ABSTRACT
The effects of Li/Nb ratio on the preparation of Li-Nb-O compounds by a hydrothermal method were studied deeply. Li/Nb ratio has a great impact on the formation of LiNbO3; the ratio smaller than 3:1 is beneficial to the formation of LiNbO3, while larger than 3:1, forms no LiNbO3 at all and the morphology and chemical bond of Nb2O5 raw material are totally modified by Li ions. The reason can be attributed to the large content of LiOH, which is beneficial to form Li3NbO4 not LiNbO3, and also, even if LiNbO3 particle locally forms, it is easily dissolved in LiOH solution with strong alkalinity. Pure LiNb3O8 powders are obtained with two absolutely opposite Li/Nb ratios: 8:1 and 1:3; the former shows a unique porous and hollow structure, quite different from the particle aggregation (the latter shows). Compared with Li/Nb = 1:3, the 4.2 times higher photocatalytic performance of LiNb3O8 (Li/Nb = 8:1) are observed and it can be attributed to the unique porous and hollow structure, which provides a high density of active sites for the degradation of MB. Compared to LiNbO3, the improved photocatalytic performance of LiNb3O8 can be attributed to its layered structure type with the reduced symmetry enhancing the separation of electrons and holes.
ABSTRACT
Porous- and hollow-structured LiNb3O8 anode material was prepared by a hydrothermal-assisted sintering strategy for the first time. The phase evolution was studied, and the formation mechanism of the porous and hollow structure was proposed. The formation of the unique structure can be attributed to the local existence of liquid phase because of the volatilization of Li element. As the anode material, the initial discharge capacity is 285.1 mAhg-1 at 0.1 C, the largest discharge capacity reported so far for LiNb3O8. Even after 50 cycles, the reversible capacity can still maintain 77.6 mAhg-1 at 0.1 C, about 2.5 times of that of LiNb3O8 samples prepared by traditional solid-state methods. The significant improvement of Li storage capacity can be attributed to the special porous and hollow structure, which provides a high density of active sites and short parallel channels for fast intercalation of Li+ ions through the surface.
ABSTRACT
Low-temperature Bi-Nb-O system photocatalysts were prepared by a citrate method using homemade water-soluble niobium precursors. The structures, morphologies, and optical properties of Bi-Nb-O system photocatalysts with different compositions were investigated deeply. All the Bi-Nb-O powders exhibit appreciably much higher photocatalytic efficiency of photo-degradation of methyl violet (MV), especially for Bi-Nb-O photocatalysts sintered at 750 °C (BNO750), only 1.5 h to completely decompose MV, and the obtained first-order rate constant (k) is 1.94/h. A larger degradation rate of Bi-Nb-O photocatalysts sintered at 550 °C (BNO550) can be attributed to the synergistic effect between ß-BiNbO4 and Bi5Nb3O15. Bi5Nb3O15 with small particle size on ß-BiNbO4 surface can effectively short the diffuse length of electron. BNO750 exhibits the best photocatalytic properties under visible-light irradiation, which can be attributed to its better crystallinity and the synergistic effect between ß-BiNbO4 and α-BiNbO4. The small amount of α-BiNbO4 loading on surface of ß-BiNbO4 can effectively improve the electron and hole segregation and migration. Holes are the main active species of Bi-Nb-O system photocatalysts in aqueous solution under visible-light irradiation.
