Comparison of different procedures to stabilize biogas formation after process failure in a thermophilic waste digestion system: influence of aggregate formation on process stability.

Following a process failure in a full-scale biogas reactor, different counter measures were undertaken to stabilize the process of biogas formation, including the reduction of the organic loading rate, the addition of sodium hydroxide (NaOH), and the introduction of calcium oxide (CaO). Corresponding to the results of the process recovery in the full-scale digester, laboratory experiments showed that CaO was more capable of stabilizing the process than NaOH. While both additives were able to raise the pH to a neutral milieu (pH>7.0), the formation of aggregates was observed particularly when CaO was used as the additive. Scanning electron microscopy investigations revealed calcium phosphate compounds in the core of the aggregates. Phosphate seemed to be released by phosphorus-accumulating organisms, when volatile fatty acids accumulated. The calcium, which was charged by the CaO addition, formed insoluble salts with long chain fatty acids, and caused the precipitation of calcium phosphate compounds. These aggregates were surrounded by a white layer of carbon rich organic matter, probably consisting of volatile fatty acids. Thus, during the process recovery with CaO, the decrease in the amount of accumulated acids in the liquid phase was likely enabled by (1) the formation of insoluble calcium salts with long chain fatty acids, (2) the adsorption of volatile fatty acids by the precipitates, (3) the acid uptake by phosphorus-accumulating organisms and (4) the degradation of volatile fatty acids in the aggregates. Furthermore, this mechanism enabled a stable process performance after re-activation of biogas production. In contrast, during the counter measure with NaOH aggregate formation was only minor resulting in a rapid process failure subsequent the increase of the organic loading rate.

Possibilities and limitations of life cycle assessment (LCA) in the development of waste utilization systems - Applied examples for a region in Northern Germany.

Against the background of increasing concerns about climate change, the reduction of greenhouse gas emissions has become an integral part of processes in both the waste management and the energy industries. This is reflected in the development of new waste treatment concepts, in which domestic and commercial waste is treated with the aim of utilizing its energy content, while at the same time recycling as much of its material content as possible. Life cycle assessment (LCA) represents a method of assessing the environmental relevance of a waste management system, the basis of which is a material flow analysis of the system in question. GHG emissions from different options for thermal treatment and energy recovery from waste as applied to a region in Northern Germany have been analyzed by the LCA approach and an indicative LCA, which only considers those emissions resulting from operating stages of the system. Operating stages have the main share of emissions compared to pre-processing stages. Results show that through specific separation of waste material flows and highly efficient energy recovery, thermal treatment and energy generation from waste can be optimized resulting in reduction of emissions of greenhouse gases. There are also other areas of waste utilization, currently given little attention, such as the solar drying of sewage sludge, which can considerably contribute to the reduction of greenhouse gas emissions.