Effect of the type of soil on dimethyl phthalate degradation by ozone.

In the present study, ozone was applied for the removal of dimethyl phthalate (DMP) from soil. The effect of several experimental parameters was investigated considering, the initial DMP concentration, ozone flow, the type of soil (sand and agricultural soil) and the presence of α-FeOOH as a potential catalyst in the reaction system with sand. The elimination of DMP using ozone is significantly affected by the type of soil. In the case of sand, conventional ozonation was capable to degrade 74% of the initial DMP concentration (0.5 mg g-1) after 8 h of the reaction, however, the mineralization degree was below 50%. Under the same experimental conditions, the complete elimination of DMP was achieved when calcined agricultural soil was present reaching a 70% of mineralization. The presence of metal oxides in calcined agricultural soil combined with ozone produced oxidants species which were responsible of incrementing the mineralization degree (around 20% in comparison with the sand). The toxicity tests on lettuce seed demonstrated lower toxicity of DMP byproducts after ozonation. The DMP high removal efficiencies and the lower toxicity of generated byproducts in soil prove the applicability of ozone treatment for soil remediation.

Data that support the structural, chemical and morphological characterization and its influence on the electrochemical performance of stabilized PdxPt1-x alloys as electrode materials for methanol oxidation in alkaline medium.

Structural, compositional, morphological and electrochemical characterization are important to determinate the influence of platinum in the methanol oxidation in alkaline media. These data and analysis support the research article catalytic performance of alloyed PtxPd1-x nanostructures supported on Vulcan XC-72R for the methanol oxidation in alkaline medium [1]. The data here presented included changes in the chemical composition, structure and microstructure. Also, complement data of cyclic voltammograms during activation in alkaline media as well as in presence of 1 M CH3OH to observe CO tolerance and Electrochemical Impedance Spectroscopy measurements at two different overpotentials (0.2 and 0.3 mV) on the onset potential for methanol electro-oxidation are published in this paper. The data can be used as a reference to determinate the effect of added different amounts of Pd to Pt/C catalysts, using an organometallic compounds method and octylamine as stabilizer. The data provided in this article have not been previously published and are available to enable critical or extended analyses.

Dataset of the synthesis parameters to deposit YSZ on stainless steel AISI 316L by sputtering technique.

The data presented in this article are related to the research previously published "improvement of adhesion and barrier properties of biomedical stainless steel by deposition of YSZ coatings using RF magnetron sputtering". It contains the structural, morphological, compositional and electrochemical characterization of bare AISI 316L substrate which was used as a substrate to coat with yttria-stabilized zirconia (YSZ). The chemical composition and topography analyses from X-ray photoelectron spectroscopy (XPS), Auger electron spectroscopy (AES) and micrographs from atomic force microscopy (AFM) as well as the roughness value of the YSZ-sputtered coating on AISI 316L substrates are presented as complementary data of the article.

Experimental data in support of characterization of the CePO4 dispersion into transparent PMMA/PU IPNs by the sequential route.

This article is focused on the complementary data referring to the article "Dispersion of upconverting nanostructures of CePO4 using rod and semi-spherical morphologies into transparent PMMA/PU IPNs by the sequential route". It contains the XPS data of CePO4, photographs and DSC thermograms of transparent PMMA/PU IPNs as well as with CePO4 dispersed in different wt.%, Confocal laser scanning micrographs, transmission electron microscopy (TEM), optical images of surface, and visual inspection (photographs) before and after aging of hybrid materials.