Method development and application to sediments for multi-residue analysis of organic contaminants using gas chromatography-tandem mass spectrometry.

A method for the determination of four classes of potentially toxic substances (PTSs) was developed and applied in marine sediments, including (i) polycyclic aromatic hydrocarbons (PAHs), (ii) polychlorinated biphenyls (PCBs), (iii) polybrominated diphenyl ethers (PBDEs), and (iv) organochlorinated pesticides (OCPs). The method is based on ultrasonic extraction with a mixture of dichloromethane:methanol (9:1 v/v) and gas chromatography coupled with tandem mass spectrometry analysis (GC-MS/MS) in multiple reaction monitoring (MRM) mode. A total of 89 compounds were identified using two precursor-product ion standards for each analyte. The method detection limit (MDL; 0.001-0.055 ng g-1 dw) and method quantification limit (MQL; 0.002-0.184 ng g-1 dw) are below the usual thresholds of pollution adopted by international sediment quality guidelines. The method proved to be selective, sensitive, accurate, and linear, with the advantage of reducing sample handling time and consumable expenses (solvent, adsorbents). The developed method was successfully applied to surface sediments of Sepetiba Bay, Rio de Janeiro State, Brazil. Total concentrations of PAH (29.20-209.5 ng g-1 dw), PCB (0.06-2.16 ng g-1 dw), OCP (0.03-0.33 ng g-1 dw), and PBDE (0.06-0.21 ng g-1 dw) represent a baseline for these compounds and revealed mild to low levels of contamination in comparison to other coastal bays in SE Brazil. By using the proposed method, we expect this preliminary dataset can be expanded and include other similar coastal systems from developing countries marked by scarcity of information about levels, risk assessment, and specific sediment quality guidelines encompassing multiple classes of regulated and emerging organic contaminants.

Polychlorinated biphenyls (PCBs) in water: method development and application to river samples from a populated tropical urban area.

A method for the determination of polychlorinated biphenyls (PCBs) in water from urban rivers was implemented and validated. Extractions of dissolved and particulate PCBs were performed using solid-phase extraction and a pressurized solvent extraction system, respectively, and the analytes were identified and quantified by gas chromatography with tandem mass spectrometry in selected reaction monitoring mode with no further purification. The method was successfully developed for the determination of 41 PCBs with two precursor-product confirmations for each analyte. Low method detection limits (0.06-0.50 ng L-1) and good precision (≤ 20%; n = 8) were obtained, as well a linear response of the calibration curve ranging from 1.0 to 50 ng L-1. Method performance for real samples was tested with water collected weekly in triplicate during April 2018 from a eutrophic river in the city of Rio de Janeiro. The total (dissolved + particulate) PCB concentrations ranged from 2.17 to 5.29 ng L-1, above the threshold for river water quality standards in Brazil. Graphical abstract.

Distribution and source apportionment of hydrocarbons in sediments of oil-producing continental margin: a fuzzy logic approach.

Investigation were carried out targeting distribution and source apportioning of hydrocarbons in surface sediments from shallow to deep waters in the Campos Basin, one of the most important oil-producing provinces in Brazil. The observed levels of aliphatic (≤ 124 µg g-1) and polycyclic aromatic hydrocarbons (PAHs ≤ 599 ng g-1) are lower than those considered relevant for environmental risk to the benthic habitats. Higher median concentrations of aliphatic hydrocarbons (8.49 µg g-1) and PAHs (84.8 ng g-1) in the middle slope sediments (700-1000-m water depths) showed the influence of hydrodynamics upon hydrocarbon accumulation in the sediments. Diagnostic ratios and conventional statistical analysis applied to hydrocarbon data produced insufficient information on the contribution of different sources. These traditional approaches do not consider the potential changes affecting source assignment and therefore cannot deal with the uncertainties. The fuzzy logic applied as an alternative method for data treatment successfully incorporated the uncertainties in the differentiation between petrogenic and pyrolytic sources, including those due to degradation. Moreover, by using fuzzy logic, it was possible to identify that water circulation patterns, mass transport, deposition, and degradation processes are more relevant factors in determining hydrocarbon composition than source proximity.