Radiation enhanced silicon self-diffusion and the silicon vacancy at high temperatures.

We report proton radiation enhanced self-diffusion (RESD) studies on Si-isotope heterostructures. Self-diffusion experiments under irradiation were performed at temperatures between 780 degrees C and 872 degrees C for various times and proton fluxes. Detailed modeling of RESD provides direct evidence that vacancies at high temperatures diffuse with a migration enthalpy of H(m)(V)=(1.8+/-0.5) eV significantly more slowly than expected from their diffusion at low temperatures, which is described by H(m)(V)<0.5 eV. We conclude that this diffusion behavior is a consequence of the microscopic configuration of the vacancy whose entropy and enthalpy of migration increase with increasing temperature.

Ge self-diffusion in epitaxial Si(1)-(x)Ge(x) layers.

Diffusion coefficients and activation energies have been determined for Ge diffusion in strain-relaxed Si(1)-(x)Ge(x) with x = 0.00, 0.10, 0.20, 0.30, 0.40, and 0.50. The activation energy drops from 4.7 eV in Si and Si(0.90)Ge(0.10) to 3.2 eV at x = 0.50. This value compares with the literature value for Ge self-diffusion in Ge, suggesting Ge-like diffusion already at x approximately equal to 0.5. The effect of strain on the diffusion was also studied showing a decrease in diffusion coefficient and an increase in activation energy upon going from compressive over relaxed to tensile strain.

A dynamic in vitro lipolysis model. II: Evaluation of the model.

A lipolysis model was characterised and evaluated by investigating the composition of the aqueous phase and the concentration of probucol and danazol in the aqueous phase. Effects of bile salt levels at 5, 10, 20, and 30 mM were investigated. Samples were taken at 0%, 50%, 75% and 95% hydrolysis of the triglycerides, and the aqueous phases were isolated by ultra-centrifugation, whereby the concentrations of bile salts, fatty acids, mono-, di-, triglycerides, and drug substances were measured. At high Ca(2+)-concentrations, bile salts were believed to precipitate with Ca(2+). The concentration of lipolytic products (fatty acids + monoglycerides) was dependent on the bile salt concentration. The ratio between lipolytic product and bile salts was 1.55+/-0.09 (S.D.). This ratio is equivalent to mixed bile salt micelles and vesicles in equilibrium. The aqueous solubility of probucol and danazol was increased in the presence of bile salts. The concentration of danazol in the aqueous phase was dependent on the solubilisation capacity of the aqueous phase. In the case of probucol, the concentration in the aqueous phase was dependent on the partition of probucol between the aqueous phase and the remaining triglyceride phase. This difference between danazol and probucol was attributed to the effect of different lipophilicity.

A dynamic in vitro lipolysis model. I. Controlling the rate of lipolysis by continuous addition of calcium.

Lipolysis by pancreatic lipase was investigated with the aim to establish an in vitro lipolysis model, which can be used to investigate the dissolution of poorly soluble lipophilic drug substances at controlled hydrolysis rates. The effects of three experimental parameters -- the concentrations of bile salts and Ca(2+) and the lipase activity -- were investigated. The effect on the rate of hydrolysis of emulsified soybean oil was investigated in experiments in a pH-stat at pH 6.5 and 37 degrees C. The free fatty acids produced by the hydrolysis were titrated at pH 6.5. It was shown that all three investigated parameters influence the initial rate of hydrolysis, whereas only the lipase activity and the concentration of Ca(2+) affect the subsequent stages. It was also shown that the rate of lipolysis can be controlled by the rate of adding Ca(2+). Thus, it is possible to design an in vitro model using readily available and inexpensive materials in which the hydrolysis rate can be controlled by the continuous addition of Ca(2+).