Microstructures and mechanical properties of Co-29Cr-6Mo alloy fabricated by selective laser melting process for dental applications.

The selective laser melting (SLM) process was applied to a Co-29Cr-6Mo alloy, and its microstructure, mechanical properties, and metal elution were investigated to determine whether the fabrication process is suitable for dental applications. The microstructure was evaluated using scanning electron microscopy with energy-dispersed X-ray spectroscopy (SEM-EDS), X-ray diffractometry (XRD), and electron back-scattered diffraction pattern analysis. The mechanical properties were evaluated using a tensile test. Dense builds were obtained when the input energy of the laser scan was higher than 400 J mm⁻³, whereas porous builds were formed when the input energy was lower than 150 J mm⁻³. The microstructure obtained was unique with fine cellular dendrites in the elongated grains parallel to the building direction. The γ phase was dominant in the build and its preferential <001> orientation was confirmed along the building direction, which was clearly observed for the builds fabricated at lower input energy. Although the mechanical anisotropy was confirmed in the SLM builds due to the unique microstructure, the yield strength, UTS, and elongation were higher than those of the as-cast alloy and satisfied the type 5 criteria in ISO22764. Metal elution from the SLM build was smaller than that of the as-cast alloy, and thus, the SLM process for the Co-29Cr-6Mo alloy is a promising candidate for fabricating dental devices.

Effects of radiotherapy on mandibular reconstruction plates.

The radiation dose in the vicinity of metal mandibular implants was measured using lithium fluoride (TLD-100) thermoluminescent dosimeters. Dosimeters were positioned in contact with Vitallium and stainless steel (AO) reconstruction plates. Simple transmission was measured with a solid state detector removed from the implant at a depth of 2.5 cm in a polystyrene phantom. The measurements were made for a 6 mV photon beam from a linear accelerator. At points in front of, but in contact with the metal implants, the dose was greater by 23 percent for Vitallium and 17 percent for stainless steel than that with no implant. At contact behind the implant, the dose was reduced considerably: 14 percent for Vitallium and 13 percent for stainless steel. At remote points behind the implant, the dose was reduced due to attenuation.