ABSTRACT
Glyphosate is the main herbicide currently used in the world due to wide applicability and efficiency in controlling weeds in many crops. However, its overuse may lead to undesirable impacts on the environment and to human health in the long run. This present study aimed to optimize and validate solid phase extraction (SPE) using an anionic resin for the simultaneous and direct determination of glyphosate and aminomethylphosphonic acid (AMPA) in water samples using high-performance liquid chromatography combined with inductively coupled plasma with triple quadrupole mass spectrometer (HPLC-ICP-MS/MS). The results showed that recovery percentage and relative standard deviation were 103.9 ± 7.9 and 99.40 ± 9.9% for glyphosate and AMPA, respectively. The validation certified that the method was precise, accurate, linear, and selective, with a limit of quantification of 1.09 and 0.29 µg L-1 for glyphosate and AMPA, respectively. The optimized methodology reached the concentration factor of 250 times and was successfully applied to analyze water samples from hydroponic cultivation of the eucalyptus seedlings. The results showed that the exudation process occurs at glyphosate doses starting from 2 L ha-1.
Subject(s)
Eucalyptus/growth & development , Glycine/analogs & derivatives , Isoxazoles/chemistry , Tetrazoles/chemistry , Water Pollutants, Chemical/analysis , Chromatography, High Pressure Liquid/methods , Glycine/analysis , Glycine/isolation & purification , Herbicides/analysis , Hydroponics , Limit of Detection , Reproducibility of Results , Seedlings/growth & development , Solid Phase Extraction , Tandem Mass Spectrometry/methods , GlyphosateABSTRACT
This work evaluated the potential of Catharanthus roseus in phytoremediation of As, Ba, Cd, Cu, Cr, Ni, Pb, Se and Zn in sewage sludge-based substrates. C. roseus was cultivated for 108 days in a treatment containing sewage sludge:vermiculite (70:30%) and in the control with 100% commercial substrate. The plants cultivated in sludge showed approximately four times greater height, number of leaves and stem diameter, as well as 89% higher fresh mass than those of the control. The highest concentrations of the metals were obtained in the roots of plants grown in the sludge, and ranged from 2.04 (Cd) to 1121 mg kg-1 (Zn). Cu, Cd and Zn had a higher bioconcentration factor than 1 in both treatments. On the other hand, the translocation factor value in the control was greater than 1 for Ba, Cd, Cu, Ni, Se and Zn. The results showed that C. roseus was efficient in the phytoremediation of the evaluated metals, in which the translocation process was progressive in the treatment that presented higher metal content.
Subject(s)
Catharanthus/metabolism , Metals, Heavy/metabolism , Refuse Disposal/methods , Soil Pollutants/metabolism , Biodegradation, Environmental , Catharanthus/growth & development , Metals, Heavy/analysis , Plant Leaves/growth & development , Plant Leaves/metabolism , Plant Roots/growth & development , Plant Roots/metabolism , Sewage/chemistry , Soil Pollutants/analysisABSTRACT
The current environmental legislations recommend monitoring chemical contaminants such as polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans before the use of sewage sludge on the agricultural land. In this study, a solid-liquid extraction with low-temperature purification (SLE-LTP) was optimized and validated to determine 2,3,7,8-tetrachlorodibenzo-p-dioxin and 2,3,7,8-tetrachlorodibenzofuran in sewage sludge and soil samples. The analyses were performed by gas chromatography-mass spectrometry operating in the selective ion mode (GC-MS-SIM). Acetonitrile:ethyl acetate 6.5:1.5 (v/v) was the best extraction phase, and the recoveries percentages were close to 100%. The linearity was demonstrated in the range of 1.25-25 µg L-1 of 1.25-20 µg L-1 for sewage sludge and soil, respectively. Matrix effect was proved for the two compounds and in the two matrices studied. Extraction percentages were between 78 and 109% and relative standard deviations ≤ 19%. The proposed method is faster than methods described in the literature because showed a few steps. The quantification limits (LOQ) in sewage sludge were 6.4 and 32 ng TEQ kg-1 for 2,3,7,8-TCDF and 2,3,7,8-TCDD, respectively. In soil, LOQs were 0.8 and 8.0 ng TEQ kg-1 for 2,3,7,8-TCDF and 2,3,7,8-TCDD, respectively. These values are lower than the maximum residue limits established by European Legislation. The method was applied to 22 agricultural soil samples from different Brazilian cities and 2,3,7,8-TCDF was detected in one of these samples.
