Temperature dependence of spin pumping and Gilbert damping in thin Co/Pt bilayers.

We report on the temperature dependence of the spin-pumping effect and the Gilbert damping in Co/Pt bilayers grown on Silicon oxide by measuring the change of the linewidth in a ferromagnetic resonance (FMR) experiment. By varying the Co thickness d(Co) between 1.5 nm and 50 nm we find that the damping increases inversely proportional to d(Co) at all temperatures between 300 K and 5 K, showing that the spin pumping effect does not depend on temperature. We also find that the linewidth increases with decreasing temperature for all thicknesses down to about 30 K, before leveling off to a constant, or even decreasing again. This behavior is similar to what is found in bulk ferromagnets, leading to the conclusion that in thin films a conductivity-like damping mechanism is present similar to what is known in crystals.

Transition voltage spectroscopy and the nature of vacuum tunneling.

Transition voltage spectroscopy (TVS) has been proposed as a tool to analyze charge transport through molecular junctions. We extend TVS to Au-vacuum-Au junctions and study the distance dependence of the transition voltage V(t)(d) for clean electrodes in cryogenic vacuum. On the one hand, this allows us to provide an important reference for V(t)(d) measurements on molecular junctions. On the other hand, we show that TVS forms a simple and powerful test for vacuum tunneling models.

Conductance switching in Ag(2)S devices fabricated by in situ sulfurization.

We report a simple and reproducible method to fabricate switchable Ag(2)S devices. The alpha-Ag(2)S thin films are produced by a sulfurization process after silver deposition on an Si substrate. Structure and composition of the Ag(2)S are characterized using XRD and RBS. Our samples show semiconductor behaviour at low bias voltages, whereas they exhibit reproducible bipolar resistance switching at higher bias voltages. The transition between both types of behaviour is observed by hysteresis in the I-V curves, indicating decomposition of the Ag(2)S, increasing the Ag(+) ion mobility. The as-fabricated Ag(2)S samples are a good candidate for future solid state memory devices, as they show reproducible memory resistive properties and they are fabricated by an accessible and reliable method.

Highly conductive molecular junctions based on direct binding of benzene to platinum electrodes.

Highly conductive molecular junctions were formed by direct binding of benzene molecules between two Pt electrodes. Measurements of conductance, isotopic shift in inelastic spectroscopy, and shot noise compared with calculations provide indications for a stable molecular junction where the benzene molecule is preserved intact and bonded to the Pt leads via carbon atoms. The junction has a conductance comparable to that for metallic atomic junctions (around 0.1-1G0), where the conductance and the number of transmission channels are controlled by the molecule's orientation at different interelectrode distances.

Electron-vibration interaction in single-molecule junctions: from contact to tunneling regimes.

Point contact spectroscopy on a H(2)O molecule bridging Pt electrodes reveals a clear crossover between enhancement and reduction of the conductance due to electron-vibration interaction. As single-channel models predict such a crossover at a transmission probability of tau=0.5, we used shot noise measurements to analyze the transmission and observed at least two channels across the junction where the dominant channel has a tau=0.51 +/- 0.01 transmission probability at the crossover conductance, which is consistent with the predictions for single-channel models.

Formation of a metallic contact: jump to contact revisited.

The transition from tunneling to metallic contact between two surfaces does not always involve a jump, but can be smooth. We have observed that the configuration and material composition of the electrodes before contact largely determine the presence or absence of a jump. Moreover, when jumps are found preferential values of conductance have been identified. Through a combination of experiments, molecular dynamics, and first-principles transport calculations these conductance values are identified with atomic contacts of either monomers, dimers, or double-bond contacts.

Evidence for a single hydrogen molecule connected by an atomic chain.

Stable, single-molecule conducting-bridge configurations are typically identified from peak structures in a conductance histogram. In previous work on Pt with H2 at cryogenic temperatures it has been shown that a peak near 1G0 identifies a single-molecule Pt-H2-Pt bridge. The histogram shows an additional structure with lower conductance that has not been identified. Here, we show that it is likely due to a hydrogen decorated Pt chain in contact with the H2 molecular bridge.

Electronic and atomic shell structure in aluminium nanowires.

We report experiments on aluminium nanowires in ultra-high vacuum at room temperature that reveal a periodic spectrum of exceptionally stable structures. Two 'magic' series of stable structures are observed: at low conductance, the formation of stable nanowires is governed by electronic shell effects whereas for larger contacts atomic packing dominates. The crossover between the two regimes is found to be smooth. A detailed comparison of the experimental results to a theoretical stability analysis indicates that, while the main features of the observed electron-shell structure are similar to those of alkali and noble metals, a sequence of extremely stable wires plays a unique role in aluminium. This series appears isolated in conductance histograms and can be attributed to 'superdeformed' non-axisymmetric nanowires.

The effect of bonding of a CO molecule on the conductance of atomic metal wires.

We have measured the effect of bonding of a CO molecule on the conductance of Au, Cu, Pt and Ni atomic contacts at 4.2 K. When CO gas is admitted to the metal nanocontacts, a conductance feature appears in the conductance histogram near 0.5 of the quantum unit of conductance, for all metals. For Au, the intensity of this fractional conductance feature can be tuned with the bias voltage, and it disappears at high bias voltage (above approximately 200 mV). The bonding of CO to Au appears to be weakest, and associated with the formation of monatomic Au wire.

Vibrationally induced two-level systems in single-molecule junctions.

