Liquid chromatography-tandem mass spectrometry for the identification of impurities in d-allethrin samples.

A previous GC/MS study highlighting the impurity profile of the synthetic pesticide d-allethrin is extended here to validate and confirm the impurities identity through the development of soft ionisation HPLC-MS methods. To accomplish this, we developed a reverse phase LC-MS analysis in gradient elution with two distinct soft ionisation techniques, the atmospheric pressure ionisation with electrospray source (API-ESI) and the chemical ionisation (APCI). A single quadrupole and an ion trap, which allowed the simultaneous determination of the molecular masses and structural information of the impurities by acquisition of collisionally induced (CID) product ions spectrum and in-source fragmentation, were employed as analysers. Single quadrupole and ion trap analysers resulted perfectly matching in the d-allethrin impurity fragmentation patterns. All the main impurities over 0.1% identified by GC/MS were confirmed. Results indicate that the proposed HPLC/MS method was found appropriate to confirm the presence of impurities such as chrysolactone, chloro allethrin derivatives, allethrolone and chrysanthemic acid, excluding their formation under GC/MS strong ionisation condition.

Stereoselective determination of allethrin by two-dimensional achiral/chiral liquid chromatography with ultraviolet/circular dichroism detection.

A two-dimensional achiral/chiral HPLC method with circular dichroism (CD) detection was optimized for the stereochemical resolution and determination of the elution order of the eight stereoisomers of synthetic allethrin. A monolithic silica HPLC column (Chromolith, Merck, 100 mm x 4.6 mm i.d.) was put orthogonally to an enantioselective OJ Daicel column (250 mm x 4.6 mm i.d.) by means of a switching valve. The resolution of cis and trans diastereoisomers on the silica column was obtained by using a mobile phase consisting of n-hexane:tert-butyl methyl ether (96:4) (v/v) at a flow rate of 1 ml min(-1). The cis and trans peaks were then switched to the enantioselective OJ column separately in two subsequent injections. The resolution of the four trans stereoisomers was accomplished by using n-hexane:tert-butyl methyl ether (90:10) (v/v), while the mobile phase composition for the four cis stereoisomers consisted of n-hexane:isopropanol (99.3:0.7) (v/v). The CD based detection system allowed the determination of the elution order on the basis of the CD signals of the single stereoisomers, together with the injection of pure stereoisomers. Under the final conditions, the validated method was applied to the determination of stereoisomeric composition and absolute configuration of the prevailing stereoisomers of real samples, i.e. commercial batches of different sources of d-allethrin.

Report of the first workshop on the genetic map of bovine chromosome 1.

A report of the first workshop on the genetic map of bovine chromosome 1 (BTA1) is presented. Five laboratories contributed 31,962 informative meioses from 70 loci. Thirty-two loci which had been typed by at least two laboratories were used to construct a framework genetic map with a likelihood ratio support of at least 1000:1 for locus order. The resulting sex-averaged framework map contained 26 loci and spanned 163.6 CM. The lengths of the female and male maps were 159.5 CM and 165.3 CM, respectively, and there was evidence for an expansion in the telomeric one-third of the male map. Of the four cases where order for closely linked loci differed among the maps produced for each of the contributing laboratories, a consensus order was obtained for three in the framework map. The average genetic distance between framework loci on the sex-averaged map was 6.3 CM.