Assessment of indoor bioaerosol exposure using direct-reading versus traditional methods-potential application to home health care.

Home healthcare workers (HHCWs) can be occupationally exposed to bioaerosols in their clients' homes. However, choosing the appropriate method to measure bioaerosol exposures remains a challenge. Therefore, a systematic comparison of existing measurement approaches is essential. Bioaerosol measurements with a real-time, fluorescence-based Wideband Integrated Bioaerosol Sensor (WIBS) were compared to measurements with four traditional off-line methods (TOLMs). The TOLMS included optical microscopic counting of spore trap samples, microbial cultivation of impactor samples, qPCR, and next-generation sequencing (NGS) of filter samples. Measurements were conducted in an occupied apartment simulating the environments that HHCWs could encounter in their patients' homes. Descriptive statistics and Spearman's correlation test were computed to compare the real-time measurement with those of each TOLM. The results showed that the geometric mean number concentrations of the total fluorescent aerosol particles (TFAPs) detected with the WIBS were several orders of magnitude higher than those of total fungi or bacteria measured with the TOLMs. Among the TOLMs, concentrations obtained with qPCR and NGS were the closest to the WIBS detections. Correlations between the results obtained with the WIBS and TOLMs were not consistent. No correlation was found between the concentrations of fungi detected using microscopic counting and any of the WIBS fluorescent aerosol particle (FAP) types, either indoors or outdoors. In contrast, the total concentrations detected with microbial cultivation correlated with the WIBS TFAP results, both indoors and outdoors. Outdoors, the total concentration of culturable bacteria correlated with FAP-type AC. In addition, fungal and bacterial concentrations obtained with qPCR correlated with FAP types AB and AC. For a continuous, high-time resolution but broad scope, the real-time WIBS could be considered, whereas a TOLM would be the best choice for specific and more accurate microbial characterization. HHCWs' activities tend to re-aerosolize bioaerosols causing wide temporal variation in bioparticle concentrations. Thus, the advantage of using the real-time instrument is to capture those variations. This study lays a foundation for future exposure assessment studies targeting HHCWs.

Assessing residential indoor and outdoor bioaerosol characteristics using the ultraviolet light-induced fluorescence-based wideband integrated bioaerosol sensor.

We assessed and compared indoor and outdoor residential aerosol particles in a third-floor apartment from August through September 2020. The measurements were conducted using a direct-reading ultraviolet light-induced fluorescence (UV-LIF) wideband integrated bioaerosol spectrometer (WIBS). It measures individual particle light scattering and fluorescence from which particle properties can be derived. The number concentrations of total aerosol particles (TAP) and total fluorescent aerosol particles (TFAP) were significantly higher indoors. Daily and hourly TFAP mean concentrations followed the same trends as the TAP, both indoors and outdoors. The daily mean rank of the TFAP fraction (TFAP/TAP) was significantly higher indoors (23%) than outdoors (19%). Particles representing bacteria dominated indoors while particles representing fungi and pollen dominated outdoors. The mean volume-weighted median diameters for TFAP were 1.67 µm indoors and 2.09 µm outdoors. Higher TFAP fraction indoors was likely due to occupants' activities that generated or resuspended particles. This study contributes to understanding the characteristics of residential aerosol particles in situations when occupants spend most of their time indoors. Based on our findings, a large portion of all indoor aerosol particles could be biological (15-20%) and of respirable particle size (≥95%). Using a novel direct reading UV-LIF-based sensor can help quickly assess aerosol exposures relevant to human health.

Physical and Chemical Properties of Cloud Droplet Residuals and Aerosol Particles During the Arctic Ocean 2018 Expedition.

Detailed knowledge of the physical and chemical properties and sources of particles that form clouds is especially important in pristine areas like the Arctic, where particle concentrations are often low and observations are sparse. Here, we present in situ cloud and aerosol measurements from the central Arctic Ocean in August-September 2018 combined with air parcel source analysis. We provide direct experimental evidence that Aitken mode particles (particles with diameters ≲70 nm) significantly contribute to cloud condensation nuclei (CCN) or cloud droplet residuals, especially after the freeze-up of the sea ice in the transition toward fall. These Aitken mode particles were associated with air that spent more time over the pack ice, while size distributions dominated by accumulation mode particles (particles with diameters ≳70 nm) showed a stronger contribution of oceanic air and slightly different source regions. This was accompanied by changes in the average chemical composition of the accumulation mode aerosol with an increased relative contribution of organic material toward fall. Addition of aerosol mass due to aqueous-phase chemistry during in-cloud processing was probably small over the pack ice given the fact that we observed very similar particle size distributions in both the whole-air and cloud droplet residual data. These aerosol-cloud interaction observations provide valuable insight into the origin and physical and chemical properties of CCN over the pristine central Arctic Ocean.

