Elemental characterization of PM10, PM2.5 and PM1 in the town of Genoa (Italy).

The particulate matter (PM) concentration and composition, the PM10, PM2.5, PM1 fractions, were studied in the urban area of Genoa, a coastal town in the northwest of Italy. Two instruments, the continuous monitor TEOM and the sequential sampler PARTISOL, were operated almost continuously on the same site from July 2001 to September 2004. Samples collected by PARTISOL were weighted to obtain PM concentration and then analysed by PIXE (particle induced X-ray emission) and by ED-XRF (energy dispersion X-ray fluorescence), obtaining concentrations for elements from Na to Pb. Some of the filters used in the TEOM microbalance were analysed by ED-XRF to calculate Pb concentration values averaged over 7-30 d periods.

Seasonal variation of 210Pb activity concentration in outdoor air of Milan (Italy).

Weekly measurements of 210Pb activity concentration on aerosol particles were performed at ground level in outdoor air in Milan (Italy) during the years 2000-2001. The experimental method was based on the delayed alpha spectrometry of in-grown 210Po activity detected on airborne particles collected on a filter support. On the same filter the 214Pb activity concentration was also measured during the sampling. 210Pb weekly concentration values showed a great variability and the average monthly values exhibited a seasonal pattern characterised by maxima in winter and minima in spring-summer. The same seasonal trend was also observed in 214Pb concentration values. 210Pb average yearly values were 0.70 and 0.82 mBq/m3 in 2000 and 2001, respectively, in good agreement with literature data registered at continental sites of similar latitude and longitude. The activity ratio 210Pb/214Pb was used to evaluate the residence time of fine aerosols in the urban air of Milan, which was 1-2 days.

Use of RAPD-PCR and TTGE for the evaluation of biodiversity of whey cultures for Grana Padano cheese.

AIMS: This work was carried out in order to evaluate the microbial diversity of whey cultures collected from different Grana Padano cheese plants in Veneto region (north-east Italy) by means of RAPD-PCR and Temporal Temperature Gradient Gel Electrophoresis (TTGE) analysis. METHODS AND RESULTS: Lactobacillus helveticus was the dominant species among isolated thermophilic lactobacilli. RAPD-PCR with primers M13 and D8635 resulted a suitable method for typing Lact. helveticus at strain level. Thirteen different Lact. helveticus biotypes were detected in the seven whey cultures studied with one biotype present in all the whey cultures. Besides Lact. helveticus, Lact. delbrueckii subsp. lactis was the main microbial species detected by TTGE. CONCLUSIONS: RAPD-PCR resulted very useful in studying Lact. helveticus biodiversity; furthermore, TTGE analysis allowed to detect the dominant thermophilic microflora characteristic of Grana Padano cheese whey cultures. IMPACT OF THE STUDY: By the combined used of RAPD-PCR and TTGE it could be possible to follow the behaviour in strain or species composition of whey cultures during time.

Genotypic and phenotypic diversity of Lactobacillus delbrueckii subsp. lactis strains of dairy origin.

Eighty-nine strains of Lactobacillus delbrueckii subsp. lactis isolated from Italian hard and semi-hard cheeses and artisan starter cultures were characterised by phenotypic and genotypic methods. Phenotypic diversity was evaluated by studying biochemical characteristics (i.e. acidifying and peptidase activities) of technological interest. Genotypic diversity was evidenced by RAPD-PCR and pulsed field gel electrophoresis (PFGE). Phenotypic characterisation indicated a wide variability of the acidifying activity within Lact. delbrueckii subsp. lactis. Although the data was variable, it allowed us to evidence groups of strains with different acidifying properties, especially in terms of acidification intensity. Concerning peptidase activity, Lact. delbrueckii subsp. lactis showed a homogeneously high x-prolil-dipeptidil-aminopeptidase activity and a considerable but more heterogeneous lysil-aminopeptidase activity. The increased resolution obtained by the use of two molecular typing techniques, i.e. RAPD-PCR and PFGE, allowed to widen the level of strain heterogeneity. Technological and ecological pressures are determinant in selecting Lact. delbrueckii subsp. lactis sub-populations which are more functional to the different cheese technologies.

