Rapid and green detection of manganese in electrolytes by ultraviolet-visible spectrometry to control pollutant discharge.

Controlling the manganese (Mn2+) concentration is important to product quality in the electrolytic manganese industry. Conventional methods for detecting Mn2+ are complex and reagent-consuming, which makes them slow and polluting. It is of great significance to develop a new fast and environmentally friendly method to quantify Mn2+ in electrolyte. The characteristic ultraviolet-visible (UV-vis) absorbance at 401 nm of Mn2+ will vary linearly with the Mn2+ concentration after data correction. Adjusting the pH, calibrating the spectral bandwidth (SBW) and optical path length (OPL), and subtracting the interference from coexisting substances by linear interpolation improve the measuring accuracy. Mn2+ concentration can be determined by direct fast UV-vis absorbance measurement at characteristic peaks without using harmful reagents which facilitates such measurement to be applicated as on-line detection method for electrolytic manganese industry. The method developed in this study will help achieve the goal of improving the detection speed while cutting back on pollutant discharge from concentration analysis process in electrolytic manganese industry.

Development of a certified reference material (NMIJ CRM 7531-a) for the determination of trace cadmium and other elements in brown rice flour.

A certified reference material (CRM) for trace cadmium and other elements in brown rice flour was developed at the National Metrology Institute of Japan (NMIJ). The CRM was provided as a dry powder after drying and frozen pulverization of fresh brown rice obtained from a Japanese domestic market. Characterization of the property value for each element was carried out exclusively by NMIJ with at least two independent analytical methods, including inductively coupled plasma mass spectrometry (ICP-MS), ICP high-resolution mass spectrometry, isotope-dilution ICP-MS, ICP optical emission spectrometry, and graphite-furnace atomic-absorption spectrometry. Property values were provided for six elements (Mn, Fe, Cu, Zn, As, and Cd). The concentration range of the property values was from 0.280 mg kg(-1) of As to 31.8 mg kg(-1) of Zn. The combined relative standard uncertainties of the property values were estimated by considering the uncertainties of the homogeneity, characterization, difference among analytical methods, dry-mass correction factor, and calibration standard. The range of the relative combined standard uncertainties was from 1.1% of Zn to 1.6% of As.

Arsenic-enriched groundwaters of India, Bangladesh and Taiwan--comparison of hydrochemical characteristics and mobility constraints.

Arsenic (As) enrichment in groundwater has become a major global environmental disaster. Groundwater samples were collected from 64 sites located in the districts of 24-Parganas (S), and Nadia in West Bengal, India (Bhagirathi sub-basin), and 51 sites located in the districts of Comilla, Noakhali, Magura, Brahman baria, Laxmipur, Munshiganj, Faridpur and Jhenaida in Bangladesh (Padma-Meghna sub-basin). Groundwater samples were also collected from two As-affected areas (Chianan and Lanyang plains) of Taiwan (n = 26). The concentrations of major solutes in groundwater of the Padma-Meghna sub-basin are more variable than the Bhagirathi sub-basin, suggesting variations in the depositional and hydrological settings. Arsenic concentrations in groundwaters of the studied areas showed large variations, with mean As concentrations of 125 µg/L (range: 0.20 to 1,301 µg/L) in Bhagirathi sub-basin, 145 µg/L (range: 0.20 to 891 µg/L) in Padma-Meghna sub-basin, 209 µg/L (range: 1.3 to 575 µg/L) in Chianan plain, and 102 µg/L (range: 2.5 to 348 µg/L) in Lanyang plain groundwater. The concentrations of Fe, and Mn are also highly variable, and are mostly above the WHO-recommended guideline values and local (Indian and Bangladeshi) drinking water standard. Piper plot shows that groundwaters of both Bhagirathi and Padma-Meghna sub-basins are of Ca-HCO(3) type. The Chianan plain groundwaters are of Na-Cl type, suggesting seawater intrusion, whereas Lanyang plain groundwaters are mostly of Na-HCO(3) type. The study shows that reductive dissolution of Fe(III)-oxyhydroxides is the dominant geochemical process releasing As from sediment to groundwater in all studied areas.

State-of-the-science review: Does manganese exposure during welding pose a neurological risk?

Recent studies report that exposure to manganese (Mn), an essential component of welding electrodes and some steels, results in neurotoxicity and/or Parkinson's disease (PD) in welders. This "state-of-the-science" review presents a critical analysis of the published studies that were conducted on a variety of Mn-exposed occupational cohorts during the last 100 yr, as well as the regulatory history of Mn and welding fumes. Welders often perform a variety of different tasks with varying degrees of duration and ventilation, and hence, to accurately assess Mn exposures that occurred in occupational settings, some specific information on the historical work patterns of welders is desirable. This review includes a discussion of the types of exposures that occur during the welding process--for which limited information relating airborne Mn levels with specific welding activities exists--and the human health studies evaluating neurological effects in welders and other Mn-exposed cohorts, including miners, millers, and battery workers. Findings and implications of studies specifically conducted to evaluate neurobehavioral effects and the prevalence of PD in welders are also discussed. Existing exposure data indicate that, in general, Mn exposures in welders are less than those associated with the reports of clinical neurotoxicity (e.g., "manganism") in miners and smelter workers. It was also found that although manganism was observed in highly exposed workers, the scant exposure-response data available for welders do not support a conclusion that welding is associated with clinical neurotoxicity. The available data might support the development of reasonable "worst-case" exposure estimates for most welding activities, and suggest that exposure simulation studies would significantly refine such estimates. Our review ends with a discussion of the data gaps and areas for future research.

