Effect of high-pressure homogenization preparation on mean globule size and large-diameter tail of oil-in-water injectable emulsions.

The effect of different high pressure homogenization energy input parameters on mean diameter droplet size (MDS) and droplets with > 5 µm of lipid injectable emulsions were evaluated. All emulsions were prepared at different water bath temperatures or at different rotation speeds and rotor-stator system times, and using different homogenization pressures and numbers of high-pressure system recirculations. The MDS and polydispersity index (PI) value of the emulsions were determined using the dynamic light scattering (DLS) method, and large-diameter tail assessments were performed using the light-obscuration/single particle optical sensing (LO/SPOS) method. Using 1000 bar homogenization pressure and seven recirculations, the energy input parameters related to the rotor-stator system will not have an effect on the final particle size results. When rotor-stator system energy input parameters are fixed, homogenization pressure and recirculation will affect mean particle size and large diameter droplet. Particle size will decrease with increasing homogenization pressure from 400 bar to 1300 bar when homogenization recirculation is fixed; when the homogenization pressure is fixed at 1000 bar, the particle size of both MDS and percent of fat droplets exceeding 5 µm (PFAT5) will decrease with increasing homogenization recirculations, MDS dropped to 173 nm after five cycles and maintained this level, volume-weighted PFAT5 will drop to 0.038% after three cycles, so the "plateau" of MDS will come up later than that of PFAT5, and the optimal particle size is produced when both of them remained at plateau. Excess homogenization recirculation such as nine times under the 1000 bar may lead to PFAT5 increase to 0.060% rather than a decrease; therefore, the high-pressure homogenization procedure is the key factor affecting the particle size distribution of emulsions. Varying storage conditions (4-25°C) also influenced particle size, especially the PFAT5.

[Research progress of detecting large-diameter tail in lipid injectable emulsions].

Injectable lipid emulsions have been routinely used in patients since 1960s as a nutritional supplement for patients requiring parenteral nutrition. In recent years, lipid injectable emulsions have been extensively studied as a kind of novel drug carrier, also the quality problems of the lipid emulsion attract more and more attentions gradually. Large diameter tail of injectable lipid emulsions as a significant quality control indicator should pay more attention. Regarding to the defect of detecting large diameter tail of lipid injectable emulsions in our country, the purpose of this article is to summarize the techniques of detecting large diameter tail, illustrate the impacts of large lipid droplet on the quality of lipid injectable emulsions, emphasize the importance of detecting large diameter tail in lipid emulsions and provide guidance for researching and developing lipid emulsions in domestic market.

[Preparation, formation mechanism and preliminary evaluation of oral absorption of a Bicyclol-phospholipid complex].

Bicyclol with benzyl alcohol structure, is a poorly water-soluble drug, used for the treatment of chronic hepatitis B. To increase the drug solubility and oral bioavailability, a Bicyclol-phospholipid complex was studied on its preparation, formation mechanism, and the influence on drug physicochemical properties and oral absorption. The complex was prepared by a solvent evaporation method. The optimal formulation was selected by orthogonal experimental design, and a reasonable evaluating method of the complexation rate was established. Various methods, such as differential scanning calorimetry (DSC), X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR) and 31P nuclear magnetic resonance (31P-NMR), were used to explore the phase state and formation mechanism of the complex. The solubility of drug in complex was investigated in water/n-octanol. Preliminary study of its absorption and liver tissue distribution in rats was also carried out. The results showed that Bicyclol and phosphatidylcholine can be complexed entirely in the molar ratio 1 : 2. Bicyclol was dispersed in phospholipids as amorphous state. They were combined by intermolecular hydrogen bond due to charge transfer effect which occurred between the two polarities of the double bond between phosphorus and oxygen (P=O) of phosphatidylcholine and benzalcohol group of Bicyclol. The solubility of the complex compared to the active pharmaceutical ingredient (API) was effectively enhanced 5.75 times in water and 7.72 times in n-octanol, separately. In addition, drug concentrations were also enhanced 43 times in plasma and 13 times in liver with one hour after administering the complex to rats via oral gavage. All of these indicated that Bicyclol with benzalcohol group can interact with phospholipids to form complex, improving drug's physicochemical properties, thus further increasing its absorption and target tissue distribution. This study also provided theoretical reference for the research of other benzalcohol derivatives complexed with phospholipids.

[Analysis and identification of degradation products of buagafuran by high performance liquid chromatography-diode array detection-tandem mass spectrometry].

