RESUMEN
Wet oxidation methods are utilized to separate and quantify (3)H and (14)C radionuclides in inorganic and organic radwastes generated at nuclear facilities. Because (3)H and (14)C are pure beta emitters with half-lives of 12.3 and 5,730 years, respectively, these radionuclides should be chemically separated from other radionuclides present in radwastes for accurate quantification. In particular, a collection technique for (14)C radionuclide in radwastes is needed because it is converted into (14)CO2 gas by an oxidation reaction. To confirm the recoveries of (3)H and (14)C, various standard radioactive sources were used to verify the proposed method. Because the majority of (3)H radionuclides are distributed in tritiated water (HTO), only tritiated water was used as a standard for (3)H radionuclides. Additionally, (14)C-labeled methanol ((14)CH3OH), lauric acid ((14)CH3(CH2)10COOH), sodium bicarbonate (NaH(14)CO3), and toluene (C6H5(14)CH3) were used as (14)C standards. The compounds were oxidized with chemical oxidants and then separated. The individual species were mixed with a scintillation cocktail and counted using a liquid scintillation counter. The recoveries of (14)C and (3)H were 82-97% and 98%, respectively. The wet oxidation method will be applied to RI wastes for clearance.
Asunto(s)
Radioisótopos de Carbono/análisis , Radioisótopos de Carbono/química , Calefacción/métodos , Monitoreo de Radiación/métodos , Residuos Radiactivos/análisis , Tritio/análisis , Tritio/química , Oxidación-Reducción , Dosis de Radiación , Reproducibilidad de los Resultados , Sensibilidad y Especificidad , Soluciones , Manejo de Especímenes/métodosRESUMEN
Aqueous wastes from nuclear fuel reprocessing present special problems of radiotoxicity of the active species. Cells of Serratia sp. were found previously to accumulate high levels of hydrogen uranyl phosphate (HUP) via the activity of a phosphatase enzyme. Uranium is of relatively low radiotoxicity whereas radionuclide fission products such as (90)Sr and (137)Cs are highly radiotoxic. These radionuclides can be co-crystallized, held within the bio-HUP "host" lattice on the bacterial cells and thereby removed from contaminated solution, depending on continued phosphatase activity. Radiostability tests using a commercial (60)Co γ-source showed that while cell viability and activity of purified phosphatase were lost within a few hours on irradiation, whole-cell phosphatase retained 80% of the initial activity, even after loss of cell culturability, which was increased to 100% by the incorporation of mercaptoethanol as an example radioprotectant, beyond an accumulated dose of >1.3 MGy. Using this co-crystallization approach (without mercaptoethanol) (137)Cs(+) and (85)Sr(2+) were removed from a simulated waste selectively against a 33-fold excess of Na(+).
Asunto(s)
Monoéster Fosfórico Hidrolasas/metabolismo , Residuos Radiactivos , Radioisótopos/metabolismo , Serratia/enzimología , Serratia/efectos de la radiación , Cristalización , Mercaptoetanol/metabolismo , Viabilidad Microbiana/efectos de la radiación , Protectores contra Radiación/metabolismo , Factores de Tiempo , Eliminación de Residuos Líquidos/métodos , Administración de Residuos/métodosRESUMEN
In this paper a relatively simple and low cost analysis procedure to apply to a routine analysis of (129)I in low and intermediate level radioactive wastes (LILWs), cement and paraffin solidified evaporated bottom and spent resin, which are produced from nuclear power plants (NPPs), pressurized water reactors (PWR), is presented. The (129)I is separated from other nuclides in LILWs using an anion exchange adsorption and solvent extraction by controlling the oxidation and reduction state and is then precipitated as silver iodide for counting the beta activity with a low background gas proportional counter (GPC). The counting efficiency of GPC was varied from 4% to 8% and it was reversely proportional to the weight of AgI by a self absorption of the beta activity. Compared to a higher pH, the chemical recovery of iodide as AgI was lowered at pH 4. It was found that the chemical recovery of iodide for the cement powder showed a lower trend by increasing the cement powder weight, but it was not affected for the paraffin sample. In this experiment, the overall chemical recovery yield of the cement and paraffin solidified LILW samples and the average weight of them were 67+/-3% and 5.43+/-0.53 g, 70+/-7% and 10.40+/-1.60 g, respectively. And the minimum detectable activity (MDA) of (129)I for the cement and paraffin solidified LILW samples was calculated as 0.070 and 0.036 Bq/g, respectively. Among the analyzed cement solidified LILW samples, (129)I activity concentration of four samples was slightly higher than the MDA and their ranges were 0.076-0.114 Bq/g. Also of the analyzed paraffin solidified LILW samples, five samples contained a little higher (129)I activity concentration than the MDA and their ranges were 0.036-0.107 Bq/g.
RESUMEN
The characteristics of the oxidation states of Pu in a hydrochloric acid solution were investigated and the results were applied to a separating of Pu isotopes from IAEA reference soils. The oxidation states of Pu(III) and Pu(IV) were prepared by adding hydroxylamine hydrochloride and sodium nitrite to a Pu stock solution, respectively. Also, the oxidation state of Pu(VI) was adjusted with concentrated HNO(3) and HClO(4). The stability of the various oxidation states of plutonium in a HCl solution with elapsed time after preparation were found to be in the following order: Pu(III) approximately Pu(VI)>Pu(IV)>Pu(V). The chemical recoveries of Pu(IV) in a 9M HCl solution with an anion exchange resin were similar to those of Pu(VI). This method for the determination of Pu isotopes with an anion exchange resin in a 9M HCl medium was applied to IAEA reference soils where the activity concentrations of (239,240)Pu and (238)Pu in IAEA-375 and IAEA-326 were consistent with the reference values reported by the IAEA.
Asunto(s)
Ácido Clorhídrico/química , Isótopos/química , Plutonio/química , Isótopos/análisis , Oxidación-Reducción , Plutonio/análisisRESUMEN
A fission track analysis and alpha track analysis were developed to detect fissile particles such as uranium and plutonium isotopes as well as to identify particle-bound plutonium in contaminated soil or sediment. To record a reference point, a locator SEM grid electroplated with boron was used to obtain a recorded grid image on the Lexan or CR-39 detector. With the fission track technique, the track images of the grid coated with boron and the fissile nuclides on the CR-39 detector were clearly recorded so that the location of the fissile particles could be easily identified in the radio-contaminated soil matrix. With the alpha track technique, many of the hot particles in the BOMARC soil turned out to be contaminated with plutonium isotopes rather than uranium isotopes.