Magnetic Skyrmions above Room Temperature in a van der Waals Ferromagnet Fe3GaTe2.

2D van der Waals (vdW) ferromagnetic crystals are a promising platform for innovative spintronic devices based on magnetic skyrmions, thanks to their high flexibility and atomic thickness stability. However, room-temperature skyrmion-hosting vdW materials are scarce, which poses a challenge for practical applications. In this study, a chemical vapor transport (CVT) approach is employed to synthesize Fe3GaTe2 crystals and room-temperature Néel skyrmions are observed in Fe3GaTe2 nanoflakes above 58 nm in thickness through in situ Lorentz transmission electron microscopy (L-TEM). Upon an optimized field cooling procedure, zero-field hexagonal skyrmion lattices are successfully generated in nanoflakes with an extended thickness range (30-180 nm). Significantly, these skyrmion lattices remain stable up to 355 K, setting a new record for the highest temperature at which skyrmions can be hosted. The research establishes Fe3GaTe2 as an emerging above-room-temperature skyrmion-hosting vdW material, holding great promise for future spintronics.

Growing crystals and studying structure and electronic properties of Cu2ZnGe(SÑ Se1-x)4 compositions.

Single crystals of Cu2ZnGeSe4 and Cu2ZnGeS4 solid solutions were developed and successfully obtained using the chemical vapor transfer method, with iodine acting as a transporter. The structure, compositional dependences of lattice parameters, pycnometric and X-ray densities and microhardness were determined. The chemical composition determined by the X-ray microanalysis satisfactorily corresponds to the nominal one with a tolerance of ±5 %. The XRD analysis showed that all the obtained compounds and their solid solutions have unit cell described by tetragonal symmetry. The attice parameters were found to be а = 5.342 ± 0.005 Å, с = 10.51 ± 0.01 Å for the Сu2ZnGeS4 compound and а = 5.607 ± 0.005 Å, с = 11.04 ± 0.01 Å for the Cu2ZnGeSe4, respectively. Structural studies confirmed the validity of the Vegard's law in relation to the obtained samples. The pycnometric densities of ∼4.28 g/cm3 for the Cu2ZnGeS4 and ∼5.46 g/cm3 for the Cu2ZnGeSe4 were found to be slightly less than their X-ray densities of ∼4.32 g/cm3 and ∼5.52 g/cm3, respectively. The maximum microhardness of ∼398 kg/mm2 for these solid solutions corresponds to x = 0.60. The melt point of the solid solutions increases from ∼1180 °C for the Сu2ZnGeSe4 up to ∼1400 °C for the Сu2ZnGeS4. Based on X-ray fluorescence analysis and DTA data, the phase diagram of the Cu2ZnGeSe4-Cu2ZnGeS4 system was constructed. Analysis of the obtained diagram indicates its first type according to Rozbom's classification.

[Mechanism of gigantol in transmembrane transport in human lens epithelial cells].

Gigantol is a phenolic component of precious Chinese medicine Dendrobii Caulis, which has many pharmacological activities such as prevent tumor and diabetic cataract. This paper aimed to investigate the molecular mechanism of gigantol in transmembrane transport in human lens epithelial cells(HLECs). Immortalized HLECs were cultured in vitro and inoculated in the laser scanning confocal microscopy(LSCM) medium at 5 000 cells/mL. The fluorescence distribution and intensity of gigantol marked by fluorescence in HLECs were observed by LSCM, and the absorption and distribution of gigantol were expressed as fluorescence intensity. The transmembrane transport process of gigantol in HLECs were monitored. The effects of time, temperature, concentration, transport inhibitors, and different cell lines on the transmembrane absorption and transport of gigantol were compared. HLECs were inoculated on climbing plates of 6-well culture plates, and the ultrastructure of HLECs was detected by atomic force microscopy(AFM) during the transmembrane absorption of non-fluorescent labeled gigantol. The results showed that the transmembrane absorption of gigantol was in time and concentration-dependent manners, which was also able to specifically target HLECs. Energy and carrier transport inhibitors reduced gigantol absorption by HLECs. During transmembrane process of gigantol, the membrane surface of HLECs became rougher and presented different degrees of pits, indicating that the transmembrane transport of gigantol was achieved by active absorption of energy and carrier-mediated endocytosis.

