Recording and erasure of photorefractive holograms in undoped BTO crystal at moderate to high intensities of 639.7 nm laser under action of 532 nm laser pre-illumination.

We investigate recording and erasure of photorefractive holographic gratings in an undoped Bi12TiO20 crystal in a moderate to high intensity regime of the recording beams at 639.7 nm without and with the action of laser pre-illumination at 532 nm. The detected hologram without pre-illumination indicates the participation of two photorefractive electronic gratings in its recording process, and the diffracted signal by itself exhibits a fivefold enhancement when the total intensity increases from 38.4 to 214.5 mW/cm2. The dependence of the measured total diffraction efficiency on intensity was investigated and showed linear behavior. At least three gratings are present in the regime of pre-illumination and participate in the writing and erasure of holographic mechanisms. Two of them are electronic, and one is hole-based, with a phase difference of Δϕ between them. The theoretical approach used to analyze the total diffraction efficiency based upon the photorefractivity standard model, and considering the presence of the three gratings, showed good agreement with the holographic erasure experimental data and permitted us to compute Δϕ, which exhibited strong and unusual dependence on the total intensity.

134Cs activity standardization by 4πß(LS)-γ(NaI-Tl) anticoincidence counting and submission to international reference system.

From a commercial supplier a solution containing 134Cs has been standardized at National Laboratory for Ionizing Radiation Metrology (LNMRI) for the first time using three Liquid scintillation based measurement. These measurement methods are 4πß-γ live-timed anticoincidence counting, 4πß-γ coincidence counting and 3H-standard efficiency tracing with the CNET methods. The results obtained by anticoincidence counting was adopted as reference value and its combined uncertainty was 0.38%. The agreement of this reference value with coincidence counting and CNET methods were 0.39% and 0.34% respectively and were in consistency with each uncertainty method. The weighted mean results coincidence counting and CNET methods are also in close agreement 0.03% with anticoincidence counting method and meets the requirement of primary and national standard. This standardization was made in order to reduce the uncertainty in 134Cs measurement in Brazil and also following a request made by Bureau International des Poids and Mesures for new submission to International Reference System. The LNMRI last submission was made in 1987. Therefore from a 134Cs master solution a NIST ampoules was prepared and LNMRI/IRD submitted it to the International Reference System, Bureau International of Poids and Measures (SIR/BIPM). In this paper will be analyzed the LNMRI measurement and performance each measurement methods and also take into account the reference value of KCDB, we determined also the 134Cs gamma emission probabilities of main energy.

Determination of impurities in (124)I samples by high resolution gamma spectrometry.

(124)I is a radionuclide used in the diagnosis of tumors. The National Health Agency requires identification and activity measurement of impurities. Using gamma spectrometry with an efficiency calibrated high-purity germanium detector, impurities (125)I and (126)I in an (1)(24)I production sample were identified. Activity ratios of (125)I and (126)I to (124)I were approximately 0.5% and 98%, respectively.

Color tunability with temperature and pump intensity in Yb3+/Tm3+ codoped aluminosilicate glass under anti-Stokes excitation.

Pump and thermally induced color tunabilities were demonstrated in Yb(3+)/Tm(3+) codoped low silica calcium aluminosilicate (LSCAS) glass under anti-Stokes excitation at 1.064 microm. The effects of pump intensity and sample's temperature on the upconversion emissions and mainly on the color tunabilities (from 800 to 480 nm) were investigated. The results revealed a 20- and a threefold reductions at 800/480 nm ratio as, respectively, the pump intensity and sample's temperature were increased from 27 to 700 kW/cm(2) and from 296 to 577 K. These behaviors with pump intensity and temperature (a strong increase of the 480 nm emission in comparison with the 800 nm one) were attributed to the several efficient processes occurring in the LSCAS system (Yb(3+)-->Tm(3+) energy-transfer processes, easy saturations of the Yb(3+) and Tm(3+) excited states, and radiative emissions). Besides these assigns, the temperature dependence is mainly assigned to the temperature-dependent effective absorption cross section of the ytterbium sensitizer through the so-called multiphonon-assisted anti-Stokes excitation process. Theoretical analyses and fits of the experimental data provided quantitative information.

Deep and shallow trap contributions to the ionic current in the thermal-electric field poling in soda-lime glasses.

In this paper, we investigate the contribution of deep and shallow trapped ions on the second-order nonlinearity during typical poling procedures in soda-lime glass. The zero-electric field potential barriers of each contribution were estimated. The shallow traps, measured through the electrical ionic current, was determined as ~0.34 eV; while deep trap activation energy, measured by means of the thermal/electric field activated luminescence, was estimated ~3.8 eV. The traps show different dependence on its thermal energy onset for different applied electric field. The ionic current is linearly dependent on the electric field. The luminescence has a minimum electric field ~3.6 kV/cm and thermal energy ~31 meV (~87 degrees C) to occur. The average ionic jump lengths for both processes are also estimated, and the deep trap length is about ten times shorter than the shallow trap one. Samples poled at the border of the luminescence onset parameters revealed that the higher its contributions the more stable the induced second order nonlinearity.

