Immobilization of laccase of Pycnoporus sanguineus CS43.

Laccase from Pycnoporus sanguineus CS43 was successfully immobilized onto Immobead-150 and Eupergit-C by covalent binding and by entrapment in LentiKats. The highest immobilization was onto Immobead-150 (97.1±1.2%) compared to the other supports, LentiKats (89±1.1%) and Eupergit-C (83.2±1.4%). All three immobilized enzyme systems showed increased thermostability and better mechanical properties than free laccase. Moreover, after 5 cycles of reuse of these systems, 90% of initial laccase activity was retained. Immobead-150 and LentiKats systems exhibited the highest efficiencies in removal of m-cresol under the combined actions of biodegradation and adsorption, while laccase entrapped in LentiKats showed a high ability for degradation of m-cresol within 24h. In addition, the typical Michaelis-Menten enzymatic model effectively described the kinetic profile of m-cresol degradation by the enzyme entrapped in LentiKats. Based on the results obtained in the present study, it can be established that the immobilized biocatalysts developed here possess significant potential for wastewater treatment.

Enzyme adsorption, precipitation and crosslinking of glucose oxidase and laccase on polyaniline nanofibers for highly stable enzymatic biofuel cells.

Enzymatic biofuel cells have many great features as a small power source for medical, environmental and military applications. Both glucose oxidase (GOx) and laccase (LAC) are widely used anode and cathode enzymes for enzymatic biofuel cells, respectively. In this paper, we employed three different approaches to immobilize GOx and LAC on polyaniline nanofibers (PANFs): enzyme adsorption (EA), enzyme adsorption and crosslinking (EAC) and enzyme adsorption, precipitation and crosslinking (EAPC) approaches. The activity of EAPC-LAC was 32 and 25 times higher than that of EA-LAC and EAC-LAC, respectively. The half-life of EAPC-LAC was 53 days, while those of EA-LAC and EAC-LAC were 6 and 21 days, respectively. Similar to LAC, EAPC-GOx also showed higher activity and stability than EA-GOx and EAC-GOx. For the biofuel cell application, EAPC-GOx and EAPC-LAC were applied over the carbon papers to form enzyme anode and cathode, respectively. In order to improve the power density output of enzymatic biofuel cell, 1,4-benzoquinone (BQ) and 2,2'-azino-bis(3-ethylbenzothiazoline-6-sulfonic acid) diammonium salt (ABTS) were introduced as the electron transfer mediators on the enzyme anode and enzyme cathode, respectively. BQ- and ABTS-mediated enzymatic biofuel cells fabricated by EAPC-GOx and EAPC-LAC showed the maximum power density output of 37.4 µW/cm(2), while the power density output of 3.1 µW/cm(2) was shown without mediators. Under room temperature and 4°C for 28 days, enzymatic biofuel cells maintained 54 and 70% of its initial power density, respectively.

Mesosilica-coated ultrafine fibers for highly efficient laccase encapsulation.

In this paper, we present a simple but efficient biomimetic method to encapsulate laccase on mesoporous silica-modified electrospun (ES) ultrafine fibers. Because of the mild immobilization conditions (room temperature, aqueous condition), the encapsulated laccase retained a high activity of 94%. Because of the protection from the silica layer, the laccase worked efficiently at 60 °C and retained a long-term activity in the presence of proteinase K. After recycling for 10 times the laccase still preserved 96% of its original reactivity. More remarkably, the immobilized laccase on fibers could completely recover its activity after thermal denature, while the free laccase permanently lost the activity. We also demonstrated that the laccase on silica-coated fibers exhibited an enhanced decolorization capability of Brilliant Blue KN-R (BBKN-R) as compared to the free laccase, showing its great potential for industrial applications.

Molecular modeling and docking of novel laccase from multiple serotype of Yersinia enterocolitica suggests differential and multiple substrate binding.

Multi-copper oxidases (MCOs) are widely distributed in bacteria, where they are responsible for metal homeostasis, acquisition and oxidation. Using specific primers, yacK coding for MCO was amplified from different serotypes of Yersinia enterocolitica biovar 1A. Homology modeling of the protein followed by docking with five well-known substrates for different MCO's (viz., 2,2'-azino-bis(3-ethylbenzthiazoline-6-sulphonic acid [ABTS], syringaldazine, L-tyrosine, ammonium ferrous sulfate and guaiacol), lignin monomers (Coniferyl alcohol, p-coumaryl alcohol and sinapyl alcohol) and two inhibitors i.e., kojic acid and N-hydroxyglycine was done. The docking gave maximum GoldScore i.e., 91.93 and 72.64 with ammonium ferrous sulfate and ABTS, respectively. Similarly, docking with ICM gave -82.10 and -83.61 docking score, confirming the protein to be true laccase with ferroxidase activity. Further, validation with ammonium ferrous sulfate as substrate gave laccase activity of 0.36Units/L/min. Guaiacol, L-tyrosine, and lignin monomers showed good binding affinity with protein models with GoldScores of 35.89, 41.82, 40.41, 41.12 and 43.10, respectively. The sequence study of all the cloned Yack genes showed serotype specific clade in dendrogram. There was distinct discrimination in the ligand binding affinity of Y. enterocolitica laccase, among strains of same clonal groups, suggesting it as a tool for phylogenetic studies.

Scanning electrochemical microscopy study of laccase within a sol-gel processed silicate film.

