RESUMEN
An easy and low-cost way to fabricate monometallic Au nanoislands for plasmonic enhanced spectroscopy is presented. The method is based on direct thermal evaporation of Au on glass substrates to form nanoislands, with thicknesses between 2 and 15 nm, which are subsequently covered by a thin layer of silicon dioxide. We have used HR-SEM and AFM to characterize the nanoislands, and their optical transmission reveals strong plasmon resonances in the visible. The plasmonic performance of the fabricated substrates has been tested in fluorescence and Raman scattering measurements of two probe materials. Enhancement factors up to 1.8 and 9×104 are reported for confocal fluorescence and Raman microscopies, respectively, which are comparable to others obtained by more elaborated fabrication procedures.
RESUMEN
The spontaneous growth of GaN nanowires (NWs) in absence of catalyst is controlled by the Ga flux impinging both directly on the top and on the side walls and diffusing to the top. The presence of diffusion barriers on the top surface and at the frontier between the top and the sidewalls, however, causes an inhomogeneous distribution of Ga adatoms at the NW top surface resulting in a GaN accumulation in its periphery. The increased nucleation rate in the periphery promotes the spontaneous formation of superlattices in InGaN and AlGaN NWs. In the case of AlN NWs, the presence of Mg can enhance the otherwise short Al diffusion length along the sidewalls inducing the formation of AlN nanotubes.
RESUMEN
The mechanisms of plasma-assisted molecular beam epitaxial growth of GaN on muscovite mica were investigated. Using a battery of techniques, including scanning and transmission electron microscopy, atomic force microscopy, cathodoluminescence, Raman spectroscopy and x-ray diffraction, it was possible to establish that, in spite of the lattice symmetry mismatch, GaN grows in epitaxial relationship with mica, with the [11-20] GaN direction parallel to [010] direction of mica. GaN layers could be easily detached from the substrate via the delamination of the upper layers of the mica itself, discarding the hypothesis of a van der Waals growth mode. Mixture of wurtzite (hexagonal) and zinc blende (ZB) (cubic) crystallographic phases was found in the GaN layers with ratios highly dependent on the growth conditions. Interestingly, almost pure ZB GaN epitaxial layers could be obtained at high growth temperature, suggesting the existence of a specific GaN nucleation mechanism on mica and opening a new way to the growth of the thermodynamically less stable ZB GaN phase.
RESUMEN
Efficient, mercury-free deep ultraviolet (DUV) light-emitting diodes (LEDs) are becoming a crucial challenge for many applications such as water purification. For decades, the poor p-type doping and difficult current injection of Al-rich AlGaN-based DUV LEDs have limited their efficiency and therefore their use. We present here the significant increase in AlN p-doping thanks to Mg/In codoping, which leads to an order of magnitude higher Mg solubility limit in AlN nanowires (NWs). Optimal electrical activation of acceptor impurities has been further achieved by electron irradiation, resulting in tunnel conduction through the AlN NW p-n junction. The proposed theoretical scenario to account for enhanced Mg incorporation involves an easy ionization of In-vacancy complex associated with a negative charging of Mg in In vicinity. This leads to favored incorporation of negatively charged Mg into the AlN matrix, opening the path to the realization of highly efficient NW-based LEDs in the DUV range.
RESUMEN
The formation of a self-limited metallic bilayer is reported during the growth of GaN by plasma-assisted molecular beam epitaxy on graphene on (0001) SiC. Depending on growth conditions, this layer may consist of either Ga or In, which gets intercalated between graphene and the SiC surface. Diffusion of metal atoms is eased by steps at SiC surface and N plasma induced defects in the graphene layer. Energetically favorable wetting of the (0001) SiC surface by Ga or In is tentatively assigned to the breaking of covalent bonds between (0001) SiC surface and carbon buffer layer. As a consequence, graphene doping and local strain/doping fluctuations decrease. Furthermore, the presence of a metallic layer below GaN opens the way to the development of devices with a spontaneously formed metallic electrode on their back side.
RESUMEN
Improvements in the spatial resolution of synchrotron-based X-ray probes have reached the nano-scale and they, nowadays, constitute a powerful platform for the study of semiconductor nanostructures and nanodevices that provides high sensitivity without destroying the material. Three complementary hard X-ray synchrotron techniques at the nanoscale have been applied to the study of individual nanowires (NWs) containing non-polar GaN/InGaN multi-quantum-wells. The trace elemental sensitivity of X-ray fluorescence allows one to determine the In concentration of the quantum wells and their inhomogeneities along the NW. It is also possible to rule out any contamination from the gold nanoparticle catalyst employed during the NW growth. X-ray diffraction and X-ray absorption near edge-structure probe long- and short-range order, respectively, and lead us to the conclusion that while the GaN core and barriers are fully relaxed, there is an induced strain in InGaN layers corresponding to a perfect lattice matching with the GaN core. The photoluminescence spectrum of non-polar InGaN quntum wells is affected by strain and the inhomogeneous alloy distribution but still exhibits a reasonable 20% relative internal quantum efficiency.
