Optical Tweezers-Based Measurements of Colloidal Forces between Asphaltene Thin Films: Effect of Ultrasonication.

Oil production and processing often involve the treatment of water-in-oil emulsions stabilized by asphaltenes. The asphaltenes adsorb irreversibly at the water-oil interface and, by self-association at the interface, form a viscoelastic film that stabilizes the emulsions mechanically and sterically. Hydrophobic forces associated with these films may also contribute to the emulsion stability. A key step in treating these emulsions is to weaken the asphaltene film at the interface, and one way to do so is with ultrasonic treatment. The effect of ultrasonic waves on the interactions between asphaltene films was investigated at a silica-water interface using optical tweezers. Silica microparticles were aged in asphaltene solutions to form asphaltene coatings on their surfaces. The particles were dispersed in water, and interparticle force measurements were performed with optical tweezers to capture the steric force and hydrophobic force contributions. The asphaltene coating thickness and hydrophobic coefficient (a factor resembling the strength of the hydrophobic interaction) were obtained from fitting these forces. The effect of ultrasonication on the thickness of the asphaltene films on the surfaces of the particles was investigated. No change in the hydrophobic coefficient was observed upon changing the interfacial asphaltene concentration. The asphaltene film thickness increased with the concentration of the asphaltene solution and aging time. After treatment of the dispersion with ultrasonic waves for different durations (between 5 and 40 min), a significant reduction in the coating thickness was observed. This reduction was confirmed by thermogravimetric analysis (TGA) measurements. It is hypothesized that cavitation at the interface removed part of the surface layer of asphaltenes from the coated particles. Based on these findings, we proved that a low-power ultrasound field can effectively break asphaltene-stabilized water-in-oil emulsions.

Haemophagocytic lymphohistiocytosis in a patient with severe burns.

Recently, increasing attention has been drawn to haemophagocytic lymphohistiocytosis as a potentially under-diagnosed condition in critically ill patients with severe sepsis. It is thought to be caused by a highly stimulated, but ineffective, immune system. We report the case of a patient suffering from major burns who, despite extensive investigations showing the absence of concurrent sepsis or infection, developed haemophagocytic lymphohistiocytosis refractory to treatment. We believe that this is the first report suggestive of haemophagocytic lymphohistiocytosis triggered by a burns injury.

Effect of surfactants on interfacial films and stability of water-in-oil emulsions stabilized by asphaltenes.

The effect of additives on asphaltene interfacial films and emulsion stability was analyzed through the change in film properties. Surface pressure isotherms were measured at 23°C for model interfaces between aqueous surfactant solutions and asphaltenes dissolved in toluene and heptane-toluene mixtures. Compressibility, crumpling film ratio and surface pressure were determined from the surface pressure isotherms. The stability of water-in-oil emulsions was determined for the same systems based on the proportion of unresolved emulsified water after repeated treatment involving heating at 60°C and centrifugation. Experimental variables included concentration of asphaltenes (5 and 10 kg/m(3)), concentration and type of surfactant (Aerosol OT, nonylphenol ethoxylates, polypropylene oxide block-copolymer, dodecylbenzene sulfonic acids, dodecylbenzene sulfonic acid-polymer blend, diisopropyl naphthalene sulfonic acid, and sodium naphthenate) and aging time (from 10 min to 4 h). Additives were found to have two opposing effects on film properties and emulsion stability: (1) decreasing or eliminating the crumpling ratio which destabilized emulsions and (2) decreasing interfacial tension which enhanced emulsion stability. A stability parameter was defined to include both the crumpling ratio and interfacial tension and provided a consistent correlation for the percent residual emulsified water.

Effect of interfacial rheology on model emulsion coalescence II. Emulsion coalescence.

In Part I, surface pressure isotherms were measured for model interfaces between a dispersed water phase and a continuous phase of asphaltenes, toluene, and heptane. Here, the coalescence rate of model emulsions prepared from the same components is determined from measured drop size distributions at 23 degrees C. A correlation is found between the initial coalescence rate and the interfacial compressibility. It is shown that the change in coalescence rate as the emulsion ages and coalesces can be predicted from surface pressure isotherm data also obtained at 23 degrees C. The stability of the emulsions was further assessed in terms of free water resolved after a treatment of heating at 60 degrees C and centrifugation. The emulsions were aged up to 24 h prior to treatment. The free water resolution appears to correlate to the "capacity for coalescence" of the interfacial film; that is, to the product of the initial film compressibility and (1-CR), where CR is the film ratio at which the film crumples.

Effect of interfacial rheology on model emulsion coalescence I. Interfacial rheology.

Interfacial elasticity and "dynamic" surface pressure isotherms were measured for interfaces between a dispersed water phase and a continuous phase of asphaltenes, toluene, and heptane. The interfacial modulus is a function of asphaltene concentration and in all cases reached a maximum at an asphaltene concentration of approximately 1 kg/m(3). The modulus increased significantly as the interface aged and slightly as the heptane content increased to a practical limit of 50 vol%. The modulus was approximately the same at 23 and 60 degrees C. The modulus correlated with the inverse of the initial compressibility determined from surface pressure isotherms. The surface pressure isotherms also indicated that a phase transition occurred as the interface was compressed leading to the formation of low compressibility films. Crumpling was observed upon further compression. The phase transition shifted to a higher film ratio with an increase in heptane content and interface age. Asphaltene concentration and temperature (23 and 60 degrees C) has little effect on the surface pressure isotherms. The surface pressure and elasticity measurements are consistent with the gradual formation of a cross-linked asphaltene network on the interface.

Comparison of von Willebrand factor antigen, von Willebrand factor-cleaving protease and protein S in blood components used for treatment of thrombotic thrombocytopenic purpura.

Replacement of normal levels of von Willebrand factor-cleaving protease (VWF:CP, ADAMTS13) activity from infused plasma is important in plasma exchange (PEX) for the treatment of thrombotic thrombocytopenic purpura (TTP) patients. We have studied the VWF:CP activity, VWF multimer distribution, VWF:Ag, protein S (PS) activity and free PS antigen levels in fresh frozen plasma (FFP), cryosupernatant (CSP) and virally inactivated components treated with methylene blue/light (MB) or solvent detergent (SD) processes. VWF:CP activity was normal in all components tested and was retained following overnight storage at room temperature. CSP and SD plasma contained reduced levels of the highest molecular weight VWF multimers. Protein S activity was reduced below the normal range in SD plasma, but within the normal range for the other components tested. Virally inactivated SD- and MB-treated plasma may be an effective alternative to FFP and CSP in PEX for TTP. Reduced PS activity in SD plasma may predispose to venous thromboembolism, especially if infused in large volumes.

Granulocytic sarcoma preceding AML M0 and the diagnostic value of CD34.

Granulocytic sarcoma with no demonstrable abnormalities in the peripheral blood or bone marrow is a rare but recognised initial manifestation of acute myeloid leukaemia and has led to diagnostic difficulties in some cases. A lymph node excisional biopsy from a patient presenting with cervical lymphadenopathy, a mediastinal mass, and a normal peripheral blood picture was reported to have features suggesting a T cell non-Hodgkin lymphoma, for which she was subsequently treated. However, 10 months later the patient developed acute myeloid leukaemia, FAB classification M0. The initial lymph node biopsy was reviewed and further immunohistochemical studies using antibodies against CD34 led to a revised diagnosis of primary granulocytic sarcoma.