COVID-19 challenges: From SARS-CoV-2 infection to effective point-of-care diagnosis by electrochemical biosensing platforms.

In January 2020, the World Health Organization (WHO) identified a new zoonotic virus, SARS-CoV-2, responsible for causing the COVID-19 (coronavirus disease 2019). Since then, there has been a collaborative trend between the scientific community and industry. Multidisciplinary research networks try to understand the whole SARS-CoV-2 pathophysiology and its relationship with the different grades of severity presented by COVID-19. The scientific community has gathered all the data in the quickly developed vaccines that offer a protective effect for all variants of the virus and promote new diagnostic alternatives able to have a high standard of efficiency, added to shorter response analysis time and portability. The industry enters in the context of accelerating the path taken by science until obtaining the final product. In this review, we show the principal diagnostic methods developed during the COVID-19 pandemic. However, when we observe the diagnostic tools section of an efficient infection outbreak containment report and the features required for such tools, we could observe a highlight of electrochemical biosensing platforms. Such devices present a high standard of analytical performance, are low-cost tools, easy to handle and interpret, and can be used in the most remote and low-resource regions. Therefore, probably, they are the ideal point-of-care diagnostic tools for pandemic scenarios.

Toward a point-of-care diagnostic for specific detection of Mycobacterium tuberculosis from sputum samples.

This study reports the development of a new PCR-free device, using IS6110 gene as biomarker, for Tuberculosis (TB) diagnosis. An arginine film (ARGFILM) was used to prepare the biosensor platform. MT-probe was immobilized on this biosensor platform to identify IS6110 gene. This gene is an excellent biomarker for Mycobacterium tuberculosis (MT). Electrochemical analyses were carried out using differential pulse voltammetry method (DPV) by methylene blue (MB) reduction signal measurement before and after hybridization either between probe and synthetic target or extracted DNA from clinical sputum samples. The optimization study of MT-probe immobilization on modified-electrode surface showed that the best probe concentration was 15 µM. The analytical analysis of hybridization assays was performed using different concentrations of synthetic MT-target (15-500 nM). The linear response was between 15 and 100 nM and the detection limit was 4.4 nM. The biosensor performance was also investigated with extracted DNA from sputum samples (PCR-free). The results showed that the biosensor was able to detect the MT from samples, exhibiting a high sensitivity and satisfactory selectivity. Thus, these results allow for the possibility of developing a portable detection device for effective diagnosis of TB patients.

Co-contraction behaviour of masticatory and neck muscles during tooth grinding.

The objective of this study was to analyse the co-contraction behaviour of jaw and neck muscles during force-controlled experimental grinding in the supine position. Twelve symptom-free subjects were enrolled in the experimental study. Electromyographic (EMG) activity of semispinalis capitis, splenius capitis and levator scapulae muscles was recorded bilaterally with intramuscular fine-wire electrodes, whereas that of sternocleidomastoideus, infrahyoidal, suprahyoidal, masseter and anterior temporalis muscles were registered with surface electrodes. EMG and force measurements were performed during tasks simulating tooth grinding on custom-made intraoral metal splints. The mean EMG activity normalised by maximum voluntary contraction (% MVC) of each of the neck muscles studied during grinding was analysed and compared with previous data from jaw clenching at identical force (100 N) and (supine) position. The occurrence of low-level, long-lasting tonic activation (LLTA) of motor units was also documented. The mean three-dimensional force vector of the grinding forces was 106 ± 74 N. In the frontal plane, the incline to the midsagittal plane ranged between 10° and 15°. In the midsagittal plane, the incline to the frontal plane was negligibly small. Posterior neck muscle activity during grinding ranged between 4.5% and 12% MVC and during clenching with 100 N between 1.8% and 9.9% MVC. Masticatory muscle activity during grinding ranged between 17% and 21% MVC for contralateral masseter and ipsilateral temporalis and between 4% and 6.5% for ipsilateral masseter and contralateral temporalis. LLTA had an average duration of 195 ± 10 seconds. The findings from this study do not support pathophysiological muscle chain theories postulating simple biomechanical coupling of neck and jaw muscles. Co-contractions of neck and masticatory muscles may instead occur as a result of complex neurophysiological interactions.

