ABSTRACT
BACKGROUND: Luteolin is a flavonoid compound that has been widely studied for its various anti-cancer properties and sensitization to multidrug-resistant cells. However, the limited solubility and bioavailability of Lut hindered its potential clinical use. Theoretically, the combination of this compound with vitamin E TPGS and poloxamer 407 can produce a synergistic effect to enhance tumor apoptosis and P-glycoprotein inhibition. This study aimed to develop and optimize vitamin E TPGS/Poloxamer 407 micelles loaded with luteolin through investigating certain factors that can affect the encapsulation efficiency and particle size of the micelle. METHODS: A micelle was prepared using the film hydration method, and the micellar solution was lyophilized. The cake formed was analyzed. The factors investigated include the concentrations of the surfactants, ratio of vitamin E TPGS/Poloxamer 407, temperature of the hydrating solution, duration of hydration, and freezing temperature before lyophilization. The effects of these factors on the encapsulation efficiency and particle size of the micelle were also studied. The encapsulation efficiency was measured using a UV-Vis spectrophotometer, while particle size was measured using dynamic light scattering. RESULTS: The optimized micelle was found to have 90% encapsulation efficiency with a particle size of less than 40 nm, which was achieved using a 10% concentration of surfactants at a vitamin E TPGS/Poloxamer 407 ratio of 3:1. The optimized temperature for hydrating the micellar film was 40 °C, the optimized mixing time was 1 h, and the optimized freezing temperature was -80 °C. The solubility of the luteolin-loaded micelles increased 459-fold compared to pure Lut in water. The critical micelle concentration of the vitamin E TPGS/Poloxamer 407 micelle was 0.001 mg/mL, and the release study showed that luteolin-loaded micelles exhibited sustained release behavior. The release of luteolin from a micelle was found to be higher in pH 6.8 compared to pH 7.4, which signified that luteolin could be accumulated more in a tumor microenvironment compared to blood. CONCLUSION: This study demonstrated that several factors need to be considered when developing such nanoparticles in order to obtain a well-optimized micelle.
ABSTRACT
Cancer is a second leading disease-causing death worldwide that will continuously grow as much as 70% in the next 20 years. Chemotherapy is still becoming a choice for cancer treatment despite its severity of side effects and low success rate due to ineffective delivery of the chemodrugs. Since it was introduced in 1960, significant progress has been achieved in the use of liposomes in drug delivery. The study aims to review relevant literatures on role of PEGylated liposome in enhancing cytotoxic activity of several agents. A systematic literature on the use of PEGylated liposomes in anticancer research via Scopus, Google scholar and PubMed databases was conducted for studies published from 2000 to 2022. A total of 15 articles were selected and reviewed from 312 articles identified covering a variety of anticancer treatments by using PEGylated liposomes. PEGylated liposome which is purposed to achieve steric equilibrium is one of enhanced strategies to deliver anticancer drugs. It has been shown that some improvement of delivery and protection form a harsh gastric environment of several anticancer drugs when they are formulated in a PEGylated liposome. One of the successful drugs that has been clinically used is Doxil®, followed by some other drugs in the pipeline Various drugs (compounds) had been used to enhance the efficacy of PEGylated liposomes for targeted cancer cells in vitro and in vivo. In conclusion, PEGylated liposomes enhance drug activities and have great potential to become efficient anticancer delivery to follow Doxil® in the clinical setting.
ABSTRACT
This study aimed to formulate semisolid niosomal encapsulated lidocaine and prilocaine using the patented palm oil base Hamin-C® for further characterization and in vivo pain assessment. Seven formulations were initially studied with various chemical compositions. A thin-layer film hydration method was used to produce niosome using a mixture of surfactant (Span® 40 or Span® 60) and cholesterol (CHOL) at a 1:1 ratio, with/without a charge-inducing agent (diacetyl phosphate) (DCP) and with/without labrasol®. Niosome F1 formulation had been identified as the highest %EE achieved, at 53.74 and 55.63% for prilocaine and lidocaine, respectively. Furthermore, NIO-HAMIN F1 emulgel indicated the best formulation with higher permeability of prilocaine and lidocaine compared to the rest of the formulations. The reformulation of optimization of NIO-HAMIN F1 emulgel using a cold process to NIO-HAMIN F1-C emulgel to improve the viscosity resulted in higher diffusion of prilocaine and lidocaine by 5.71 and 33.38%, respectively. In vivo pain perception studies by verbal rating score (VRS) and visual analogue score (VAS) on healthy subjects show a comparable local anesthetic effect between NIO-HAMIN F1-C emulgel and EMLA® cream.
ABSTRACT
An excipient intended for direct compression in pharmaceutical tableting must show important features of flowability and compactibility. This study investigated pregelatinised sago starch as an excipient for direct compression tablets. Pregelatinised sago starch was prepared and characterised. Its powder bulk properties and performance in the tablet formulations with paracetamol as a model drug were compared against two commercial, directly compressible excipients, namely Avicel® PH 101 and Spress® B820. The results showed that pregelatinisation did not affect the chemical structure of sago starch, but its degree of crystallinity reduced, and X-ray diffraction pattern changed from C-type to A-type. Powder bulk properties of pregelatinised sago starch and Spress® B820 were comparable, exhibiting better flowability but lower compactibility than Avicel® PH 101. In the formulation of paracetamol tablets, pregelatinised sago starch and Spress® B820 performed equally well, followed by Avicel® PH 101 as indicated in Formulations 3, 2 and 1, respectively.