An HPLC-DAD-MS/MS method was developed for rapid analysis and identification of degradation products of buagafuran. Buagafuran and degradation products were separated on a Zorbax C8 column (5 microm, 4.6 mm x 150 mm) using acetonitrile-water (78 : 22) as mobile phase. The elutes were detected with diode array detector and tandem mass spectrometer via electrospray ionization source in positive ion mode. According to analysis of the retention time, UV spectra and MS, MS/MS data, combined with the possible degradation reaction of buagafuran, the structures of main degradation products were inferred. The results showed that six main degradation products were oxidation or peroxidation productions of buagafuran. Degradation product A was a double bond epoxidation product of buagafuran, degradation products B, C, D and E were the further oxidation products of degradation product A, degradation product F was a peroxidation product of buagafuran. The results indicated that the established method was effective in the rapid identification of the degradation products of buagafuran.

[Comparative study on pharmacokinetics and tissue distribution of a novel microemulsion based on the paclitaxel/L-OH lipid complex and paclitaxel injection in cremophor].

The pharmacokinetics and tissue distributions of the novel paclitaxel microemulsion based on the L-OH lipid complex made in our laboratory were studied in this article with the commercial paclitaxel injection in cremophor as reference preparation by injected intravenously with single dose of 5 mg x kg(-1) in rats. LC-MS/MS method was used to determine the drug concentration in plasma and calculate the pharmacokinetic parameters. [3H]-paclitaxel was used to reveal the tissue distributions of different organs in 0.5 h, 3 h, 24 h and 120 h. The results indicated that the AUC of the emulsion group descended to 42.55%, with the CLz and Vz increased by 2.27 times and 3.81 times respectively. Tissue distribution results revealed that the emulsion showed a significantly increase in liver and spleen with a peak concentration up to 5 times; a slightly increase was observed in lung with no statistical differences; a significantly decrease in heart, kidney, gastrointestinal tract, bone marrow, aorta, thymus, pancreas, fat, muscle, skin, seminal vesicle, reproductive organs and brain with a drop of 40%-80%. These results indicated that paclitaxel microemulsion based on L-OH lipid complexes can remarkably reduced the blood exposure, accelerate plasma clearance rate and increase distribution volume. The fact that paclitaxel microemulsion tended to be uptake by reticuloendothelial system (RES) contributed to the target in liver, spleen and lung, and help to reduce the toxicity in blood, heart, kidney and gastrointestinal tract.

Formulation, characterization and hypersensitivity evaluation of an intravenous emulsion loaded with a paclitaxel-cholesterol complex.

The objective of this paper was to develop a novel Cremophor-free, autoclave stable, intravenous emulsion for paclitaxel (PACE). A paclitaxel-cholesterol complex was used as the drug carrier to improve the solubility of paclitaxel in the oil phase of emulsions. The complex and PACE were prepared by rotary evaporation and high-pressure homogenization, respectively. Effects of oil phases, emulsifiers and pH values on the characteristics of PACE were investigated. PACE was characterized with regard to its appearance, morphology, osmolality, pH value, particle size, zeta potential, encapsulation efficiency and stability. Hypersensitivity was evaluated by guinea pig hypersensitivity reaction. The final formulation was composed of the complex, soybean oil, medium-chain triglyceridel, soybean lecithin, poloxamer 188 and glycerol. The resulting PACE had an encapsulation efficiency of 97.3% with a particle size of 135 nm and a zeta potential of -38.3 mV. Osmolality and pH of the formulation were 383 mOsmol/kg and 4.5, respectively. The formulation survived autoclaving at 115 °C for 30 min and remained stable for at least 12 months at 6 °C. PACE also exhibited a better tolerance than an equal dose of Cremophor-based paclitaxel injection in guinea pigs, as no obvious hypersensitivity reaction was observed. These results suggested that PACE has a great potential for industrial-scale production and clinical applications.

[Preparation and in vitro study of buagafuran solid dispersions].

Solid dispersions technique was used to solidify buagafuran and improve buagafuran in vitro dissolution and stability. Buagafuran solid dispersions were prepared separately using PVPK30, PEG6000 and Poloxamer188 at various weight ratios as carriers. The status of buagafuran in solid dispersions was determined by using DSC and IR. The solubility, content and in vitro dissolution of pure drug and the solid dispersions were detected by using HPLC. When buagafuran/carrier was 1:5 or less, the drug existed in a solid dispersion form. Three kinds of carriers all can improve buagafuran dispersibility and in vitro dissolution. Accelerating experiment showed that buagafuran/PVPK30 < or = 1:10 solid dispersions was ageing-resistant, and the aspect, content and in vitro dissolution did not change after storaged over 3 months, but PEG6000, Poloxamer188 and a lower ratio PVPK30 solid dispersions became aged. Buagafuran/PVPK30 < or = 1:10 solid dispersions can be developed as buagafuran oral drug delivery carrier.