Realistic kinetic loading of the jaw system during single chewing cycles: a finite element study.

Although knowledge of short-range kinetic interactions between antagonistic teeth during mastication is of essential importance for ensuring interference-free fixed dental reconstructions, little information is available. In this study, the forces on and displacements of the teeth during kinetic molar biting simulating the power stroke of a chewing cycle were investigated by use of a finite-element model that included all the essential components of the human masticatory system, including an elastic food bolus. We hypothesised that the model can approximate the loading characteristics of the dentition found in previous experimental studies. The simulation was a transient analysis, that is, it considered the dynamic behaviour of the jaw. In particular, the reaction forces on the teeth and joints arose from contact, rather than nodal forces or constraints. To compute displacements of the teeth, the periodontal ligament (PDL) was modelled by use of an Ogden material model calibrated on the basis of results obtained in previous experiments. During the initial holding phase of the power stroke, bite forces were aligned with the roots of the molars until substantial deformation of the bolus occurred. The forces tilted the molars in the bucco-lingual and mesio-distal directions, but as the intrusive force increased the teeth returned to their initial configuration. The Ogden material model used for the PDL enabled accurate prediction of the displacements observed in experimental tests. In conclusion, the comprehensive kinetic finite element model reproduced the kinematic and loading characteristics of previous experimental investigations.

Motor unit activity within the depth of the masseter characterized by an adapted scanning EMG technique.

OBJECTIVE: To study motor unit activity in the medio-lateral extension of the masseter using an adapted scanning EMG technique that allows studying the territories of multiple motor units (MUs) in one scan. METHODS: We studied the m. masseter of 10 healthy volunteers in whom two scans were performed. A monopolar scanning needle and two pairs of fine-wire electrodes were inserted into the belly of the muscle. The signals of the fine wire electrodes were decomposed into the contribution of single MUs and used as a trigger for the scanning needle. In this manner multiple MU territory scans were obtained simultaneously. RESULTS: We determined 161 MU territories. The maximum number of territories obtained in one scan was 15. The median territory size was 4.0mm. Larger and smaller MU territories were found throughout the muscle. CONCLUSIONS: The presented technique showed its feasibility in obtaining multiple MU territories in one scan. MUs were active throughout the depth of the muscle. SIGNIFICANCE: The distribution of electrical and anatomical size of MUs substantiates the heterogeneous distribution of MUs throughout the muscle volume. This distributed activity may be of functional significance for the stabilization of the muscle during force generation.

Small vertical changes in jaw relation affect motor unit recruitment in the masseter.

Strategies for recruitment of masseter muscle motor units (MUs), provoked by constant bite force, for different vertical jaw relations have not previously been investigated. The objective of this study was to analyse the effect of small changes in vertical jaw relation on MU recruitment behaviour in different regions of the masseter during feedback-controlled submaximum biting tasks. Twenty healthy subjects (mean age: 24·6 ± 2·4 years) were involved in the investigation. Intra-muscular electromyographic (EMG) activity of the right masseter was recorded in different regions of the muscle. MUs were identified by the use of decomposition software, and root-mean-square (RMS) values were calculated for each experimental condition. Six hundred and eleven decomposed MUs with significantly (P < 0·001) different jaw relation-specific recruitment behaviour were organised into localised MU task groups. MUs with different task specificity in seven examined tasks were observed. The RMS EMG values obtained from the different recording sites were also significantly (P < 0·01) different between tasks. Overall MU recruitment was significantly (P < 0·05) greater in the deep masseter than in the superficial muscle. The number of recruited MUs and the RMS EMG values decreased significantly (P < 0·01) with increasing jaw separation. This investigation revealed differential MU recruitment behaviour in discrete subvolumes of the masseter in response to small changes in vertical jaw relations. These fine-motor skills might be responsible for its excellent functional adaptability and might also explain the successful management of temporomandibular disorder patients by somatic intervention, in particular by the use of oral splints.

