ABSTRACT
The demand for polymer composite solutions in bipolar plates for polymer electrolyte membrane fuel cells (PEMFCs) has risen due to advantages over metal plates such as longer lifetime, weight reduction, corrosion resistance, flexible manufacturing, freedom of design, and cost-effectiveness. The challenge with polymer composites is achieving both sufficient electrical conductivity and mechanical stability with high filler content. A carbon fiber fleece as reinforcement in a graphite-filled polypropylene (PP) matrix was investigated for use as bipolar plate material with increased mechanical and sufficient conductive properties. Plates with a thickness of 1 mm containing four layers of fleece impregnated in the PP-graphite compound were produced in a compression molding process. Particle and fiber interactions were investigated via microscopy. The plates were characterized with respect to the electrical conductivity and mechanical stability. High electric conductivity was reached for fiber-reinforced and plain PP-graphite compound plates, with increased filler content leading to a higher conductivity. The contact resistance remained largely unaffected by surface etching as no polymeric skin layer formed during compression molding. Fiber-reinforced plates exhibit twice the tensile strength, a significantly higher tensile modulus, and an increased elongation at break, compared to PP filled only with graphite.
ABSTRACT
Due to the lack of raw material and forced by political demand, an increasing percentage of postconsumer materials (PCR) shall be used in all processing methods in polymer technology. Thermoforming, as one of the oldest polymer-processing methods, has special requirements regarding the melt stability at high temperatures. Low melt stability affects the thermoforming in a negative manner, as the low stiffness leads the sheet to sag during the heating phase. In this study, two-layer sheets are used in order to improve melt stability of PCR material. The focus is placed on the influence of rheological properties on the biaxial stretching behavior of mono- and two-layer sheets in partially molted state. In order to create a stabilizing layer, two different thermoformable virgin materials with a melt flow rate (MFR) of 3 g/10 min and 6 g/10 min were chosen. The second layer consists of instable PCR materials with a MFR of 16 g/10min and 50 g/10 min. Rheological investigations, molecular characterization and biaxial stretching tests are used to show the benefit of two-layer sheets for processing PCR material under elongational stress. The results show that the use of two-layer sheets can improve the biaxial stretching properties, so that two-layer sheets can offer a significant potential in the processing of PCR materials in thermoforming.
ABSTRACT
An increasing percentage of post-consumer materials (PCR) is becoming more and more important in all processing methods in polymer technology, also due to the lack of raw materials and political demands. Very special requirements are placed on material properties such as viscosities in extrusion. Low viscosities and the presence of particles affect extrusion in a negative manner. In this study, the use of multilayer sheets is determined to both ensure extrudability and contribute to a significant improvement in surface qualities. The focus is placed on the influence of viscosity and particles on mono- und multilayer sheet quality. Therefore, two different virgin materials with a melt flow rate (MFR) of 3 g/10 min and 6 g/10 min and two different PCR materials with a MFR of 16 g/10 min and 50 g/10 min are processed both in monolayers and in two layer sheets. Rheological investigations, optical analysis, and film thickness distributions are used to show the relationship between matrix viscosity and particles. The results show that the use of multilayer extrusion can improve both extrudability and sheet quality, so that multilayer sheets can offer a significant potential in the processing of PCR materials.