The enzyme p-diphenol:dioxygen oxidoreductase (laccase, EC 1.10.3.2) was isolated from Cerrena unicolor fungus and embedded in a sol-gel film obtained by acidic condensation of TMOS. The gel was cast to thin films on glass. The laccase-containing silicate films were inspected by confocal laser scanning microscopy (CLSM), scanning force microscopy (SFM) and scanning electrochemical microscopy (SECM). CLSM images in the reflection mode showed aggregates within the silicate films. SECM images in the substrate-generation/tip-collection mode using 2,2'-azino-bis(3-ethylbenzothiazoline-6-sulfonate) (ABTS) as electron donor for laccase showed that the position of aggregates coincides with increased enzymatic activity within the silicate film. The flux from individual aggregates was detected. SECM images in the redox competition mode confirmed the assignment and could exclude that topographic features observed by CLSM and SFM could be the reason for the image contrast. SFM images showed that the aggregates partially dissolve during prolonged exposure to aqueous buffer. The experimental setup allowed following one individual aggregate over time with all three microscopic techniques which enabled the collection of complementing information on morphology and catalytic activity as well as their development over time.

Influence of nutrients on enhancing laccase production by Botryosphaeria rhodina MAMB-05

The physiological requirements needed to enhance the production of laccases by the ascomycete Botryosphaeria rhodina MAMB-05 in submerged cultivation were examined under non-induced and induced (veratryl alcohol, VA) conditions. Under non-induced conditions (-VA), the initial pH, C:N ratio, and inorganic N source did not influence laccase production, in contrast to Tween 80, soybean oil, and copper, which significantly increased laccase production, and proline and urea, which suppressed laccase formation. In addition, Tween 60 could serve as the sole carbon source for the production of these enzymes. Under VA-induced conditions of fungal growth, factors such as inoculum type, time-point of addition of inducer, initial pH, C:N ratio, and type of N source, influenced the production of laccases; however, unlike the non-induced conditions, proline and urea did not act as suppressors. Each of these physiological conditions exerted different effects on biomass production. The nutritional conditions examined for B. rhodina MAMB-05 are discussed in relation to their influence on fungal growth and laccase production (AU)

No disponible

Electrochemical catalysis and thermal stability characterization of laccase-carbon nanotubes-ionic liquid nanocomposite modified graphite electrode.

The hydrophobic carbon nanotubes-ionic liquid (CNTs-IL) gel forms a stable modified film on hydrophobic graphite electrode surface. Laccase immobilized on the CNTs-IL gel film modified electrode shows good thermal stability and enhanced electrochemical catalytic ability. The optimal bioactivity occurs with increasing temperature and this optimum is 20 degrees C higher in comparison to free laccase. The improvement of laccase thermal stability may be due to the microenvironment of hydrophobic CNTs-IL gel on graphite electrode surface. On the other hand, the sensitive detection of oxygen has been achieved due to the feasibility of oxygen reduction by both of laccase and nanocomposite of CNTs-IL gel. Furthermore, the laccase hybrid nanocomposite also shows the fast electrochemical response and high sensitivity to the inhibitors of halide ions with the approximate IC50 of 0.01, 4.2 and 87.5 mM for the fluoride, chloride and bromide ions, respectively. It implies the feasibility of laccase modified electrode as an inhibition biosensor to detect the modulators of laccase.

Crystal structures of E. coli laccase CueO at different copper concentrations.

CueO protein is a hypothetical bacterial laccase and a good laccase candidate for large scale industrial application. Four CueO crystal structures were determined at different copper concentrations. Low copper occupancy in apo-CueO and slow copper reconstitution process in CueO with exogenous copper were demonstrated. These observations well explain the copper dependence of CueO oxidase activity. Structural comparison between CueO and other three fungal laccase proteins indicates that Glu106 in CueO constitutes the primary counter-work for reconstitution of the trinuclear copper site. Mutation of Glu106 to a Phe enhanced CueO oxidation activity and supported this hypothesis. In addition, an extra alpha-helix from Leu351 to Gly378 covers substrate biding pocket of CueO and might compromises the electron transfer from substrate to type I copper.

A crystallographic and spectroscopic study on the effect of X-ray radiation on the crystal structure of Melanocarpus albomyces laccase.

Laccases (p-diphenol dioxygen oxidoreductases) belong to the family of blue multicopper oxidases, which catalyse the four-electron reduction of dioxygen to water concomitantly through the oxidation of substrate molecules. Blue multicopper oxidases have four coppers, a copper (T1) forming a mononuclear site and a cluster of three coppers (T2, T3, and T3') forming a trinuclear site. Because X-rays are known to liberate electrons during data collection and may thus affect the oxidation state of metals, we have investigated the effect of X-ray radiation upon the crystal structure of a recombinant laccase from Melanocarpus albomyces through the use of crystallography and crystal absorption spectroscopy. Two data sets with different strategies, a low and a high-dose data set, were collected at synchrotron. We have observed earlier that the trinuclear site had an elongated electron density amidst coppers, suggesting dioxygen binding. The low-dose synchrotron structure showed similar elongated electron density, but the high-dose X-ray radiation removed the bulk of this density. Therefore, X-ray radiation could alter the active site of laccase from M. albomyces. Absorption spectra of the crystals (320, 420, and 590nm) during X-ray radiation were measured at a home laboratory. Spectra clearly showed how that the band at 590nm had vanished, resulting from the T1 copper being reduced, during the long X-ray measurements. The crystal colour changed from blue to colourless. Absorptions at 320 and 420nm seemed to be rather permanent. The absorption at 320nm is due to the T3 coppers and it is proposed that absorption at 420nm is due to the T2 copper when dioxygen or a reaction intermediate is close to this copper.