Structural, Surface and Optical Studies of m- and c-Face AlN Crystals Grown by Physical Vapor Transport Method.

Bulk aluminum nitride (AlN) crystals with different polarities were grown by physical vapor transport (PVT). The structural, surface, and optical properties of m-plane and c-plane AlN crystals were comparatively studied by using high-resolution X-ray diffraction (HR-XRD), X-ray photoelectron spectroscopy (XPS), and Raman spectroscopy. Temperature-dependent Raman measurements showed that the Raman shift and the full width at half maximum (FWHM) of the E2 (high) phonon mode of the m-plane AlN crystal were larger than those of the c-plane AlN crystal, which would be correlated with the residual stress and defects in the AlN samples, respectively. Moreover, the phonon lifetime of the Raman-active modes largely decayed and its line width gradually broadened with the increase in temperature. The phonon lifetime of the Raman TO-phonon mode was changed less than that of the LO-phonon mode with temperature in the two crystals. It should be noted that the influence of inhomogeneous impurity phonon scattering on the phonon lifetime and the contribution to the Raman shift came from thermal expansion at a higher temperature. In addition, the trend of stress with increasing 1000/temperature was similar for the two AlN samples. As the temperature increased from 80 K to ~870 K, there was a temperature at which the biaxial stress of the samples transformed from compressive to tensile stress, while their certain temperature was different.

Mechanism of gigantol in transmembrane transport in human lens epithelial cells / 中国中药杂志

Gigantol is a phenolic component of precious Chinese medicine Dendrobii Caulis, which has many pharmacological activities such as prevent tumor and diabetic cataract. This paper aimed to investigate the molecular mechanism of gigantol in transmembrane transport in human lens epithelial cells(HLECs). Immortalized HLECs were cultured in vitro and inoculated in the laser scanning confocal microscopy(LSCM) medium at 5 000 cells/mL. The fluorescence distribution and intensity of gigantol marked by fluorescence in HLECs were observed by LSCM, and the absorption and distribution of gigantol were expressed as fluorescence intensity. The transmembrane transport process of gigantol in HLECs were monitored. The effects of time, temperature, concentration, transport inhibitors, and different cell lines on the transmembrane absorption and transport of gigantol were compared. HLECs were inoculated on climbing plates of 6-well culture plates, and the ultrastructure of HLECs was detected by atomic force microscopy(AFM) during the transmembrane absorption of non-fluorescent labeled gigantol. The results showed that the transmembrane absorption of gigantol was in time and concentration-dependent manners, which was also able to specifically target HLECs. Energy and carrier transport inhibitors reduced gigantol absorption by HLECs. During transmembrane process of gigantol, the membrane surface of HLECs became rougher and presented different degrees of pits, indicating that the transmembrane transport of gigantol was achieved by active absorption of energy and carrier-mediated endocytosis.

Enhanced Optical Response of Zinc-Doped Tin Disulfide Layered Crystals Grown with the Chemical Vapor Transport Method.

Tin disulfide (SnS2) is a promising semiconductor for use in nanoelectronics and optoelectronics. Doping plays an essential role in SnS2 applications, because it can increase the functionality of SnS2 by tuning its original properties. In this study, the effect of zinc (Zn) doping on the photoelectric characteristics of SnS2 crystals was explored. The chemical vapor transport method was adopted to grow pristine and Zn-doped SnS2 crystals. Scanning electron microscopy images indicated that the grown SnS2 crystals were layered materials. The ratio of the normalized photocurrent of the Zn-doped specimen to that of the pristine specimen increased with an increasing illumination frequency, reaching approximately five at 104 Hz. Time-resolved photocurrent measurements revealed that the Zn-doped specimen had shorter rise and fall times and a higher current amplitude than the pristine specimen. The photoresponsivity of the specimens increased with an increasing bias voltage or decreasing laser power. The Zn-doped SnS2 crystals had 7.18 and 3.44 times higher photoresponsivity, respectively, than the pristine crystals at a bias voltage of 20 V and a laser power of 4 × 10-8 W. The experimental results of this study indicate that Zn doping markedly enhances the optical response of SnS2 layered crystals.

Influence of Mn, Fe, Co, and Cu Doping on the Photoelectric Properties of 1T HfS2 Crystals.