Source apportionment of PM10 and PM2.5 in Milan (Italy) using receptor modelling.

In this paper a source apportionment of particulate matter pollution in the urban area of Milan (Italy) is given. Results of PM10 and PM2.5 mass and elemental concentrations from a 1-year monitoring campaign are presented. Mean annual and daily PM10 levels are compared with the limits of the EU Air Quality Directive EC/30/1999 and the results show that the limit values established would not be met in the urban area of Milan or the large surrounding area. Moreover, high levels of PM2.5 are registered and this fraction constitutes a high portion of the PM10 mass. In Milan the winter period is characterised by a high degree of air pollution due to a greater contribution of emissions and to adverse meteorological and thermodynamic conditions of the atmosphere. The application of multivariate techniques and receptor modelling (PCFA, APCFA) to the whole data-set led to the identification of the main emitting sources and to the source apportionment of PM10 and PM2.5 in Milan. The most important sources were identified as 'soil dust', 'traffic', 'industry' and 'secondary compounds' for PM10 and as 'soil dust', 'anthropogenic' and 'secondary compounds' for PM2.5, explaining the greatest part of the total variance (91% and 75%, respectively).

Temporal variation of 212Pb concentration in outdoor air of Milan and a comparison with 214Bi.

Continuous measurement of hourly concentrations of 212Pb attached to aerosol particles was carried out during the whole year 2000 in the outdoor air of Milan (Italy). An improved experimental method based on on-line alpha spectroscopy during atmospheric particulate matter sampling allowed the contemporary determination of 212Pb and 214Bi through the deconvolution of the alpha energy spectral distribution analysis. The 212Pb hourly concentrations were about 100 times lower than 214Bi but showed a similar characteristic diurnal time trend. However, the influence of meteorological parameters such as rain and wind was more evident in 212Pb than in 214Bi concentrations. The 212Pb average annual concentration was 0.090 +/- 0.060 Bq/m3 with daily mean concentration varying from 0.013 to 0.333 Bq/m3.

Long period study of outdoor radon concentration in Milan and correlation between its temporal variations and dispersion properties of atmosphere.

The results of a survey of outdoor radon concentrations in Milan are reported. Measurements were performed hourly over a continuous four year period from January 1997 to December 2000. Radon concentration was obtained by two means: both direct measurement of radon; and measurement of its decay products. The average daily pattern of radon concentration featured a minimum in the late afternoon and a maximum in the early hours of the morning. A seasonal pattern with higher concentrations in winter than in summer (from around 15 Bq m(-3) in winter to around 5 Bq m(-3) in summer) was also observed. Similar average annual values of around 10 Bq m(-3) were obtained. The annual effective outdoor radon dose was found to be 0.12 mSv. The variation from minimum in the afternoon to maximum the following morning was found to be a good indicator of the height of the nocturnal mixing layer. The variation between maximum and minimum levels on the same day is an index of the maximum height of the mixing layer. Furthermore, our long term measurements of radon have permitted us to examine the dispersion characteristics of the atmosphere over Milan, and to establish the frequency of conditions unfavourable to the dispersion of atmospheric pollutants.

Factors influencing mass concentration and chemical composition of fine aerosols during a PM high pollution episode.

Results obtained during a winter field campaign for the fine fractions of particulate matter are presented. A high pollution episode together with an analysis of the main factors, which influence accumulation of pollutants is described. The measurement campaigns were carried out simultaneously at two sites in Northern Italy, Milan and Erba, during the winter of 2000. The daily variability in the mass concentration values and PM2.5/PM10 ratios appeared to be strongly dependent upon meteorological and atmospheric stability conditions and, in particular, wind regimes. During the intensive field campaign a high-pollution episode occurred that led to TSP and fine fraction concentrations well above the attention and alarm thresholds, reaching values of up to 200-250 microg m(-3). The elemental concentrations were determined by ED-XRF analysis. The elemental composition of the particulate matter indicated that crustal matter oxides (soil dust) were the main component in particles with aerodynamic diameter d(ae) > 10 microm. They were an important part also in particles with 2.5 < d(ae) < 10 microm, but strongly decreased in particles with d(ae) < 2.5 microm. In the finer fraction sulphates nitrogen and carbon compounds played a major role. The temporal patterns of mass and elemental concentrations, as well as the main components of PM were very similar at the two sites. The high-pollution episode was recorded at many locations in the Po plain, highlighting the role of meteorology and thermodynamic atmospheric conditions on pollution build-up on a large area.

