ABSTRACT
This work proposes, analyzes, designs, and validates superior topologies of UHGH converters that are capable of supporting extremely large conversion ratios up to â¼2000× and output voltage up to â¼4-12 kV for future mobile soft robots from an input voltage as low as the range of a 1-cell battery pack. Thus, the converter makes soft robots standalone systems that can be untethered and mobile. The extremely large voltage gain is enabled by a unique hybrid combination of a high-gain switched magnetic element (HGSME) and a capacitor-based voltage multiplier rectifier (CVMR) that, together, achieve small overall size, efficient operation, and output voltage regulation and shaping with simple duty-cycle modulation. With superior performance, power density, and compact size, the UHGH converters prove to be a promising candidate for future untethered soft robots.
ABSTRACT
This paper presents the project proposal of a low-cost transducer with a Hall-effect sensor placed in a ferromagnetic core's air gap, which enables the measurement of the distorted voltage instantaneous values without the feedback loop used for measurements in electrical machines. The presented transducer allows for electrical separation between the measured voltage and the voltage at the output. Moreover, the influences of frequency, additional resistance, and the reactance of the winding circuit on the voltage phase shift caused by winding inductance with ferrite core and amplitude are discussed. The result of simulating leakage inductance of measuring winding with ferrite core with an air gap is calculated using finite element analysis. Experimental investigations of the voltage phase shift angle and output voltage amplitude drop for the voltage transducers with an open feedback loop are carried out, taking into account the linear core magnetization characteristic.
ABSTRACT
Transformers are required to demonstrate the ability to withstand short circuit currents. Over currents caused by short circuit can give rise to windings deformation. In this paper, a novel method is proposed to monitor the state of transformer windings, which is achieved through on-line detecting the leakage inductance of the windings. Specifically, the mathematical model is established for on-line identifying the leakage inductance of the windings by applying least square algorithm (LSA) to the equivalent circuit equations. The effect of measurement and model inaccuracy on the identification error is analyzed, and the corrected model is also given to decrease these adverse effect on the results. Finally, dynamic test is carried out to verify our method. The test results clearly show that our method is very accurate even under the fluctuation of load or power factor. Therefore, our method can be effectively used to on-line detect the windings deformation.
ABSTRACT
Transformers are required to demonstrate the ability to withstand short circuit currents. Over currents caused by short circuit can give rise to windings deformation. In this paper, a novel method is proposed to monitor the state of transformer windings, which is achieved through on-line detecting the leakage inductance of the windings. Specifically, the mathematical model is established for on-line identifying the leakage inductance of the windings by applying least square algorithm (LSA) to the equivalent circuit equations. The effect of measurement and model inaccuracy on the identification error is analyzed, and the corrected model is also given to decrease these adverse effect on the results. Finally, dynamic test is carried out to verify our method. The test results clearly show that our method is very accurate even under the fluctuation of load or power factor. Therefore, our method can be effectively used to on-line detect the windings deformation.