Thermal lens study of energy transfer in Yb(3+)/Tm(3+)-co-doped glasses.

Energy transfer (ET) and heat generation processes in Yb(3+)/Tm(3+)-co-doped low-silica calcium-aluminosilicate glasses were investigated using thermal lens and photoluminescence measurements. Stepwise ET processes from Yb(3+) to Tm(3+), with excitation at 0.976 mum, produced efficient emission in the mid-infrared range at around 1.8 mum, with high fluorescence quantum efficiency (~0.50) and relatively low thermal loading (

Heated humidification or face mask to prevent upper airway dryness during continuous positive airway pressure therapy.

STUDY OBJECTIVES: The objectives of this study were (1) to evaluate the way in which nasal continuous positive airway pressure (CPAP) therapy influences the relative humidity (rH) of inspired air; and (2) to assess the impact on rH of the addition of an integrated heated humidifier or a full face mask to the CPAP circuitry. DESIGN: The studies were performed in 25 patients with obstructive sleep apnea syndrome receiving long-term nasal CPAP therapy and complaining of nasal discomfort. During CPAP administration, temperature and rH were measured in the mask either during a night's sleep for 8 patients or during a daytime study in which the effects of mouth leaks were simulated in 17 patients fitted with either a nasal mask (with or without humidification) or a face mask alone. SETTING: University hospital sleep disorders center. MEASUREMENTS AND RESULTS: Compared with the values obtained with CPAP alone, integrated heated humidification significantly increased rH during the sleep recording, both when the mouth was closed (60 +/- 14% to 81 +/- 14%, p < 0.01) and during mouth leaks (43 +/- 12% to 64 +/- 8%, p < 0.01). During the daytime study, a significant decrease in rH was observed with CPAP alone. Compared with the values measured during spontaneous breathing without CPAP (80 +/- 2%), the mean rH was 63 +/- 9% (p < 0.01) with the mouth closed and 39 +/- 9% (p < 0. 01) with the mouth open. The addition of heated humidification to CPAP prevented rH changes when the mouth was closed (82 +/- 12%), but did not fully prevent the rH decrease during simulation of mouth leaks (63 +/- 9%) compared with the control period (80 +/- 2%, p < 0. 01). Finally, attachment of a face mask to the CPAP circuitry prevented rH changes both with the mouth closed (82 +/- 9%) and with the mouth open (84 +/- 8%). CONCLUSIONS: These data indicate that inhaled air dryness during CPAP therapy can be significantly attenuated by heated humidification, even during mouth leaks, and can be totally prevented by using a face mask.

Long-term efficacy of fixed CPAP recommended by Autoset for OSAS.

The Autoset autotitration system (Resmed, Australia) was designed as an aid for determination of the effective level of CPAP. Two studies have shown that the 95% pressure centile during a night with Autoset, after excluding any periods with severe leak (P95), was well correlated with the pressure determined manually according to the reference method. However, the suitability of P95 under Autoset for treatment with conventional CPAP needed to be evaluated outside of the context of titration. The objective of this study was to measure the compliance and efficacy of CPAP at P95 determined by Autoset, after 3 months. Twenty-four patients who had undergone routine autotitration by Autoset under polysomnographic control in the laboratory for previously untreated OSAS were evaluated after 3 months of treatment with CPAP at P95. This evaluation was based on compliance, daily usage, determined by reading the hourly counter, Epworth sleepiness score and home respiratory recording under CPAP. Polysomnography under Autoset showed a significant reduction of abnormal respiratory events (apnea-hypopnea index (AHI): 5.7 (+/-4.6) vs 69.6 (+/-29.8) n/h; p<0.001). P95 was between 8.5 and 15 cm H2O (mean: 11.2 (+/-1.6)). Two patients were lost to follow-up. At 3 months, 18 out of 22 (82%) patients declared that they were still using their machine with a daily usage of 5.25 (+/-1.82) h. The Epworth sleepiness scale was significantly decreased (5 (+/-4.1) vs 11.4 (+/-5.4); p<0.05). P95 recommended by Autoset remained effective on abnormal respiratory events with a low AHI (4.1 (+/-3.2) n/h) and a low 4% oxygen desaturation index (3.6 (+/-4.5) n/h) under CPAP. This study confirms the efficacy of autotitration and the suitability of P95 determined by Autoset for long-term treatment by conventional CPAP at home.

Fourfold output power enhancement and threshold reduction through thermal effects in an Er(3+)/Yb(3+)-codoped optical fiber laser excited at 1.064 mum.

Thermally induced output power enhancement and threshold reduction in an Er(3+)/Yb(3+) -codoped optical fiber laser at 1.54mum pumped by 1.064-mu;m cw radiation is demonstrated. Steady fourfold output power increase and threshold decrease were achieved by heating of the Yb(3+) -sensitized Er(3+) -doped fiber laser medium in the temperature range 23-150 degrees C degrees . The laser efficiency thermal behavior is assigned to the temperature-dependent effective absorption cross section of the ytterbium sensitizer through the so-called multiphonon-assisted anti-Stokes excitation process.