RESUMEN
Many arid lands across the globe are experiencing more frequent and extreme droughts due to warmer temperatures resulting from climate change, less predictable precipitation patterns, and decreased soil moisture. Approximately 60-90% of household water is used for urban landscape irrigation in the western United States, necessitating the establishment of landscapes using drought-tolerant plants that conserve water. Shepherdia ×utahensis (hybrid buffaloberry) is a drought-tolerant plant with dense leaf trichomes (epidermal appendages) that may limit excessive water loss by transpiration. However, little is known about how S. ×utahensis regulates leaf heat balance when transpirational cooling is limited. The objective of this research was to investigate the effects of substrate water availability on plant growth and development and trichome density of S. ×utahensis. Ninety-six clonally propagated plants were grown using an automated irrigation system, and their substrate volumetric water contents were controlled at 0.05-0.40 m3·m-3 for 2 months. Results showed that water stress impaired plant growth and increased the proportion of visibly wilted leaves. Shepherdia ×utahensis acclimates to drought by reducing cell dehydration and canopy overheating, which may be accomplished through decreased stomatal conductance, smaller leaf development, leaf curling, increased leaf thickness, and greater root-to-shoot ratio. Leaf trichome density increased when stem water potential decreased, resulting in greater leaf reflectance of visible light. Cell and leaf expansion were restricted under water stress, and negative correlations were exhibited between epidermal cell size and trichome density. According to our results, plasticity in leaves and roots aids plants in tolerating abiotic stresses associated with drought. Acclimation of S. ×utahensis to water stress was associated with increased trichome density due to plasticity in cell size. Dense trichomes on leaves reflected more lights which appeared to facilitate leaf temperature regulation.
RESUMEN
Moisture content is a critical variable for the harvesting, processing, storing and marketing of cereal grains, oilseeds and legumes. Efficient and accurate determination of grain moisture content even with advanced nondestructive techniques, remains a challenge due to complex water-retaining biological structures and hierarchical composition and geometry of grains that affect measurement interpretation and require specific grain-dependent calibration. We review (1) the primary factors affecting permittivity measurements used in practice for inferring moisture content in grains; (2) develop novel methods for estimating critical parameters for permittivity modeling including packing density, porosity, water binding surface area and water phase permittivity and (3) represent the permittivity of packs of grains using dielectric mixture theory as a function of moisture content applied to high moisture corn (as a model grain). Grain permittivity measurements are affected by their free and bound water contents, chemical composition, temperature, constituent shape, phase configuration and measurement frequency. A large fraction of grain water is bound exhibiting reduced permittivity compared to that of free water. The reduced mixture permittivity and attributed to hydrophilic surfaces in starches, proteins and other high surface area grain constituents. The hierarchal grain structure (i.e., kernel, starch grain, lamella, molecule) and the different constituents influence permittivity measurements due to their layering, geometry (i.e., kernel or starch grain), configuration and water-binding surface area. Dielectric mixture theory offers a physically-based approach for modeling permittivity of agricultural grains and similar granular media.
Asunto(s)
Grano Comestible , Almidón , Grano Comestible/química , Almidón/análisis , Verduras , Agua/química , Zea maysRESUMEN
The number of sensors, ground-based and remote, exploiting the relationship between soil dielectric response and soil water content continues to grow. Empirical expressions for this relationship generally work well in coarse-textured soils but can break down for high-surface area and intricate materials such as clayey soils. Dielectric mixing models are helpful for exploring mechanisms and developing new understanding of the dielectric response in porous media that do not conform to a simple empirical approach, such as clayey soils. Here, we explore the dielectric response of clay minerals and clayey soils using the mixing model approach in the frequency domain. Our modeling focuses on the use of mixing models to explore geometrical effects. New spectroscopic data are presented for clay minerals (talc, kaolinite, illite and montmorillonite) and soils dominated by these clay minerals in the 1 MHz-6 GHz bandwidth. We also present a new typology for the way water is held in soils that we hope will act as a framework for furthering discussion on sensor design. We found that the frequency-domain response can be mostly accounted for by adjusting model structural parameters, which needs to be conducted to describe the Maxwell-Wagner (MW) relaxation effects. The work supports the importance of accounting for soil structural properties to understand and predict soil dielectric response and ultimately to find models that can describe the dielectric-water content relationship in fine-textured soils measured with sensors.