Single-molecule junctions are found to show anomalous spikes in dI/dV spectra. The position in energy of the spikes is related to local vibration mode energies. A model of vibrationally induced two-level systems reproduces the data very well. This mechanism is expected to be quite general for single-molecule junctions. It acts as an intrinsic amplification mechanism for local vibration mode features and may be exploited as a new spectroscopic tool.

Shot noise measurements on a single molecule.

We report measurements of shot noise in the current through a single D2 molecule. The molecular junctions were formed by means of the mechanically controllable break junction technique. The configuration of the D2 molecule bridging the gap between two Pt tips is verified by use of point contact spectroscopy. Maintaining the same junction shot noise measurements were performed and the observed quantum suppression shows that conductance is carried dominantly by a single, almost fully transparent conductance channel. This observation allows us to decide between conflicting model calculations for this system, and this may serve as a benchmark for further computations on molecular junctions.

Oxygen-enhanced atomic chain formation.

We report experimental evidence for atomic chain formation during stretching of atomic-sized contacts for gold and silver, that is strongly enhanced due to oxygen incorporation. While gold has been known for its tendency to form atomic chains, for silver this is only observed in the presence of oxygen. With oxygen the silver chains are as long as those for gold, but the conductance drops with chain length to about 0.1 conductance quantum. A relation is suggested with previous work on surface reconstructions for silver (110) surfaces after chemisorption of oxygen.

Atomic-size oscillations in conductance histograms for gold nanowires and the influence of work hardening.

Nanowires of different natures have been shown to self-assemble as a function of stress at the contact between two macroscopic metallic leads. Here we demonstrate for Au wires that the balance between various metastable nanowire configurations is influenced by the microstructure of the starting materials, and we discover a new set of periodic structures, which we interpret as due to the atomic discreteness of the contact size for the three principal crystal orientations.

Observation of a parity oscillation in the conductance of atomic wires.

Using a scanning tunnel microscope or mechanically controllable break junctions atomic contacts for Au, Pt, and Ir are pulled to form chains of atoms. We have recorded traces of conductance during the pulling process and averaged these for a large number of contacts. An oscillatory evolution of conductance is observed during the formation of the monoatomic chain suggesting a dependence on the numbers of atoms forming the chain being even or odd. This behavior is not only observed for the monovalent metal Au, as was predicted, but is also found for the other chain-forming metals, suggesting it to be a universal feature of atomic wires.

Measurement of the conductance of a hydrogen molecule.

Recent years have shown steady progress towards molecular electronics, in which molecules form basic components such as switches, diodes and electronic mixers. Often, a scanning tunnelling microscope is used to address an individual molecule, although this arrangement does not provide long-term stability. Therefore, metal-molecule-metal links using break-junction devices have also been explored; however, it is difficult to establish unambiguously that a single molecule forms the contact. Here we show that a single hydrogen molecule can form a stable bridge between platinum electrodes. In contrast to results for organic molecules, the bridge has a nearly perfect conductance of one quantum unit, carried by a single channel. The hydrogen bridge represents a simple test system in which to understand fundamental transport properties of single-molecule devices.

Current-voltage curves of atomic-sized transition metal contacts: an explanation of why Au is Ohmic and Pt is not.

We present an experimental study of current-voltage (I-V) curves on atomic-sized Au and Pt contacts formed under cryogenic vacuum (4.2 K). Whereas I-V curves for Au are almost Ohmic, the conductance G=I/V for Pt decreases with increasing voltage, resulting in distinct nonlinear I-V behavior. The experimental results are compared with first principles density functional theory calculations for Au and Pt, and good agreement is found. The difference in conductance properties for Pt vs Au can be explained by the underlying electron valence structure: Pt has an open d shell while Au has not.

Crossover from electronic to atomic shell structure in alkali metal nanowires.

After making a cold weld by pressing two clean metal surfaces together, upon gradually separating the two pieces a metallic nanowire is formed, which progressively thins down to a single atom before contact is lost. In previous experiments we have observed that the stability of such nanowires is influenced by electronic shell filling effects, in analogy to shell effects in metal clusters. For sodium and potassium at larger diameters there is a crossover to crystalline wires with shell closings corresponding to the completion of additional atomic layers. This observation completes the analogy between shell effects observed for clusters and nanowires.

Atomic-size metallic conductors.

A number of newly developed experimental techniques and theoretical insights have made it possible to investigate the electronic transport properties of conductors at the atomic scale. Although the field is still rapidly evolving, a number of new discoveries, concepts and insights have been clearly established. The central theme of this brief review will be the electronic conductance of a single atom. This conductance can be described in terms of a number of quantum modes, where the number of these modes is determined by the valence orbitals of the metal atom. I first present some elements of the theoretical basis for these concepts, and discuss the various experimental tools that have been used to verify it. Electronic conductance at the atomic scale cannot be separated from the problem of the energetics and dynamics of atomic-scale configurations. Investigations in this area have produced a number of surprising discoveries, and of these I will discuss the spontaneous formation of a conducting chain of single gold atoms, and the enhanced stability of nanowires of alkali metals at 'magic' radii determined by shell structure of the conductance modes.

Common origin for surface reconstruction and the formation of chains of metal atoms.

During the fracture of nanocontacts gold spontaneously forms freely suspended chains of atoms, which is not observed for the isoelectronic noble metals Ag and Cu. Au also differs from Ag and Cu in forming reconstructions at its low-index surfaces. Using mechanically controllable break junctions we show that all the 5d metals that show similar reconstructions (Ir, Pt, and Au) also form chains of atoms, while both properties are absent in the 4d neighbor elements (Rh, Pd, and Ag), indicating a common origin for these two phenomena. A competition between s and d bonding is proposed as an explanation.