RESUMEN
Using atom probe tomography, it is demonstrated that Mg doping of GaN nanowires grown by Molecular Beam Epitaxy results in a marked radial inhomogeneity, namely a higher Mg content in the periphery of the nanowires. This spatial inhomogeneity is attributed to a preferential incorporation of Mg through the m-plane sidewalls of nanowires and is related to the formation of a Mg-rich surface which is stabilized by hydrogen. This is further supported by Raman spectroscopy experiments which give evidence of Mg-H complexes in the doped nanowires. A Mg doping mechanism such as this, specific to nanowires, may lead to higher levels of Mg doping than in layers, boosting the potential interest of nanowires for light emitting diode applications.
RESUMEN
Dual-function hybrid material U1 was designed for simultaneous chromofluorogenic detection and removal of Hg(2+) in an aqueous environment. Mesoporous material UVM-7 (MCM41 type) with homogeneously distributed pores of about 2-3 nm in size, a large specific surface area exceeding 1000 m(2) g(-1), and nanoscale particles was used as an inorganic support. The mesoporous solid is decorated with thiol groups that were treated with squaraine dye III to give a 2,4-bis(4-dialkylaminophenyl)-3-hydroxy-4-alkylsulfanylcyclobut-2-enone (APC) derivative that is covalently anchored to the inorganic silica matrix. The solid was characterised by various techniques including X-ray diffraction, transmission electron microscopy, Raman spectroscopy, and nitrogen adsorption. This hybrid solid is the chemodosimeter for Hg(2+) detection. Hg(2+) reacts with the APC fragment in U1 with release of the squaraine dye into the solution, which turns deep blue and fluoresces strongly. Naked-eye Hg(2+) detection is thus accomplished in an easy-to-use procedure. In contrast, U1 remains silent in the presence of other thiophilic transition metal ions, alkali and alkaline earth metal ions, or anions ubiquitously present in water such as chloride, carbonate, sulfate, and phosphate. Material U1 acts not only as chemodosimeter that signals the presence of Hg(2+) down to parts-per-billion concentrations, but at the same time is also an excellent adsorbent for the removal of mercury cations from aqueous solutions. The amount of adsorbed mercury ranges from 0.7 to 1.7 mmol g(-1), depending on the degree of functionalisation. In addition, hybrid material U1 can be regenerated for both sensing and removal purposes. As far as we know, U1 is the first example of a promising new class of polyfunctional hybrid supports that can be used as both remediation and alarm systems by selective signalling and removal of target species of environmental importance. Model compounds based on silica gel (G1), fumed silica (F1), and micrometre-sized MCM-41 scaffolds (M1) were also prepared and studied for comparative purposes.
Asunto(s)
Colorantes Fluorescentes/química , Mercurio/análisis , Compuestos de Organosilicio/química , Adsorción , Colorantes Fluorescentes/síntesis química , Estructura Molecular , Tamaño de la Partícula , Porosidad , Dióxido de Silicio/química , Propiedades de SuperficieRESUMEN
Silica-based ZnO-MCM-41 mesoporous nanocomposites with high Zn content (5≤Si/Zn≤50) have been synthesized by a one-pot surfactant-assisted procedure from aqueous solution using a cationic surfactant (CTMABr = cetyltrimethylammonium bromide) as structure-directing agent, and starting from molecular atrane complexes as inorganic hydrolytic precursors. This preparative technique allows optimization of the dispersion of the ZnO nanodomains in the silica walls. The mesoporous nature of the final materials is confirmed by x-ray diffraction (XRD), transmission electron microscopy (TEM) and N(2) adsorption-desorption isotherms. The ZnO-MCM-41 materials show unimodal pore size distributions without blocking of the pore system even for high Zn content. A careful optical spectroscopic study (using x-ray photoelectron spectroscopy (XPS), photoluminescence (PL) and UV-visible spectroscopy) of these materials shows that, irrespective of the Si/Zn ratio, the Zn atoms are organized in well-dispersed, uniform low-defect ZnO nanodomains (radius about 1 nm) and are partially embedded within the silica walls.