Determination of microplastic content in seafood: An integrated approach combined with the determination of elemental contaminants.

A method for the determination of microplastic (MP) content in seafood is proposed based on the selective digestion of seafood without the degradation of MP. A simple approach was developed using diluted acid with microwave-assisted wet digestion. The following parameters were evaluated: nitric acid concentration (0.5 to 14.4 mol L-1), digestion temperature (180 to 220 °C), irradiation program holding time (10 to 30 min), MP particle size (0.3 to 5 mm), and the seafood mass (0.5 to 2 g). To develop a reliable method for the determination of MP amount, up to 2 g of an in natura seafood sample were spiked with a known amount of MP (100 mg of mixed MP). Suitable conditions were obtained using 1 mol L-1 HNO3 at 200 °C (10 min holding time). Digests were filtered and the plastic content was gravimetrically determined. The heating program was 20 min, which represents a significant reduction in the time normally reported in the literature for MP analysis (from few hours up to 3 days). The proposed method allowed gravimetric determination of eight plastic types (polyethylene terephthalate, polystyrene, expanded polystyrene, polypropylene, high and low density polyethylene, polycarbonate and polyvinyl chloride) with particle size ≥0.3 mm. Up to 2 g of an in natura seafood sample (shark species, acoupa weakfish, tuna fish, trahira, and pink shrimp) were efficiently digested, which opened the possibility of using the proposed digestion method for determining elemental contaminants (Al, As, Ca, Cd, Co, Cr, Cu, Fe, Hg, La, Mg, Mn, Mo, Ni, Pb, and Zn). Thus, as the main feature of the proposed digestion method is the possibility of determining MP and elemental contaminants using the same digestion protocol, saves time and reagents and provides accurate and precise information about different classes of marine pollutants (MP and elemental contaminants).

Determination of inorganic contaminants in carbon nanotubes by plasma-based techniques: Overcoming the limitations of sample preparation.

In this work, sample preparation of carbon nanotubes (CNTs) for further determination of inorganic contaminants was investigated using a microwave-assisted wet digestion single reaction chamber system (MAWD-SRC). Analytes (Al, As, Ca, Cd, Co, Cr, Fe, La, Mg, Mo, Ni, Pb and Zn) were determined in CNTs by inductively coupled plasma optical emission spectrometry (ICP-OES) and inductively coupled plasma mass spectrometry (ICP-MS, except for Al, Ca, Fe and Mg). Method parameters were evaluated, as the mass of CNT (25-300 mg), the temperature (220-270 °C) and the time (35-75 min) of irradiation program. The accuracy was evaluated by using a certified reference material (CRM) of CNT and also by comparison of the results with those obtained using neutron activation analysis (NAA) and high resolution continuum source graphite furnace atomic absorption spectrometry with direct solid sampling (DSS-HR-CS-GF AAS). Quantitative recoveries for all elements were obtained using 275 mg of CNTs, 6 mL of 14.4 mol L-1 HNO3 and 0.5 mL of 30% H2O2 with an irradiation program of 65 min (35 min at 270 °C). No statistical difference was observed between the results obtained after the decomposition of CNTs by MAWD-SRC with those obtained by NAA and DSS-HR-CS-GF AAS. No difference was also observed for the results using the proposed method and the values for the CRM of CNT. The use of MAWD-SRC showed good performance for CNTs digestion using relatively high sample mass (up to 275 mg), contributing to low limits of quantification (LOQs) and overcoming the current limitations of sample preparation. To the best knowledge of the authors, this work reports the highest sample mass feasible to be decomposed using wet digestion for CNTs among the methods proposed in literature.

Microwave-assisted ultraviolet digestion of petroleum coke for the simultaneous determination of nickel, vanadium and sulfur by ICP-OES.

A method for the simultaneous determination of Ni, V and S in petroleum coke by inductively coupled plasma optical emission spectrometry (ICP-OES) after microwave-assisted ultraviolet digestion (MW-UV) in closed vessels was proposed. Digestion was performed using electrodeless discharge lamps positioned inside quartz vessels and turned on by microwave radiation. The following parameters were evaluated: HNO3 concentration (15 mL of 1, 4, 7, 10 or 14.4 mol L(-1)), volume of H2O2 (30%, 1 or 3 mL), sample mass (100, 250 or 500 mg) and heating time (40 or 60 min) with or without the use of UV lamps. Digestion efficiency was evaluated by the determination of the residual carbon content (RCC) in digests. Using UV lamps lower RCC was obtained and the combination of 4 mol L(-1) HNO3 with 3 mL of H2O2 and 60 min of heating allowed a suitable digestion of up to 500 mg of petroleum coke (RCC< 21%). The agreement with the reference values for Ni, V and S (obtained by digestion of petroleum coke by microwave-induced combustion) and with a certified reference material of petroleum coke was between 96 and 101%. The proposed method was considered as advantageous when compared to American Society for Testing and Materials method because it allowed the simultaneous determination of Ni, V and S with lower limit of detection (0.22, 0.12 and 8.7 µg g(-1) for Ni, V and S, respectively) avoiding the use of concentrated nitric acid and providing digests suitable for routine analysis by ICP-OES.