Isotope dilution analysis of polychlorinated biphenyls (PCBs) in transformer oil and global commercial PCB formulations by high resolution gas chromatography-high resolution mass spectrometry.

Special polychlorinated biphenyls (PCBs) standards (native and isotope labeled) were analyzed by isotope dilution method using HRGC-HRMS. Multiple analysis of special PCBs standards by three different laboratories produced the relative response factors (RRFs) and relative standard deviations (RSDs %) was in the average of 0.979 and 3.86, respectively. Additionally, inter-laboratory analysis of various forms of transformer oil revealed the PCBs concentrations were in the following order; PCBs fortified transformer oil (940-1300 ng/g)>PCB polluted transformer oil (490-680 ng/g)>chemically degraded-transformer oil (480-490 ng/g) and PCBs free oil (ND-17 ng/g). Chemical degradation resulted in an order of magnitude decrease in the PCB concentrations. Specifically, higher chlorinated PCBs degraded into lower chlorinated PCBs. Also, composition of PCBs have been determined in PCB formulations from Japan (Kanechlor), Germany (Clophen), USA (Aroclor), Russia (Sovol) and Poland (Chlorofen). Major PCBs (24-PCB congeners) contributed 54-67%, 55-68%, 16-69%, 71% and 72% in Kanechlor, Clophen, Aroclor, Sovol and Chlorofen, respectively to total PCBs. The homologue pattern of Kanechlor, Aroclor and Clophen in technical fromulation was similar (e.g., Kanechlor-300 resembled to those of Clophen A-30 and Aroclor-1242). Furthermore, congener-specific distributions of major PCBs/dioxin-like PCBs and toxic equivalency quantities (TEQ) were calculated. Based on our tentative assumption calculations, cumulative production of five different technical PCB formulations, WHO-TEQ emission was estimated to be approximately 16.05 tons.

[Safety forms for industrial lubricating oils: a working proposal at the national level]. / Le schede di sicurezza per gli oli lubrificanti industriali: una proposta operativa a livello nazionale.

The health and safety data sheets for lubricating oils currently in use present considerable differences regarding the information they provide. Often, the information is either too generalized or incomplete--particularly on the chemical aspects of oils--and therefore the sheets are inadequate for the prevention and control of the occupational risks. For the purposes of harmonization, a data sheet has been prepared which takes into account the specific features of the products, and particularly the handling of confidential data. The most important oil manufacturers have been consulted, and they have agreed to use the data sheet in order to provide information on their products to the local health authorities. The widespread use of this data sheet should enable an easier comparison of the health and safety data of oils to be made, provide a better understanding of the information received and, consequently, evaluate the risks involved.