ABSTRACT
The aim of this study was to achieve rapid gelation of chitosan (CS) and silica (SA) without crosslinking agent, the relationship between process parameters and the composite aerogels properties were also explored. By varying the composition ratio of the system (from SA:CS = 1:1 to 5:1), the system gelation time was reduced by >12 times, and the drying shrinkage of the composite aerogel reached a minimum of 7.6 %. During the two recombination processes, chitosan rapidly formed aqueous colloid secondary structure under the influence of ethanol. This phenomenon reduced the stability of the system and allowed silica to form a two-phase composite hydrogel. Because the network gap between the fibers was used as a limiting medium for gel growth. In addition, the chitosan/silica composite aerogels exhibited a mesoporous structure with low density (0.1144 g/cm3), and the thermal conductivity was 0.028 W/(m·K) at 30 °C. The trimethylchlorosilane made the composite aerogel have good hydrophobicity with water contact angle as 134.7°, and the adsorption capacity of carbon tetrachloride could reach >10 times of its own weight. This study provides an eco-friendly and high-efficiency method for preparing aerogels, which has potential applications in the fields of thermal insulation, oil-water separation, etc.
Subject(s)
Chitosan , Silicon Dioxide/chemistry , Water , Hydrogels , Hydrophobic and Hydrophilic InteractionsABSTRACT
Due to the high surface area and uniform porosity of covalent organic frameworks (COFs), they exhibit superior properties in capturing and detecting even trace amounts of gases in the air. However, the COFs materials that possess dual detected functionality are still less reported. Here, an imine-based COF containing thiophene as a donor and triazine as an acceptor to form spatial-distribution-defined D-A structures was prepared. D-A system between thiophene and triazine facilitates the charge transfer process during the protonation process of the imine and the triazine units. The obtained COF exhibits simultaneous sensing ability toward both acidic and alkaline vapors with obvious colorimetric sensing functionality.
ABSTRACT
In this study, low-density polylactic acid (PLA) flame retardant foams were prepared using lignin fiber (LF), ammonium polyphosphate (APP), resorcinol bis(diphenyl phosphate) (RDP) and SiO2 aerogel. LF, RDP and SiO2 aerogel alone did not improved the flame retardancy of PLA composites; however, APP alone required a higher addition of amount to achieve a better flame retardancy. The synergistic effect between the four can improve the flame retardancy of PLA at a lower addition level. The intumescent flame retardant system composed of LF/APP/RDP/SiO2 aerogel can not only form a dense carbon layer on the surface of the material when burning to improve the flame retardant performance, but also improve the thermal stability of PLA, increase the degradation temperature and reduce the thermal weight loss rate. The final PLA flame retardant foam (density: 0.022 g/cm3) prepared by supercritical foaming can reach V-0 rating in UL-94 vertical combustion test, and the limiting oxygen index (LOI) can reach 30.5 %.