Calcium density measurement in histological samples of trabecular bone of normal subjects: relationship with aging.

It is well-known that bone volume decreases with age both in normal subjects and particularly in osteoporotic patients. It is not well demonstrated, however, whether bone loss is associated with changes in the composition of bone tissue and especially with altered concentration of mineral elements. To verify whether calcium density changes with aging, autoptic specimens, of iliac crest trabecular bone from 20 normal subjects between 21 and 66 years, 10 males and 10 females were analyzed by using a new method which allows the measurement of calcium density in a non-destructive way, on entire histologic sections of the bone. Bone specimens were embedded in araidite and tissue sections, about 3 microm thick and 4x4 mm size, were mounted onto polyvinyl acetate films and analyzed by PIXE (proton induced X-ray emission) using the CISE setup for calcium content determination. The same bone tissue sections were then mounted on glass slides, stained with the Von Kossa method and the volume of calcified bone was measured with a semiautomatic image analyzer (Videoplan). 3 to 4 sections from each subject were analyzed and the values of calcium concentration were derived in microg/microl. Similar values of calcium density were found in males and females (535.6+77.1 and 539.2+74.1 microg/microl, respectively). No significant correlation between calcium density and age was observed either in all cases (r=0.0925) or in males (r=-0.0687) and in females (r=0.2676) separately. The unchanged calcium density during aging obtained by combining PIXE and histomorphometric techniques demonstrates that the skeletal calcium reduction observed in old age and probably during osteoporosis, is mainly due to the decrease of bone volume.

[Exposure to metals in dental laboratories]. / Esposizione a metalli nei laboratori odontotecnici.

Dental care includes handling of different types of metal alloys usually classified as "noble" and "base" in relation to the presence or absence of either gold or other precious metals. It must be born in mind that exposure to metals in this activities is due not only to those metals present in the alloys but also to those contained in the other materials used during the processes of casting and finishing. The most important metals are the following: Al, Be, Cd, Cr, Co, Cu, Au, In, Hg, Mo, Ni, Pd, Pt, Si, Ag, Sn, Ti, W, Zn. In this paper we investigated the environmental exposure to metals in dental laboratories studying the environmental air concentration of metals in casting and finishing processes estimating the "quality" of the elements present by Particle Induces X-ray Emission (PIXE) and the "quantity" of the elements by electro thermic atomic absorption spectrophotometry (ET-AAS) and the concentration of the main metals in the blood and in the urine of exposed technicians by ET-AAS. These analyses permitted to detect all the metals present in the work environment and to quantify their concentration, which always resulted to be low (except some metals during short time operations). The biological monitoring revealed the existence of moderate absorption of these metals in the exposed workers but it is not possible for us to affirm if this phenomenon represents a real risk for the health of the technicians. Hence further epidemiological and health surveillance investigations are needed to verify morbidity and mortality of the subjects employed in this activity.

PIXE technique for calcium analysis of human bone.

The determination of calcium content in human bone tissue is very useful in metabolic diseases of bone, such as renal osteodystrophy, osteoporosis, hyperparathyroidism, and osteomalacia of diverse etiology. The PIXE technique allows calcium to be directly determined in bioptic tissue sections properly, sampled for histological optical and/or electron microscopy examination.Bone semithin sections (3 µm thick, 4×4 mm(2) dimensions), cut by ultramicrotome and deposited onto polyvinyl acetate films, underwent PIXE analysis using the CISE set-up. Histomorphometric (after standard staining), evaluation of calcified bone volume (CBV) in absolute value allows calcium density to be determined. A total of nine bone biopsies were analyzed (three sections each) obtaining values ranging between 352 and 482, with an average value of 421.5±15.3 (M±SE) µg/µL, in good agreement with literature data (obtained by AAS technique on dissected bone samples).The aim of this paper is to emphasize the usefulness, of combined PIXE and histomorphometric techniques for the study of calcium content in bone tissue in both healthy and diseased bones.