RESUMEN
A bilateral comparison to determine the activity concentration of the same 125I solution was organized. As electron-capture radionuclide with a rather high atomic number, 125I must be regarded as difficult to measure. The situation is partly exacerbated by the fact that some established standardization methods, like photon-photon coincidence counting, can no longer be applied due to the unavailability of appropriate equipment and expertise. One aim of this work is to compare modern liquid scintillation counting methods for the standardization of 125I. Both participating metrology institutes have used their custom-built triple-to-double-coincidence ratio (TDCR) counters and the determined activity concentrations are in excellent agreement even though the ways to analyze the data and to compute counting efficiencies were widely independent. The results also agree with the outcome of 4π-γ counting that was carried out at LNHB. In both laboratories, the measurements were complemented by measurements with several secondary standardization methods which even allow to establish a link to the CCRI(II)-K2.I-125(2) comparison started in 2004. A good agreement between the TDCR results and the key comparison reference value of the 2004/2005 comparison was obtained.
RESUMEN
The Bureau International des Poids et Mesures (BIPM) is developing a new transfer instrument to extend its centralized services for assessing the international equivalence of radioactive standards to new radionuclides. A liquid scintillation counter using the triple/double coincidence ratio method is being studied and tested in the CCRI(II)-P1.Co-60 pilot study. The pilot study, involving 13 participating laboratories with primary calibration capabilities, validated the approach against the original international reference system based on ionization chambers, which has been in operation since 1976. The results are in agreement and an accuracy suitable for purpose, below 5×10-4, is achieved. The pilot study also reveals an issue when impurities emitting low-energy electrons are present in the standard solution, which have a different impact on liquid scintillation counting compared to other primary measurement methods.
RESUMEN
A workshop was held from 28 February to 2 March 2006 at the National Institute of Standards and Technology (NIST) to evaluate the needs for new directions for complex matrix reference materials certified for radionuclide content, interlaboratory comparisons and performance evaluation (PE) programs. The workshop identified new radioanalytical metrology thrust areas needed for environmental, radiobioassay, emergency consequence management, and nuclear forensics, attribution, nonproliferation, and safeguards.
RESUMEN
Selenium 79 is a beta emitter produced from (235)U fission and is one of the long half-life radionuclides of interest in nuclear waste disposal problematic because of its potential migration capacity to the surface environment. Measurement of (79)Se is particularly difficult due to its low activity in waste matrices (about 10(-3)Bqg(-1)). A radiochemical procedure based on ion exchange separations was already described in a previous paper. This work presents different applications of the radiochemical separation to waste samples and an improvement of this procedure, including a selective extraction of selenium as diethylselenium in an organic solvent followed by a re-extraction in aqueous medium. This additional step allows the decontamination factor to be increased with the aim of counting (79)Se by liquid scintillation counting.
RESUMEN
Selenium (Se) 79 is a beta emitter produced from (235)U fission thus occurring as one of the fission products found in nuclear reactors. Due to its long half life (about 10(5) years), (79)Se is one of the radionuclides of interest for the performance of assessment studies of waste storage or disposal. Thus, the National Radioactive Waste Management Agency (Andra, France) requests its monitoring in wastes packages before their disposal in specific sites. Measurement of (79)Se is difficult owing to its trace level concentration and its low activity in nuclear wastes. A radiochemical procedure has to be carried out in order to separate selenium from the matrix and to concentrate it before the measurement with a mass spectrometric or a nuclear technique. The beginning of the development is presented in this paper. The optimised protocol firstly developed in view of an ICP-MS measurement, includes five steps based on microwave digestion, evaporation and separations on ion exchange resins. It was tested first on synthetic solutions and was optimised in order to be applicable to a large number of sample types. The recoveries of the whole procedure were evaluated using natural (82)Se or the gamma emitter (75)Se as a radioactive spiker. Then, the protocol was applied to two solid samples spiked with natural selenium, a glass microfiber filter and an ion exchange resin, and two liquid samples spiked with (75)Se, a synthetic solution and an effluent. The yields obtained for both samples ranged from 70 up to 80%.