Doping plays a vital role in the application of transition-metal dichalcogenides (TMDCs) because it can increase the functionality of TMDCs by tuning their native characteristics. In this study, the influence of Mn, Fe, Co, and Cu doping on the photoelectric properties of HfS2 was investigated. Pristine, Mn-, Fe-, Co-, and Cu-doped HfS2 crystals were grown using the chemical vapor transport method. Scanning electron microscopy images showed that the crystals were layered and transmission electron microscopy, X-ray diffraction, and Raman spectroscopy measurements confirmed that the crystals were in the 1T-phase with a CdI2-like structure. The bandgap of pristine HfS2 obtained from the absorption and photoconductivity spectra was approximately 1.99 eV. As the dopant changed from Mn, Fe, and Co, to Cu, the bandgap gradually increased. The activation energies of the samples were determined using temperature-dependent current-voltage curves. After doping, the activation energy decreased, and the Co-doped HfS2 exhibited the smallest activation energy. Time-resolved photoresponse measurements showed that doping improved the response of HfS2 to light; the Co-doped HfS2 exhibited the best response. The photoresponsivity of HfS2 as a function of the laser power and bias voltage was measured. After doping, the photoresponsivity increased markedly; the Co-doped HfS2 exhibited the highest photoresponsivity. All the experimental results indicated that doping with Mn, Fe, Co, and Cu significantly improved the photoresponsive performance of HfS2, of which Co-doped HfS2 had the best performance.

Gas sensing properties of individual SnO2 nanowires and SnO2 sol-gel nanocomposites.

This work is an investigation of the properties of semiconductor materials based on metal oxides, their catalytic properties, and their application as gas sensors, which were shown to exhibit high sensitivity, stability, and selectivity to target gases. The aim of this work is the comparison of gas sensing properties of tin dioxide in the form of individual nanowires and nanopowders obtained by sol-gel synthesis. This comparison is necessary because the traditional synthesis procedures of small particle, metal oxide materials seem to be approaching their limit. Because of this, there is increasing interest in the fabrication of functional materials based on nanowires, i.e., quasi-one-dimensional objects. In this work, nanocrystalline tin dioxide samples with different morphology were synthesized. The gas-transport method was used for the fabrication of well-faceted wire-like crystals with diameters ranging between 15-100 nm. The sol-gel method allowed us to obtain fragile gels from powders with grain sizes of about 5 nm. By means of X-ray photoelectron spectroscopy (XPS) it was proven that the nanowires contain considerably smaller amounts of hydroxy groups compared to the nanopowders. This leads to a decrease in the parasitic sensitivity of the sensing materials to humidity. In addition, we demonstrated that the nanowires are characterized by a nearly single-crystalline structure, ensuring higher stability of the sensor response due to the unlikelihood of sample recrystallization. The results from the ammonia detection experiments showed that the ratio of the sensor response to the surface area exhibits similar values for both the individual nanowire and nanopowders-based sensor materials.

Limb saving surgery for Ewing's sarcoma of the distal tibia: a case report.

BACKGROUND: Ewing's sarcoma is a primary malignant tumor of bone occurring mostly in childhood. Few effective reconstruction techniques are available after wide resection of Ewing's sarcoma at the distal end of the tibia. Reconstruction after wide resection is especially difficult in children, as it is necessary to consider the growth and activity of the lower limbs. CASE PRESENTATION: A 12-year-old Japanese boy had presented with right lower leg pain at age 8 years. Imaging examination showed a bone tumor accompanied by a large extra-skeletal mass in the distal part of his tibia. The tumor was histologically diagnosed as Ewing's sarcoma. The patient received chemotherapy, followed by wide resection. Reconstruction consisted of a bone transport method involving external fixation of Taylor Spatial Frame. To prevent infection after surgery, the external fixation pin was coated with iodine. One year after surgery, the patient showed poor consolidation of bone, so iliac bone transplantation was performed on the extended bones and docking site of the distal tibia. After 20 months, tibia formation was good. Three years after surgery, there was no evidence of tumor recurrence or metastases; bone fusion was good, and he was able to run. CONCLUSIONS: The bone transport method is an effective surgical method of reconstruction after wide resection of a bone tumor at the distal end of the tibia, if a pin can be inserted into the distal bone fragment. Coating external fixation pins with iodine may prevent postoperative infection.