RESUMEN
Although only representing 0.05% of global freshwater, or 0.001% of all global water, soil water supports all terrestrial biological life. Soil moisture behaviour in most models is constrained by hydraulic parameters that do not change. Here we argue that biological feedbacks from plants, macro-fauna and the microbiome influence soil structure, and thus the soil hydraulic parameters and the soil water content signals we observe. Incorporating biological feedbacks into soil hydrological models is therefore important for understanding environmental change and its impacts on ecosystems. We anticipate that environmental change will accelerate and modify soil hydraulic function. Increasingly, we understand the vital role that soil moisture exerts on the carbon cycle and other environmental threats such as heatwaves, droughts and floods, wildfires, regional precipitation patterns, disease regulation and infrastructure stability, in addition to agricultural production. Biological feedbacks may result in changes to soil hydraulic function that could be irreversible, resulting in alternative stable states (ASS) of soil moisture. To explore this, we need models that consider all the major feedbacks between soil properties and soil-plant-faunal-microbial-atmospheric processes, which is something we currently do not have. Therefore, a new direction is required to incorporate a dynamic description of soil structure and hydraulic property evolution into soil-plant-atmosphere, or land surface, models that consider feedbacks from land use and climate drivers of change, so as to better model ecosystem dynamics.
Asunto(s)
Retroalimentación , Agua Subterránea , Plantas/metabolismo , Suelo/química , Ciclo del Carbono , Clima , Sequías , Ecosistema , Ambiente , HidrologíaRESUMEN
The recently developed OPtical TRApezoid Model (OPTRAM) has been successfully applied for watershed scale soil moisture (SM) estimation based on remotely sensed shortwave infrared (SWIR) transformed reflectance (TRSWIR) and the normalized difference vegetation index (NDVI). This study is aimed at the evaluation of OPTRAM for field scale precision agriculture applications using ultrahigh spatial resolution optical observations obtained with one of the world's largest field robotic phenotyping scanners located in Maricopa, Arizona. We replaced NDVI with the soil adjusted vegetation index (SAVI), which has been shown to be more accurate for cropped agricultural fields that transition from bare soil to dense vegetation cover. The OPTRAM was parameterized based on the trapezoidal geometry of the pixel distribution within the TRSWIR-SAVI space, from which wet- and dry-edge parameters were determined. The accuracy of the resultant SM estimates is evaluated based on a comparison with ground reference measurements obtained with Time Domain Reflectometry (TDR) sensors deployed to monitor surface, near-surface and root zone SM. The obtained results indicate an SM estimation error between 0.045 and 0.057 cm3 cm-3 for the near-surface and root zone, respectively. The high resolution SM maps clearly capture the spatial SM variability at the sensor locations. These findings and the presented framework can be applied in conjunction with Unmanned Aerial System (UAS) observations to assist with farm scale precision irrigation management to improve water use efficiency of cropping systems and conserve water in water-limited regions of the world.
RESUMEN
Ecosystems may exhibit alternative stable states (ASS) in response to environmental change. Modelling and observational data broadly support the theory of ASS, however evidence from manipulation experiments supporting this theory is limited. Here, we provide long-term manipulation and observation data supporting the existence of drought induced alternative stable soil moisture states (irreversible soil wetting) in upland Atlantic heath, dominated by Calluna vulgaris (L.) Hull. Manipulated repeated moderate summer drought, and intense natural summer drought both lowered resilience resulting in shifts in soil moisture dynamics. The repeated moderate summer drought decreased winter soil moisture retention by ~10%. However, intense summer drought, superimposed on the experiment, that began in 2003 and peaked in 2005 caused an unexpected erosion of resilience and a shift to an ASS; both for the experimental drought manipulation and control plots, impairing the soil from rewetting in winter. Measurements outside plots, with vegetation removal, showed no evidence of moisture shifts. Further independent evidence supports our findings from historical soil moisture monitoring at a long-term upland hydrological observatory. The results herald the need for a new paradigm regarding our understanding of soil structure, hydraulics and climate interaction.
RESUMEN
Emissions of gases from agricultural and animal feeding operations contribute to climate change, produce odors, degrade sensitive ecosystems, and pose a threat to public health. The complexity of processes and environmental variables affecting these emissions complicate accurate and reliable quantification of gas fluxes and production rates. Although a plethora of measurement technologies exist, each method has its limitations that exacerbate accurate quantification of gas fluxes. Despite a growing interest in gas emission measurements, only a few available technologies include real-time, continuous monitoring capabilities. Commonly applied state-of-the-art measurement frameworks and technologies were critically examined and discussed, and recommendations for future research to address real-time monitoring requirements for forthcoming regulation and management needs are provided.