Upper tropospheric water vapour and its interaction with cirrus clouds as seen from IAGOS long-term routine in situ observations.

IAGOS (In-service Aircraft for a Global Observing System) performs long-term routine in situ observations of atmospheric chemical composition (O3, CO, NOx, NOy, CO2, CH4), water vapour, aerosols, clouds, and temperature on a global scale by operating compact instruments on board of passenger aircraft. The unique characteristics of the IAGOS data set originate from the global scale sampling on air traffic routes with similar instrumentation such that the observations are truly comparable and well suited for atmospheric research on a statistical basis. Here, we present the analysis of 15 months of simultaneous observations of relative humidity with respect to ice (RHice) and ice crystal number concentration in cirrus (Nice) from July 2014 to October 2015. The joint data set of 360 hours of RHice-Nice observations in the global upper troposphere and tropopause region is analysed with respect to the in-cloud distribution of RHice and related cirrus properties. The majority of the observed cirrus is thin with Nice < 0.1 cm-3. The respective fractions of all cloud observations range from 90% over the mid-latitude North Atlantic Ocean and the Eurasian Continent to 67% over the subtropical and tropical Pacific Ocean. The in-cloud RHice distributions do not depend on the geographical region of sampling. Types of cirrus origin (in situ origin, liquid origin) are inferred for different Nice regimes and geographical regions. Most importantly, we found that in-cloud RHice shows a strong correlation to Nice with slightly supersaturated dynamic equilibrium RHice associated with higher Nice values in stronger updrafts.

Microbial aerosol liberation from soiled textiles isolated during routine residuals handling in a modern health care setting.

BACKGROUND: A wide variety of specialty textiles are used in health care settings for bedding, clothing, and privacy. The ability of textiles to host or otherwise sequester microbes has been well documented; however, their reciprocal potential for liberating airborne bacteria remains poorly characterized. In response, a multi-season survey of bacterial bioaerosols was conducted in the origin and terminus of residual paths which are specifically designed to isolate soiled hospital textiles as they are moved to laundering. This survey used conventional optical particle counting which incorporated multi-channel fluorescence in conjunction with molecular phylogenetic analyses to characterize the bioaerosols liberated during soiled textile storage--immediately before and after the occupation of a modern hospital. Although outfitted with a HEPA filtration system, the number of airborne particles presenting fluorescing optical signatures consistent with airborne bacteria and fungi significantly increased in textile holding rooms soon after the hospital's commissioning, even though these isolated residual areas rarely host personnel. The bioaerosol liberated during textile storage was characterized using Illumina MiSeq sequencing of bacterial 16S ribosomal ribonucleic acid (rRNA) genes. Gene copies recovered by quantitative PCR from aerosol collected in co-located impingers were consistent with fluorescence gated optical particle counting. RESULTS: The relative abundance patterns of proximal bacterial bioaerosol were such that the air in the origin and terminus of textile storage rooms could not be differentiated once the hospital began processing soiled linens. Genes from microbes typically associating with human skin, feces, and hair--Staphylococcus, Propionibacteria, Corynebacteria, Lactobacillus, and Streptococcus spp.--dominated the aerosol abundance profiles in textile holding rooms, which were generally far less diverse than communities recovered from surfaces in patient rooms. CONCLUSIONS: These results suggest that aerosol partitioning from the routine handling of soiled textiles can contribute to airborne exposures in the health care environment.

Characterizing elemental, equivalent black, and refractory black carbon aerosol particles: a review of techniques, their limitations and uncertainties.

Elemental-, equivalent black- and refractory black-carbon are terms that have been defined in order to dissect the more general term, black carbon, into its component parts related to its specific chemical and optical properties and its impact on climate and health. Recent publications have attempted to clarify the meaning of these terms with respect to their environmental impact, particularly on climate. Here, we focus on the measurement aspects, reviewing the most commonly implemented techniques for the direct and indirect derivation of black carbon properties, their strengths, limitations, and uncertainties, and provide a non-exhaustive bibliography where the reader can find more detailed information. This review paper is designed as a guide for those wishing to learn about the current state of black carbon measurement instrumentation, how calibration is carried out, when one instrument may have the advantage over another, and where new techniques are needed to fill important knowledge gaps.

Characterizing the aging of biomass burning organic aerosol by use of mixing ratios: a meta-analysis of four regions.

