RESUMEN
The paper describes the production and study of spherical powder made from corrosion-resistant 316L steel with the addition of 0.2% and 0.5% Ag. The study of granulometric composition, morphology, fluidity and bulk density, phase composition, microhardness and impurity composition of the spherical powders was carried out. The study showed compliance of the spherical powders with the requirements for powders used for additive manufacturing. The fluidity of the powders was 17.9 s, and the bulk density was 3.76 g/cm3. The particles have a spherical shape with a minimum number of defects and an austenitic-ferritic structure. The study of the phase composition of ingots, wires and powders showed that the ingot structure of all samples consists of austenite. According to the results of studies of the phase composition of the wire, there is a decrease in γ-Fe and an increase in α-Fe and σ-NiCr in going from wire No. 1 to wire No. 3. According to the results of studies of the phase composition of the powder particles, there are three phases, γ-Fe, α-Fe, and Fe3O4. The study of microhardness showed a decrease in HV depending on the increase in silver. The hardness of the powder is lower than that of the ingot by 16-24% due to the presence of a ferritic phase in the powder. As a result of plasma spraying, an increase in residual oxygen is observed, which is associated with the oxidation of the melt during plasma dispersion. The amount of nitrogen and sulfur does not change, while the amount of carbon and hydrogen decreases, and the impurities content corresponds to the standards for corrosion-resistant steel. Qualitative and quantitative analysis of the silver content in the samples indicates that it was not affected by the stages involved in obtaining the spherical powder.
RESUMEN
The article is devoted to the study of melted ingots, plates rolled from them, and the resulting spherical powder made of corrosion-resistant 316L steel with the addition of 0.2 wt.% and 0.5 wt.% Ag. The study of antibacterial properties, microstructure, and distribution of silver concentrations, as well as qualitative analysis of silver content was carried out. The optimal mode of homogenization annealing of the ingot was 1050 °C for 9 h, which leads to the formation of an austenitic structure. It is shown that the addition of a small amount of silver does not affect the formation of the austenitic structure and silver is distributed evenly throughout the volume of the ingot. The austenitic structure also prevails in the plates after rolling. Silver is distributed evenly throughout the entire volume of the plate. It is noted that the addition of 0.2 wt.% Ag does not affect the strength, elongation, and microhardness of steel, and the addition of 0.5 wt.% Ag does not significantly reduce the strength of steel, however, all samples meet the mechanical characteristics according to the ASTM A240 standard. The qualitative chemical composition of samples made of corrosion-resistant steels was confirmed by X-ray fluorescence analysis methods. By the method of energy-dispersion analysis, the presence of a uniform distribution of silver over the entire volume of the powder particle was determined. The particles have a spherical shape with a minimum number of defects. The study of the antibacterial activity of plates and powder shows the presence of a clear antibacterial effect (bacteria of the genus Xanthomonas campestris, Erwinia carotovora, Pseudomonas marginalis, Clavibacter michiganensis) in samples No. 2 and No. 3 with the addition of 0.2 wt.% and 0.5 wt.% Ag.