Modification of alkanethiolate monolayers by O(3P) atomic oxygen: effect of chain length and surface temperature.

We have conducted a comprehensive study of ground-state O((3)P) atomic oxygen reactions with 1-hexadecanethiolate (CH3(CH2)15SH) and 1-undecanethiolate (CH3(CH2)10SH) self-assembled monolayers adsorbed onto Au/mica substrates, using X-ray photoelectron spectroscopy, infrared reflection absorption spectroscopy, ellipsometry, and contact angle measurements. In general, the reactions are not limited to the terminal methyl groups. Apparently, the incident O((3)P) (translational energy per atom of 0.11 kJ mol(-1)) can penetrate below the surface of the monolayer. The ability of the atoms to penetrate, and thus the reaction rate of the backbone -CH2-, is dependent upon both the temperature and the chain length, with the longer chain having a large difference between the rate at room temperature and 150 K. In particular, the long-chain SAM exhibits clearly reduced reactivity with respect to the incident beam of atomic oxygen when the film is cooled to 150 K as compared to room temperature. This is a notable finding and demonstrates the crucial importance that structural order and dynamical fluctuations, both of which depend on chain length and substrate temperature, have in determining the surface passivation and protection characteristics of SAM overlayers with respect to attack by energetic reagents.

Dynamics of the sputtering of water from ice films by collisions with energetic xenon atoms.

The flow of energy from the impact site of a heavy, translationally energetic xenon atom on an ice surface leads to several non-equilibrium events. The central focus of this paper is on the collision-induced desorption (sputtering) of water molecules into the gas-phase from the ice surface. Sputtering is strongly activated with respect to xenon translational energy, and a threshold for desorption was observed. To best understand these results, we discuss our findings in the context of other sputtering studies of molecular solids. The sputtering yield is quite small; differential measurements of the energy of xenon scattered from ice surfaces show that the ice efficiently accommodates the collisional energy. These results are important as they quantitatively elucidate the dynamics of such sputtering events, with implications for energetic non-equilibrium processes at interfaces.

On the chemical processing of hydrocarbon surfaces by fast oxygen ions.

Solid methane (CH(4)), ethane (C(2)H(6)), and ethylene (C(2)H(4)) ices (thickness: 120 ± 40 nm; 10 K), as well as high-density polyethylene (HDPE: [C(2)H(4)](n)) films (thickness: 130 ± 20 nm; 10, 100, and 300 K), were irradiated with mono-energetic oxygen ions (Φ ~ 6 × 10(15) cm(-2)) of a kinetic energy of 5 keV to simulate the exposure of Solar System hydrocarbon ices and aerospace polymers to oxygen ions sourced from the solar wind and planetary magnetospheres. On-line Fourier-transform infrared spectroscopy (FTIR) was used to identify the following O(+) induced reaction pathways in the solid-state: (i) ethane formation from methane ice via recombination of methyl (CH(3)) radicals, (ii) ethane conversion back to methane via methylene (CH(2)) retro-insertion, (iii) ethane decomposing to acetylene via ethylene through successive hydrogen elimination steps, and (iv) ethylene conversion to acetylene via hydrogen elimination. No changes were observed in the irradiated PE samples via infrared spectroscopy. In addition, mass spectrometry detected small abundances of methanol (CH(3)OH) sublimed from the irradiated methane and ethane condensates during controlled heating. The detection of methanol suggests an implantation and neutralization of the oxygen ions within the surface where atomic oxygen (O) then undergoes insertion into a C-H bond of methane. Atomic hydrogen (H) recombination in forming molecular hydrogen and recombination of implanted oxygen atoms to molecular oxygen (O(2)) are also inferred to proceed at high cross-sections. A comparison of the reaction rates and product yields to those obtained from experiments involving 5 keV electrons, suggests that the chemical alteration of the hydrocarbon ice samples is driven primarily by electronic stopping interactions and to a lesser extent by nuclear interactions.

Determination of the sticking coefficient and scattering dynamics of water on ice using molecular beam techniques.

The sticking coefficient for D(2)O impinging on crystalline D(2)O ice was determined for incident translational energies between 0.3 and 0.7 eV and for H(2)O on crystalline H(2)O ice at 0.3 eV. These experiments were done using directed molecular beams, allowing for precise control of the incident angle and energy. Experiments were also performed to measure the intensity and energy of the scattered molecules as a function of scattering angle. These results show that the sticking coefficient was near unity, slightly increasing with decreasing incident energy. However, even at the lowest incident energy, some D(2)O did not stick and was scattered from the ice surface. We observe under these conditions that the sticking probability asymptotically approaches but does not reach unity for water sticking on water ice. We also present evidence that the scattered fraction is consistent with a binary collision; the molecules are scattered promptly. These results are especially relevant for condensation processes occurring under nonequilibrium conditions, such as those found in astrophysical systems.

Comparative surface dynamics of amorphous and semicrystalline polymer films.

The surface dynamics of amorphous and semicrystalline polymer films have been measured using helium atom scattering. Time-of-flight data were collected to resolve the elastic and inelastic scattering components in the diffuse scattering of neutral helium atoms from the surface of a thin poly(ethylene terephthalate) film. Debye-Waller attenuation was observed for both the amorphous and semicrystalline phases of the polymer by recording the decay of elastically scattered helium atoms with increasing surface temperature. Thermal attenuation measurements in the specular scattering geometry yielded perpendicular mean-square displacements of 2.7•10(-4) Å(2) K(-1) and 3.1•10(-4) Å(2) K(-1) for the amorphous and semicrystalline surfaces, respectively. The semicrystalline surface was consistently ∼15% softer than the amorphous across a variety of perpendicular momentum transfers. The Debye-Waller factors were also measured at off-specular angles to characterize the parallel mean-square displacements, which were found to increase by an order of magnitude over the perpendicular mean-square displacements for both surfaces. In contrast to the perpendicular motion, the semicrystalline state was ∼25% stiffer than the amorphous phase in the surface plane. These results were uniquely accessed through low-energy neutral helium atom scattering due to the highly surface-sensitive and nonperturbative nature of these interactions. The goal of tailoring the chemical and physical properties of complex advanced materials requires an improved understanding of interfacial dynamics, information that is obtainable through atomic beam scattering methods.

Interfacial chemistry of poly(methyl methacrylate) arising from exposure to vacuum-ultraviolet light and atomic oxygen.

We herein report on the chemical and physical changes that occur in thin films of poly(methyl methacrylate), PMMA, induced by exposure to high-energy vacuum ultraviolet radiation and a supersonic beam of neutral, ground electronic state O((3)P) atomic oxygen. A combination of in situ quartz crystal microbalance and in situ Fourier-transform infrared reflection-absorption spectroscopy were used to determine the photochemical reaction kinetics and mechanisms during irradiation. The surface morphological changes were measured with atomic force microscopy. The results showed there was no enhancement in the mass loss rate during simultaneous exposure of vacuum ultraviolet (VUV) radiation and atomic oxygen. Rather, the rate of mass loss was impeded when the polymer film was exposed to both reagents. This study elucidates the kinetics of photochemical and oxidative reaction for PMMA, and shows that the synergistic effect involving VUV irradiation and exposure to ground state atomic oxygen depends substantially on the relative fluxes of these reagents.