ABSTRACT
In this study, extracts of Robusta-roasted coffee were obtained using various extraction techniques, including subcritical fluid extractions using HFC-134a and HCFC-22 under room-temperature batch extraction, frozen-temperature batch extraction, and continuous extraction conditions. Additionally, supercritical carbon dioxide (SCCO2) extraction was performed using ethanol and tetrahydrofuran as co-solvents. These extractions were performed due to the presence of potent antioxidants and antibacterial substances in the extracts. Extraction machines were built to process the extraction. The antioxidant potential of the extracts was evaluated using total phenolic content and DPPH and FRAP assays, while antibacterial potential was identified using the disk diffusion method. The results showed that HCFC-22 extraction produced the highest yield compared to other extraction methods, but HFC-134a extraction had the highest antioxidant potential values. The yield and antioxidant potential of the extracts obtained using room-temperature batch extraction were slightly higher than those obtained using frozen-temperature batch extraction and continuous extraction. The yield and antioxidant potential of the extracts obtained using SCCO2 extraction were similar to those obtained using HFC-134a and HCFC-22 extractions, and co-solvents slightly improved the extraction performance. The extracts were found to be more effective as inhibitors of Gram-positive bacteria than Gram-negative bacteria. Caffeine was the most prominent tentative chemical compound in all coffee extracts. This research study provides a better understanding of various extraction techniques using HFC-134a, HCFC-22, and SCCO2 when applied to roasted Robusta coffee beans, with a focus on yield, antioxidant potential, antimicrobial potential, and tentative chemical profiles.
ABSTRACT
Essential oil from Jasminum sambac flowers has demonstrated the potential of antioxidant and antimicrobial properties. However, jasmine flowers contain only a small amount of essential oil; therefore, subcritical fluid extraction (SFE) with HFC-134a, one of the effective extraction methods for flower extraction, was performed in this study. The percentage of overfilled solvent and storage time of the flowers were varied during the extraction. Antioxidant potential, antimicrobial potential and tentative volatile compounds were investigated in this study to observe the quality of the essential oil. It was discovered that a greater amount of overfilled solvent resulted in thicker essential oil and a longer storage time resulted in a lower amount of total oil yield. It could be seen that almost all extraction conditions did not have any significant difference in antioxidant and antimicrobial potential. The essential oil contained primary compounds such as indole, 9-tricosene, α-farnesene, muurolene, and benzyl alcohol. This study led to the conclusion that the amount of overfilled solvent from SFE affected the thickness of jasmine essential oil and its tentative volatile compounds. The longer storage time caused the significantly lower essential oil yield, but changing the extraction conditions had no significant effect on antioxidant or antimicrobial potential.
ABSTRACT
The Knudsen pump, known as a thermal transpiration membrane, is an air inducer that has been mostly studied for small-scale power generation devices. It is a porous medium that does not require any mechanically moving component, but rather uses the temperature gradient across two surfaces of the membrane to induce air from the colder side to the hotter side. If the temperature on the colder side of the membrane is reduced by a thermal guard, the pumping performance of the membrane seems to be improved. Therefore, the membrane integrating with TPMS structures as thermal guards for both experiment and simulation were conducted in this study. The results of flow rate and temperature distribution on the membrane surface were compared. Three characteristic parameters of the membrane, i.e., area factor, pore radius and permeability, were found and can be used in an equation to estimate the air flow rate through the membrane. Diamond was found to be the highest flow improvement while Primitive was the lowest flow improvement. The simulation results with varying %RD also supported that the contact area between the TPMS structure and the membrane inlet surface made Diamond conduct more heat out from the membrane surface than other TPMS structures.
