ABSTRACT
This study experimentally and numerically validates the commonly employed technique of laser-induced heating of a material in optical temperature sensing studies. Furthermore, the Er3+-doped glass microspheres studied in this work can be employed as remote optical temperature sensors. Laser-induced self-heating is a useful technique commonly employed in optical temperature sensing research when two temperature-dependent parameters can be correlated, such as in fluorescence intensity ratio vs. interferometric calibration, allowing straightforward sensor characterization. A frequent assumption in such experiments is that thermal homogeneity within the sensor volume, that is, a sound hypothesis when dealing with small volume to surface area ratio devices such as microresonators, but has never been validated. In order to address this issue, we performed a series of experiments and simulations on a microsphere supporting whispering gallery mode resonances, laser heating it at ambient pressure and medium vacuum while tracking the resonance wavelength shift and comparing it to the shift rate observed in a thermal bath. The simulations were done starting only from the material properties of the bulk glass to simulate the physical phenomena of laser heating and resonance of the microsphere glass. Despite the simplicity of the model, both measurements and simulations are in good agreement with a highly homogeneous temperature within the resonator, thus validating the laser heating technique.
ABSTRACT
Large mode area fibers have become indispensable in addressing the power requirements of laser sources in gravitational wave detectors. Besides high power capabilities, the system must provide an excellent beam quality and polarization. In this Letter, we present the characterization of a monolithic high-power fiber amplifier at 1064 nm, built using an ytterbium-doped chirally coupled-core fiber, which achieves an output power of 100 W in a linearly polarized $ {{\rm TEM}_{00}} $TEM00 mode in an all-fiber setup.
ABSTRACT
Next-generation gravitational wave detectors require single-frequency and high power lasers at a wavelength of 1.5 µm addressing a set of demanding requirements such as linearly-polarized TEM00 radiation with low noise to run for long periods. In this context, fiber amplifiers in MOPA configuration are promising candidates to fulfill these requirements. We present a single-frequency monolithic Er:Yb co-doped fiber amplifier (EYDFA) at 1.5 µm with a linearly-polarized TEM00 output power of 100 W. The EYDFA is pumped off-resonant at 940 nm to enhance the Yb-to-Er energy transfer efficiency and enable higher ASE threshold. We also performed numerical simulations to investigate the off-resonant pumping scheme and confirm the corresponding experimental results.
ABSTRACT
We report an analytical model and experimental validation of the temporal dynamics of 3-level system fiber amplifiers. The model predictions show a good agreement with the measured pump power to output power and the pump power to output phase transfer functions in an EDFA pumped at 976 nm, as well as with the typical literature values for the spontaneous lifetime of the involved energy levels. The measurements show a linear relation between the effective lifetime of the meta-stable level and the output power, and a filtering of the temperature-induced phase-shift due to the quantum defect at a sufficiently high frequency modulation.