Characteristic organic aerosol (OA) emission ratios (ERs) and normalized excess mixing ratios (NEMRs) for biomass burning (BB) events have been calculated from ambient measurements recorded during four field campaigns. Normalized OA mass concentrations measured using Aerodyne Research Inc. quadrupole aerosol mass spectrometers (Q-AMS) reveal a systematic variation in average values between different geographical regions. For each region, a consistent, characteristic ratio is seemingly established when measurements are collated from plumes of all ages and origins. However, there is evidence of strong regional and local-scale variability between separate measurement periods throughout the tropical, subtropical, and boreal environments studied. ERs close to source typically exceed NEMRs in the far-field, despite apparent compositional change and increasing oxidation with age. The absence of any significant downwind mass enhancement suggests no regional net source of secondary organic aerosol (SOA) from atmospheric aging of BB sources, in contrast with the substantial levels of net SOA formation associated with urban sources. A consistent trend of moderately reduced ΔOA/ΔCO ratios with aging indicates a small net loss of OA, likely as a result of the evaporation of organic material from initial fire emissions. Variability in ERs close to source is shown to substantially exceed the magnitude of any changes between fresh and aged OA, emphasizing the importance of fuel and combustion conditions in determining OA loadings from biomass burning.

The role of a peri-urban forest on air quality improvement in the Mexico City megalopolis.

Air quality improvement by a forested, peri-urban national park was quantified by combining the Urban Forest Effects (UFORE) and the Weather Research and Forecasting coupled with Chemistry (WRF-Chem) models. We estimated the ecosystem-level annual pollution removal function of the park's trees, shrub and grasses using pollution concentration data for carbon monoxide (CO), ozone (O(3)), and particulate matter less than 10 microns in diameter (PM(10)), modeled meteorological and pollution variables, and measured forest structure data. Ecosystem-level O(3) and CO removal and formation were also analyzed for a representative month. Total annual air quality improvement of the park's vegetation was approximately 0.02% for CO, 1% for O(3,) and 2% for PM(10), of the annual concentrations for these three pollutants. Results can be used to understand the air quality regulation ecosystem services of peri-urban forests and regional dynamics of air pollution emissions from major urban areas.

Relations between PM10 composition and cell toxicity: a multivariate and graphical approach.

Previous studies have used particle mass and size as metrics to link airborne particles with deleterious health effects. Recent evidence suggests that particle composition can play an important role in PM-toxicity; however, little is known about the specific participation of components (individually or acting in groups) present in such a complex mixture that accounts for toxicity. This work explores relationships among PM(10) components in order to identify their covariant structure and how they vary in three sites in Mexico City. Relationships between PM(10) with cell toxicity and geographical location were also explored. PM(10) was analyzed for elemental composition, organic and elemental carbon, endotoxins and the induction of inhibition of cell proliferation, IL-6, TNFalpha and p53. PM(10) variables were evaluated with principal component analysis and one-way ANOVA. The inhibition of cell proliferation, IL-6 and TNFalpha were evaluated with factorial ANOVA and p53 with the Welch test. The results indicate that there is heterogeneity in particle mass, composition and toxicity in samples collected at different sites. Multivariate analysis identified three major groups: (1) S/K/Ca/Ti/Mn/Fe/Zn/Pb; (2) Cl/Cr/Ni/Cu; and (3) endotoxins, organic and elemental carbon. Groups 1 and 3 showed significant differences among sites. Factorial ANOVA modeling indicated that cell proliferation was affected by PM concentration; TNFalpha and IL-6 by the interaction of concentration and site, and p53 was different by site. Radial plots suggest the existence of complex interactions between components, resulting in characteristic patterns of toxicity by site. We conclude that interactions of PM(10) components determine specific cellular outcomes.

Evidence for the predominance of mid-tropospheric aerosols as subtropical anvil cloud nuclei.

NASA's recent Cirrus Regional Study of Tropical Anvils and Cirrus Layers-Florida Area Cirrus Experiment focused on anvil cirrus clouds, an important but poorly understood element of our climate system. The data obtained included the first comprehensive measurements of aerosols and cloud particles throughout the atmospheric column during the evolution of multiple deep convective storm systems. Coupling these new measurements with detailed cloud simulations that resolve the size distributions of aerosols and cloud particles, we found several lines of evidence indicating that most anvil crystals form on mid-tropospheric rather than boundary-layer aerosols. This result defies conventional wisdom and suggests that distant pollution sources may have a greater effect on anvil clouds than do local sources.