Synergistic interplay of ABA and BR signal in regulating plant growth and adaptation.

Complex antagonistic interactions between abscisic acid (ABA) and brassinosteroid (BR) signalling pathways have been widely documented. However, whether or how ABA interacts synergistically with BR in plants remains to be elucidated. Here, we report that low, but not high, concentration of ABA increases lamina joint inclination of rice seedling, which requires functional BR biosynthesis and signalling. Transcriptome analyses confirm that about 60% of low-concentration ABA early response genes can be regulated by BR in the same directions. ABA activates BR signal in a fast, limited and short-term manner and the BR-biosynthesis regulatory gene, OsGSR1, plays a key role during this process, whose expression is induced slightly by ABA through transcriptional factor ABI3. Moreover, the early short-term BR signal activation is also important for ABA-mediated salt stress tolerance. Intriguingly, the process and effect of short-term BR signal activation were covered by high concentration of ABA, implying adaptive mechanisms existed in plants to cope with varying degrees of stress.

Structural and electronic properties of SnO2 doped with non-metal elements.

Crystal structure and electronic properties of SnO2 doped with non-metal elements (F, S, C, B, and N) were studied using first-principles calculations. The theoretical results show that doping of non-metal elements cannot change the structure of SnO2 but result in a slight expansion of the lattice volume. The most obvious finding from the analysis is that F-doped SnO2 has the lowest defect binding energy. The doping with B and S introduced additional defect energy levels within the forbidden bandgap, which improved the crystal conductivity. The Fermi level shifts up due to the doping with B, F, and S, while the Fermi level of SnO2 doped with C or N has crossed the impurity level. The Fermi level of F-doped SnO2 is inside the conduction band, and the doped crystal possesses metallicity. The optical properties of SnO2 crystals doped with non-metal elements were analyzed and calculated. The SnO2 crystal doped with F had the highest reflectivity in the infrared region, and the reflectance of the crystals doped with N, C, S, and B decreased sequentially. Based on this theoretical calculations, F-doped SnO2 is found to be the best photoelectric material for preparing low-emissivity coatings.

Oriented thick films of block copolymer made by multiple successive coatings: perforated lamellae versus oriented lamellae.

Building 3D ordered nanostructures by copolymer deposition on a substrate implies a full control beyond the thin film regime. We have used here block copolymers (BCPs) forming bulk lamellar phases to form thick, i.e. much thicker than the lamellar period, structured films on a substrate. Films are formed by a simple method of multiple successive coatings. The film structure is controlled using the combined action of surface templating and annealing time. Sections of the thick layers were characterized by scanning electron microscopy (SEM) after etching of one of the BCP moieties. We show that perfect hexagonally perforated films (HPL) with lamellae parallel to the substrate are formed for a wide thickness range up to 300 nm. Grazing incidence small angle X-ray scattering (GISAXS) confirms such an organization by revealing that perforations sit on a hexagonal lattice. A lamellar organization perpendicular to the substrate is shown to take over for thicker films. A scenario consistent with our observations is proposed, where the sequence of phases results from the balance between surface and stretching energy effects.

Indole-3-acetic acid has long-term effects on long non-coding RNA gene methylation and growth in Populus tomentosa.

DNA methylation and long non-coding RNAs (lncRNAs) regulate plant growth and development, but their relationship and effect on responses to the auxin phytohormone indole-3-acetic acid (IAA) remain largely unknown, particularly in woody plants such as poplar (Populus tomentosa). Following treatment of 1-year-old clonal plants with 100 µM IAA, key poplar lncRNA genes showed changes in methylation, but whole-genome methylation levels showed no significant change. Moreover, 100 µM IAA inhibited growth of the 1-year-old poplar clones, possibly through the suppression of photosynthesis. This inhibition had a long-term effect, persisting at 1 month after removal of the exogenous IAA. Transcriptome analysis identified two candidate lncRNA genes that show changes in expression following IAA treatment, TCONS_00003480 and TCONS_00004832. TCONS_00003480 contains the same microRNA target sites of ptc-miR6464 as the 4-coumarate: CoA ligase 2 transcript, which encodes a lignin biosynthesis enzyme. And TCONS_00004832 shares the same target sites of ptc-miR6437a with the Photosystem II reaction center protein D and Cytochrome C Oxidase 17 transcripts, which are related to photosynthesis. The two lncRNAs as the mimics to corresponding target genes of miRNAs to prevent them from degrading. Examination of lncRNA gene expression and methylation revealed a negative relationship (r = - 0.29, P < 0.05); moreover, hypermethylation of the two candidate lncRNA genes remained 1 month after IAA treatment, suggesting that changes in methylation might be involved in the long-term effects of plant hormones. Therefore, our study reveals a long-term effect of IAA on the growth of P. tomentosa, possibly via methylation-mediated epigenetic changes in lncRNA gene expression and the interaction with corresponding miRNAs, leading to regulation of genes related to photosynthesis and growth.

