ABSTRACT
This review provides a critical, multi-faceted assessment of the practical contribution tidal stream energy can make to the UK and British Channel Islands future energy mix. Evidence is presented that broadly supports the latest national-scale practical resource estimate, of 34 TWh/year, equivalent to 11% of the UK's current annual electricity demand. The size of the practical resource depends in part on the economic competitiveness of projects. In the UK, 124 MW of prospective tidal stream capacity is currently eligible to bid for subsidy support (MeyGen 1C, 80 MW; PTEC, 30 MW; and Morlais, 14 MW). It is estimated that the installation of this 124 MW would serve to drive down the levelized cost of energy (LCoE), through learning, from its current level of around 240 £ / MWh to below 150 £ / MWh , based on a mid-range technology learning rate of 17%. Doing so would make tidal stream cost competitive with technologies such as combined cycle gas turbines, biomass and anaerobic digestion. Installing this 124 MW by 2031 would put tidal stream on a trajectory to install the estimated 11.5 GW needed to generate 34 TWh/year by 2050. The cyclic, predictable nature of tidal stream power shows potential to provide additional, whole-system cost benefits. These include reductions in balancing expenditure that are not considered in conventional LCoE estimates. The practical resource is also dependent on environmental constraints. To date, no collisions between animals and turbines have been detected, and only small changes in habitat have been measured. The impacts of large arrays on stratification and predator-prey interaction are projected to be an order of magnitude less than those from climate change, highlighting opportunities for risk retirement. Ongoing field measurements will be important as arrays scale up, given the uncertainty in some environmental and ecological impact models. Based on the findings presented in this review, we recommend that an updated national-scale practical resource study is undertaken that implements high-fidelity, site-specific modelling, with improved model validation from the wide range of field measurements that are now available from the major sites. Quantifying the sensitivity of the practical resource to constraints will be important to establish opportunities for constraint retirement. Quantification of whole-system benefits is necessary to fully understand the value of tidal stream in the energy system.
ABSTRACT
This paper explores the influence of blockage and free-surface deformation on the hydrodynamic performance of a generic marine cross-flow turbine. Flows through a three-bladed turbine with solidity 0.125 are simulated at field-test blade Reynolds numbers, O(10(5)-10(6)), for three different cross-stream blockages: 12.5, 25 and 50 per cent. Two representations of the free-surface boundary are considered: rigid lid and deformable free surface. Increasing the blockage is observed to lead to substantial increases in the power coefficient; the highest power coefficient computed is 1.23. Only small differences are observed between the two free-surface representations, with the deforming free-surface turbine out-performing the rigid lid turbine by 6.7 per cent in power at the highest blockage considered. This difference is attributed to the increase in effective blockage owing to the deformation of the free surface. Hydrodynamic efficiency, the ratio of useful power generated to overall power removed from the flow, is found to increase with blockage, which is consistent with the presence of a higher flow velocity through the core of the turbine at higher blockage ratios. Froude number is found to have little effect on thrust and power coefficients, but significant influence on surface elevation drop across the turbine.
