Pin-based electrochemical glucose sensor with multiplexing possibilities.

This work describes the use of mass-produced stainless-steel pins as low-cost electrodes to develop simple and portable amperometric glucose biosensors. A potentiostatic three-electrode configuration device is designed using two bare pins as reference and counter electrodes, and a carbon-ink coated pin as working electrode. Conventional transparency film without any pretreatment is used to punch the pins and contain the measurement solution. The interface to the potentiostat is very simple since it is based on a commercial female connection. This electrochemical system is applied to glucose determination using a bienzymatic sensor phase (glucose oxidase/horseradish peroxidase) with ferrocyanide as electron-transfer mediator, achieving a linear range from 0.05 to 1mM. It shows analytical characteristics comparable to glucose sensors previously reported using conventional electrodes, and its application for real food samples provides good results. The easy modification of the position of the pins allows designing different configurations with possibility of performing simultaneous measurements. This is demonstrated through a specific design that includes four pin working-electrodes. Different concentrations of antibody labeled with alkaline phosphatase are immobilized on the pin-heads and after enzymatic conversion of 3-indoxylphosphate and silver nitrate, metallic silver is determined by anodic stripping voltammetry.

Pin-Based Flow Injection Electroanalysis.

This work describes the use of mass-fabricated stainless-steel pins as new low-cost electrodes for a flow injection analysis (FIA) system with electrochemical detection. The pins serving as electrodes are directly punched in the tubing where solutions flow, being one of the simplest flow cells for FIA. This cell consists of a carbon ink coated pin as working electrode and two bare pins as counter and reference electrodes. The pins are able to perform at least 300 measurements. Moreover, they can be easily replaced showing good repeatability and reproducibility (RSD lower than 6% in all the cases). As a proof-of-concept, the feasibility of the system to determine glucose was evaluated by an enzymatic assay using glucose oxidase, horseradish peroxidase, and ferrocyanide as electron-transfer mediator. The application of this system to real food samples has shown accurate results.