Design and synthesis of trithiophene-bound excited-state intramolecular proton transfer dye: enhancement on the performance of bulk heterojunction solar cells.

In an aim to harvest UV-near-visible (360-440 nm) photons as well as to increase the morphology in the bulk heterojunction solar cells, we report herein the strategic design, synthesis, and characterization of a novel excited-state intramolecular proton-transfer dye, 3-hydroxy-2-(5-(5-(5-(3-hydroxy-4-oxo-4H-chromen-2-yl)thiophen-2-yl)thiophen-2-yl)thiophen-2-yl)-4H-chromen-4-one (FT), which bears two key functional groups, namely 3-hydroxychromone chromophore and trithiophene backbone and is then exploited into the blends of regioregular poly(3-hexylthiophene) (RR-P3HT) and phenyl-C(61)-butyric acid methyl ester (PCBM). FT acts as an excellent UV-near visible absorber, which then undergoes excited-state intramolecular proton transfer, giving rise to an orange-red proton-transfer emission that was reabsorbed by P3HT via a Forster type of energy transfer. Introduction of FT to P3HT/PCBM blend films also improves the morphology of phase separated structure, in particular, enhances the interaction of P3HT chains and the hole mobility. In this work, under the optimized condition of P3HT: PCBM:FT of 15:9:2 in weight ratio, the best performance of the device B-FT2 revealed consistent enhancements in the efficiency (eta) 4.28% and short-circuit current (J(sc)) 12.53 mAcm(-2), which are higher than that (3.68% and 10.28 mAcm(-2)) of the best performance of the control device B (P3HT:PCBM 15:9 in weight ratio) by 16 and 22%, respectively.

On the size evolution of gold-monolayer-protected clusters by ligand place-exchange reactions: the effect of headgroup-gold interactions.

To functionalize Au MPCs (monolayer-protected gold clusters), ligand place-exchange reactions provide a convenient route in which the initial capping ligands are displaced by mixing the MPCs with an excess amount of incoming ones. However, literature reports show that the diameters of the modified products do not always stay unchanged. Because of the diversity of experimental conditions carried out in the documented studies, there is still a lack of comprehensive understanding concerning the size evolution. Herein, carefully controlled and examined parameters include the initial size of MPCs [Au(101)(PPh(3))(21)Cl(5)], the reaction time, the concentration of incoming ligands, a homologous series of incoming ligands, and the anchoring headgroups. The results show that the final particle size is determined by the strength of headgroup-gold adsorption which is correlated with the curvature of the final product in a thermodynamic model derived from Gibbs-Thomson equation.

[Detection of single-walled carbon nanotube bundles by tip-enhanced Raman spectroscopy].

