ABSTRACT
Bariatric surgery is the most effective treatment for morbid obesity, but it can cause numerous adverse effects. This systematic review and meta-analysis aimed to evaluate whether bariatric surgery changes patient salivary flow. We searched for articles in the Web of Science, Pubmed/MEDLINE, and Scopus databases using the search terms "oral health AND bariatric surgery OR gastrectomy OR obesity surgery." We recovered 845 articles. After the removal of duplicates and exclusions, eight studies remained. Of them, five showed no significant difference in salivary flow values, two showed an increase in flow rate, and one showed a reduction in flow rate (p < 0.05). The results of the included studies showed no significant alteration in salivary flow rate for up to 24 months after bariatric surgery.
Subject(s)
Bariatric Surgery , Salivation , HumansABSTRACT
Herein, the effect of different post-pressing times and pressure in two cycles of polymerization on the degree of conversion (DC) of thermally activated acrylic resin (TRRA) is analyzed to optimize the polymerization of this material. After post-pressing for 0, 6, or 12 h, polymerization was performed with or without a pressure of 60 psi (0.41 MPa) in a short (4 h) or a long (11 h) cycle, totaling 12 groups. To determine the DC, PMMA specimens were analyzed by Fourier transform infrared spectroscopy. The influence of each factor alone on the DC was studied by experimental planning. The statistical tests used were three-way ANOVA, t-test, Tukey's test, and Levene's test, with a margin of error of 5%. Two groups prepared with post-pressing times of 12 h had the lowest DC (p < 0.001). Post-pressing times of 0 and 6 h did not yield statistically different results. Pressure increased the DC in only one group (long cycle +12 h, p=0.001). The short cycle resulted in a higher DC than the long cycle in 2 groups (with pressure +0 h, p=0.002; without pressure +6 h, p=0.015), while the long cycle yielded a statistically higher DC in only one group (with pressure +12 h, p < 0.001). The polymerization showed satisfactory DC in all 12 groups. Small differences found among the specimens indicate that the pressure, post-pressing time, and polymerization cycles herein were not influential factors for the DC of PMMA.