Standardization and decay data determinations of 125I, 54Mn and 203Hg.

The absolute 4pi-betagamma coincidence counting has been used to measure the activity concentrations of 54Mn and 203Hg, and the Sum-Peak method was used for 125I. 54Mn and 125I radionuclides have been part of international key-comparisons coordinated by the Bureau International des Poids et Measures (BIPM) in 2003/2004, while 203Hg is part of the traceability programme of the National Laboratory for Ionizing Radiation Metrology (LNMRI)/Brazil. Three different detectors were used for the Sum-Peak method: 3''x3'' NaI(Tl) and 5''x5'' well NaI(Tl) scintillation detectors and a planar germanium detector. Direct measurements were made of the photon emission probabilities of the 35.5-, 834.8- and 279.2-keV gamma-rays of 125I, 54Mn and 203Hg to give values of (0.0667+/-0.0014), (0.9997+/-0.0055) and (0.8161+/-0.0005), respectively. The half-lives of 203Hg and 54Mn were also determined by means of a 4pigamma ionization chamber (203Hg) and by the reference source method using a HPGe detector (54Mn) to give values of (46.639+/-0.023) days and (312.1+/-0.9) days, respectively.

Standardisation of 54Mn and 65Zn using a software coincidence counting system.

The activities of 54Mn and 65Zn have been determined by 4pi(PC)-gamma coincidence counting, with efficiency variation performed by the conventional method of altering the self-absorption in the sources as well as by the computer discrimination method. The standardisation of 65Zn presents some complications requiring optimisation of the gamma-ray energy window settings to achieve a linear efficiency-extrapolation curve. Determination of these optimal settings by the conventional coincidence method is a tedious task. These difficulties have been reduced by the utilisation of a software coincidence counting system that records time and amplitude information of individual pulses from coincidence measurements, where the coincidence parameters are set after the data collection process has completed, facilitating multiple data evaluations on a single data set. The optimal gamma-ray energy window settings for the 65Zn standardisation were derived from the results of the 54Mn standardisation, as well as from studies of the 65Zn data itself. The setting of the PC channel thresholds for K and both (K+L) electrons is also discussed. The results are compared with those attained using conventional coincidence counting.

[Nutritive value of daily food rations reproduced in different regions of the country. IV. Copper, zinc and manganese levels]. / Wartosc odzywcza calodziennych racji pokarmowych odtwarzanych w kilku regionach kraju. CZ. IV. Zawatosc miedzi, cynku, manganu.

The content of copper, zinc and manganese in daily diets reconstructed in the laboratory in 1988 on the basis of data on the yearly food consumption in 1986 of two social groups (manual and mental workers) with medium income was determined. The diets were prepared for four regions of the country (Warszawa, Lublin, Poznan, Wroclaw). It was found out that the content of copper and zinc in the diets in 1986 and the realisation of recommended dietary allowances for these minerals were lower than in 1973, 1980 and 1981. The degree of realization of the recommended intake of zinc and copper in diets from 1986 was on average 67% and 45% respectively. The content of manganese in the diets was in the range of recommendation. The content of microminerals in the diets was usually similar in the all studied regions of the country.

[Effect of simultaneous exposure to fluorine and manganese on health status of workers]. / Wplyw jednoczesnego narazenia na fluor i mangan na stan zdrowia narazonych pracowników.

The effect of fluorine and manganese on the health of workers continually exposed to these elements was studied. The concentration of the chemicals did not significantly exceed maximum allowable concentrations only during three hours of work daily. Thirty-six workers directly exposed to fluorine and manganese were examined and compared with the controls. The authors demonstrated that exceeding permissible norms did not cause evident intoxication symptoms even though working in exposure had lasted for many years. However, some changes in the activity of liver indicatory enzymes may be one of the first symptoms of this organ's damage. Frequently occurring ++periodontosis and leukoplakia of the mucous membrane needed careful stomatological prophylaxis .

Upper limits of zinc, copper and manganese in infant formulas.

Upper limits are proposed for zinc, copper and manganese in infant formulas. At these limits intakes would be lower than would intakes shown to be associated with toxicity, but the upper limits of an entirely safe range of intake remain uncertain. The proposed limits provide a considerable margin beyond normal nutritional requirements, and it is not recommended that formulas should typically contain these quantities. The proposed upper limits (per 100 kcal) are 1.5 mg of zinc, 200 micrograms of copper and 50 micrograms of manganese.