ABSTRACT
Diabetes mellitus is a prevalent metabolic syndrome that is associated with high blood glucose levels. The number of diabetic patients is increasing every year and the total number of cases is expected to reach more than 600 million worldwide by 2045. Modern antidiabetic drugs alleviate hyperglycaemia and complications that are caused by high blood glucose levels. However, due to the side effects of these drugs, plant extracts and bioactive compounds with antidiabetic properties have been gaining attention as alternative treatments for diabetes. Natural products are biocompatible, cheaper and expected to cause fewer side effects than the current antidiabetic drugs. In this review, various nanocarrier systems are discussed, such as liposomes, niosomes, polymeric nanoparticles, nanoemulsions, solid lipid nanoparticles and metallic nanoparticles. These systems have been applied to overcome the limitations of the current drugs and simultaneously improve the efficacy of plant-based antidiabetic drugs. The main challenges in the formulation of plant-based nanocarriers are the loading capacity of the plant extracts and the stability of the carriers. A brief review of lipid nanocarriers and the amphipathic properties of phospholipids and liposomes that encapsulate hydrophilic, hydrophobic and amphiphilic drugs is also described. A special emphasis is placed on metallic nanoparticles, with their advantages and associated complications being reported to highlight their effectiveness for treating hyperglycaemia. The present review could be an interesting paper for researchers who are working in the field of using plant extract-loaded nanoparticles as antidiabetic therapies.
ABSTRACT
The detection of counterfeit pharmaceuticals is always a major challenge, but the early detection of counterfeit medicine in a country will reduce the fatal risk among consumers. Technically, fast laboratory testing is vital to develop an effective surveillance and monitoring system of counterfeit medicines. This study proposed the combination of Attenuated Total Reflectance Fourier Transform Infrared (ATR-FTIR) and Differential Scanning Calorimetry (DSC) for the quick detection of counterfeit medicines, through the polymer analysis of blister packaging materials. A sample set containing three sets of original and counterfeit medicine was analyzed using ATR-FTIR and DSC, while the spectra from ATR-FTIR were employed as a fingerprint for the polymer characterization. Intending to analyze the polymeric material of each sample, DSC was set at a heating rate of 10 °C min-l and within a temperature range of 0- 400 °C, with nitrogen as a purge gas at a flow rate of 20 ml min-an. The ATR-FTIR spectra revealed the chemical characteristics of the plastic packaging of fake and original medicines. Further analysis of the counterfeit medicine's packaging with DSC exhibited a distinct difference from the original due to the composition of polymers in the packaging material used. Overall, this study confirmed that the rapid analysis of polymeric materials through ATR-FTIR and comparing DSC thermograms of the plastic in their packaging effectively distinguished counterfeit drug products.
ABSTRACT
A simple, rapid, and sensitive method of liquid chromatography-tandem mass spectrometry (LC/MS/MS) method was developed and validated for the determination of vardenafil in rabbit plasma. A simple protein precipitation method with ice-cold acetonitrile was used for plasma extraction. The mass transitions m/z 489â¶151 and m/z 390â¶169 were used to measure vardenafil and tadalafil (internal standard), respectively, with a total assay run time of 6 min. The limit of detection was 0.2 ng/mL. The assay was reproducible with intra-assay and interassay precision ranging 1.17%-9.17% and 1.31%-5.86%, respectively. There was also good intra-assay and interassay accuracy between 89.3%-105.3% and 94%-102% of the expected value, respectively. The linearity range was 0.5-60 ng/mL in rabbit plasma (r 2 ≥ 0.99). The measured AUC from 0 to 24 h (AUC0 - 24t ) for the test and reference formulations were 174.38 ± 95.91 and 176.45 ± 76.88, respectively. For the test, C max and T max were 75.36 ± 59.53 ng/mL and 1.42 ± 0.19 h, whereas, for the reference, these were 58.22 ± 36.11 ng/mL and 2.04 ± 0.33 h, respectively. The test formulation achieved a slightly lower AUC0 - 24t value (p > 0.05), higher C max values (p > 0.05), faster T max (p < 0.05), and almost equal bioavailability compared with the reference formulation.
ABSTRACT
BACKGROUND: Chemerin is an adipokine that induces insulin resistance by the mechanism of inflammation in adipose tissue but these are still unclear. A high level of chemerin in humans is considered as a marker of inflammation in insulin resistance and obesity as well as in type 2 diabetes mellitus. Despite the role of chemerin in insulin resistance progression, chemerin as one of the novel adipokines is proposed to be involved in high cancer risk and mortality. AIM: The aim of this paper was to review the role of CMKLR-1 receptor and the potential therapeutic target in the management of chemerin induced type 2 diabetes mellitus and cancer. PATHOPHYSIOLOGY: Increased chemerin secretion activates an inflammatory response. The inflammatory response will increase the oxidative stress in adipose tissue and consequently results in an insulin-resistant state. The occurrence of inflammation, oxidative stress and insulin resistance leads to the progression of cancers. CONCLUSION: Chemerin is one of the markers that may involve in development of both cancer and insulin resistance. Chemokine like receptor- 1 (CMKLR-1) receptor that regulates chemerin levels exhibits a potential therapeutic target for insulin resistance, type 2 diabetes and cancer treatment.