Asunto(s)
Monitoreo del Ambiente/métodos , Gases/análisis , Agricultura , Contaminantes Atmosféricos/análisis , Alimentación Animal/análisis , Animales , Monitoreo del Ambiente/instrumentación , Diseño de Equipo , Efecto Invernadero , Meteorología/instrumentación , Meteorología/métodosRESUMEN
Greenhouse and regulated gas emissions from animal waste are naturally mediated by moisture content and temperature. As with soils, emissions from manure could be readily estimated given the physical, hydraulic, and thermal properties are described by models and microbes and nutrients are not limiting factors. The objectives of this study were to measure and model physical, hydraulic, and thermal properties of dairy manure to support advanced modeling of gas and water fluxes in addition to solute, colloid, and heat transport. A series of soil science measurement techniques were applied to determine a set of fundamental properties of as-excreted dairy cattle manure. Relationships between manure dielectric permittivity and volumetric water content (θ) were obtained using time-domain reflectometry and capacitance-based dielectric measurements. The measured water retention characteristic for cattle manure was similar to organic peat soil. The unsaturated hydraulic conductivity function of dairy manure was inferred from inverse numerical fitting of laboratory manure evaporation results. The thermal properties of dairy manure, including thermal conductivity, thermal diffusivity, and bulk volumetric heat capacity, were also determined using three penta-needle heat pulse probes. The accuracy of the heat capacity measurements was determined from a comparison of theoretical θ, estimated from the measured thermal properties with that determined by the capacitance-based dielectric measurement. These data represent a novel and unique contribution for advancing prediction and modeling capabilities of gas emissions from cattle manure, although the uncertainties associated with the complexities of shrinkage, surface crust formation, and cracking must also be considered.
RESUMEN
Baked ceramic aggregates (fritted clay, arcillite) have been used for plant research both on the ground and in microgravity. Optimal control of water and air within the root zone in any gravity environment depends on physical and hydraulic properties of the aggregate, which were evaluated for 0.25-1-mm and 1-2-mm particle size distributions. The maximum bulk densities obtained by any packing technique were 0.68 and 0.64 g cm-3 for 0.25-1-mm and 1-2-mm particles, respectively. Wettable porosity obtained by infiltration with water was approximately 65%, substantially lower than total porosity of approximately 74%. Aggregate of both particle sizes exhibited a bimodal pore size distribution consisting of inter-aggregate macropores and intra-aggregate micropores, with the transition from macro- to microporosity beginning at volumetric water content of approximately 36% to 39%. For inter-aggregate water contents that support optimal plant growth there is 45% change in water content that occurs over a relatively small matric suction range of 0-20 cm H2O for 0.25-1-mm and 0 to -10 cm H2O for 1-2-mm aggregate. Hysteresis is substantial between draining and wetting aggregate, which results in as much as a approximately 10% to 20% difference in volumetric water content for a given matric potential. Hydraulic conductivity was approximately an order of magnitude higher for 1-2-mm than for 0.25-1-mm aggregate until significant drainage of the inter-aggregate pore space occurred. The large change in water content for a relatively small change in matric potential suggests that significant differences in water retention may be observed in microgravity as compared to earth.
Asunto(s)
Cerámica , Hidroponía , Reología , Agua , Silicatos de Aluminio , Arcilla , Medios de Cultivo , Sistemas Ecológicos Cerrados , Sistemas de Manutención de la Vida , Tamaño de la Partícula , Raíces de Plantas/crecimiento & desarrollo , Raíces de Plantas/metabolismo , Porosidad , Suelo , Vuelo Espacial , IngravidezRESUMEN
Control of water and air in the root zone of plants remains a challenge in the microgravity environment of space. Due to limited flight opportunities, research aimed at resolving microgravity porous media fluid dynamics must often be conducted on Earth. The NASA KC-135 reduced gravity flight program offers an opportunity for Earth-based researchers to study physical processes in a variable gravity environment. The objectives of this study were to obtain measurements of water content and matric potential during the parabolic profile flown by the KC-135 aircraft. The flight profile provided 20-25 s of microgravity at the top of the parabola, while pulling 1.8 g at the bottom. The soil moisture sensors (Temperature and Moisture Acquisition System: Orbital Technologies, Madison, WI) used a heat-pulse method to indirectly estimate water content from heat dissipation. Tensiometers were constructed using a stainless steel porous cup with a pressure transducer and were used to measure the matric potential of the medium. The two types of sensors were placed at different depths in a substrate compartment filled with 1-2 mm Turface (calcined clay). The ability of the heat-pulse sensors to monitor overall changes in water content in the substrate compartment decreased with water content. Differences in measured water content data recorded at 0, 1, and 1.8 g were not significant. Tensiometer readings tracked pressure differences due to the hydrostatic force changes with variable gravity. The readings may have been affected by changes in cabin air pressure that occurred during each parabola. Tensiometer porous membrane conductivity (function of pore size) and fluid volume both influence response time. Porous media sample height and water content influence time-to-equilibrium, where shorter samples and higher water content achieve faster equilibrium. Further testing is needed to develop these sensors for space flight applications.