Raman spectroscopy is a powerful technique in the characterization of carbon nanotubes (CNTs). However, this spectral method is subject to two obstacles. One is spatial resolution, namely the diffraction limits of light, and the other is its inherent small Raman cross section and weak signal. To resolve these problems, a new approach has been developed, denoted tip-enhanced Raman spectroscopy (TERS). TERS has been demonstrated to be a powerful spectroscopic and microscopic technique to characterize nanomaterial or nanostructures. Excited by a focused laser beam, an enhanced electric field is generated in the vicinity of a metallic tip because of the surface plasmon polariton (SPP) and lightening rod effect. Consequently, Raman signal from the sample area illuminated by the enhanced field nearby the tip is enhanced. At the same time, the topography is obtained in the nanometer scale. The exact corresponding relationship between the localized Raman and the topography makes the Raman identification at the nanometer scale to be feasible. In the present paper, based on an inverted microscope and a metallic AFM tip, a tip-enhanced Raman system was set up. The radius of the Au-coated metallic tip is about 30 nm. The 532 nm laser passes through a high numerical objective (NA0.95) from the bottom to illuminate the tip to excite the enhanced electric field. Corresponding with the AFM image, the tip-enhanced near-field Raman of a 100 nm diameter single-walled carbon nanotube (SWNT) bundles was obtained. The SWNTs were prepared by arc method. Furthermore, the near-field Raman of about 3 SWNTs of the bundles was received with the spatial resolution beyond the diffraction limit. Compared with the far-field Raman, the enhancement factor of the tip-enhanced Raman is more than 230. With the super-diffraction spatial resolution and the tip-enhanced Raman ability, tip-enhanced Raman spectroscopy will play an important role in the nano-material and nano-structure characterization.

Coherently aligned porphyrin-appended polynorbornenes.

Six different kinds of coherently aligned porphyrin-appended polynorbornenes derived from 5,6-endo-fused N-arylpyrrolidenonorbornenes have been synthesized. Pi-pi interactions between the pendant groups are essential for dictating the photophysical properties of the polymers and the mechanism for the stereoselective formation of polymers. Splitting of the Soret band of polymers 2a-c, which have alkyl-substituted porphyrin pendant groups, suggests strong exciton coupling between chromophores. No splitting of the Soret band is observed for polymers 2d-f, which have tetraaryl substituents on the porphyrin moiety. Significant fluorescence quenching is found in polymers 2a-e, whereas only slightly reduced quantum yield is observed for 2f. Time-resolved fluorescence measurements also indicate a similar trend. The AFM image of 2d on graphite shows aggregation to form a two-dimensional, ordered pattern.

[Application of near-field Raman spectroscopy to nano-structure characterization].

Near-field Raman spectroscopy is a novel technology in the near-field optics, and attracts much attention of scientists because of the realization of spectral characterization of nano-structure. The technical advantage of Raman spectroscopy is described in the present review. The principle and practical technical scheme of near-field Raman spectroscopy systems are introduced. Several applications of near-field Raman spectroscopy are mentioned in detail, including carbon nanotube characterization, biological specimen imaging, thermoelectric crystal characterization, dye single molecule detection etc., revealing a broad prospect of the development of near-field Raman spectroscopy in various scientific research fields.

[Investigation of phase morphology of PS/PMMA blend thin film by surface enhanced raman scattering].

Polystyrene/poly (methyl methacrylate) (PS/PMMA) was studied after the thin films were prepared on glass substrate by spin-coating from THF. Raman spectroscopy combined with microscopy was used to obtain information on the morphology and structure of the thin films. From the relative intensities of the peaks around 1 604 and 1 585 cm(-1) due to stretching of benzene rings, and 1 728 cm(-1) due to stretching of C=O for PS and PMMA respectively, the authors could define the composition of the domains in the sea-island-like phase-separated structure in the microscopic image. Furthermore, the structure evolution was followed by Raman spectroscopy during the in-situ annealing of PS/PMMA (30/70) blend thin films at 210 degrees C. And the effect of SERS on the PS thin films was also discussed.

Separation and identification of the phthalic anhydride derivatives of Liqusticum Chuanxiong Hort by GC-MS, TLC, HPLC-DAD, and HPLC-MS.

A simple, sensitive, and rapid method using gas chromatography (GC)-mass spectrometry (MS) is developed for the simultaneous separation and identification of the active ingredients of Liqusticum Chuanxiong Hort (Chuanxiong). Ten phthalic anhydride derivatives (PADs) are identified in Chuanxiong as 3-butylphthalide, 3-butylidenephthalide, 3-butylidene-4-hydroxyphthalide, senkyunolide A, neocnidilide, Z-ligustilide, E-ligustilide, senkyunolide F, senkyunolide-H, and senkyunolide-I. The existence of ferulic acid and vanillin in Chuanxiong extract is also demonstrated. Further identification of these compounds is performed by thin-layer chromatography, high-performance liquid chromatography (HPLC), and HPLC-MS analysis. This is the first report of the separation and determination of the PADs in Chuanxiong by GC-MS.