The effect of force-controlled biting on human posture control.

Several studies have confirmed the neuromuscular effects of jaw motor activity on the postural stability of humans, but the mechanisms of functional coupling of the craniomandibular system (CMS) with human posture are not yet fully understood. The purpose of our study was, therefore, to investigate whether submaximum biting affects the kinematics of the ankle, knee, and hip joints and the electromyographic (EMG) activity of the leg muscles during bipedal narrow stance and single-leg stance. Twelve healthy young subjects performed force-controlled biting (FB) and non-biting (NB) during bipedal narrow stance and single-leg stance. To investigate the effects of FB on the angles of the hip, knee, and ankle joints, a 3D motion-capture system (Vicon MX) was used. EMG activity was recorded to enable analysis of the coefficient of variation of the muscle co-contraction ratios (CVR) of six pairs of postural muscles. Between FB and NB, no significant differences were found for the mean values of the angles of the ankle, knee, and hip joints, but the standard deviations were significantly reduced during FB. The values of the ranges of motion and the mean angular velocities for the three joints studied revealed significant reduction during FB also. CVR was also significantly reduced during FB for five of the six muscle pairs studied. Although submaximum biting does not change the basic strategy of posture control, it affects neuromuscular co-contraction patterns, resulting in increased kinematic precision.

Force-controlled biting alters postural control in bipedal and unipedal stance.

Human posture is characterised by inherent body sway which forces the sensory and motor systems to counter the destabilising oscillations. Although the potential of biting to increase postural stability has recently been reported, the mechanisms by which the craniomandibular system (CMS) and the motor systems for human postural control are functionally coupled are not yet fully understood. The purpose of our study was, therefore, to investigate the effect of submaximum biting on postural stability and on the kinematics of the trunk and head. Twelve healthy young adults performed force-controlled biting (FB) and non-biting (NB) during bipedal narrow stance and single-leg stance. Postural stability was quantified on the basis of centre of pressure (COP) displacements, detected by use of a force platform. Trunk and head kinematics were investigated by biomechanical motion analysis, and bite forces were measured using a hydrostatic system. The results revealed that FB significantly improved postural control in terms of reduced COP displacements, providing additional evidence for the functional coupling of the CMS and human posture. Our study also showed, for the first time, that reductions in the sway of the COP were accompanied by reduced trunk and head oscillations, which might be attributable to enhanced trunk stiffness during FB. This physiological response to isometric activation of the masticatory muscles raises questions about the potential of oral motor activity as a strategy to reduce the risk of falls among the elderly or among patients with compromised postural control.

The effect of experimental balancing interferences on masticatory performance.

Immediate adaptation to experimental-balancing interferences is known to affect jaw kinematics and electromyographic activity (EMG). However, little is known about the influence on masticatory performance parameters. This study hypothesises that balancing-side interferences significantly reduce the performance of the masticatory system. Twenty-one healthy subjects (eleven female, mean age: 24.1 ± 1.2 years) chewed standardised silicone cubes performing 15 masticatory cycles on the right side under three experimental conditions: (i) natural dentition (ND), (ii) splints with structured occlusal profiles (SS) (iii) splints with balancing interferences in the left molar region (OI). The particle size distribution was determined by a validated scanning procedure and curve fitted with the Rosin-Rammler function to determine X(50)-values. The EMG of both temporalis and masseter muscles was recorded simultaneously, and the total muscle work (TMW) was calculated. A jaw-tracking device recorded the incisal movement path (IMP). The functional parameters under the experimental conditions were compared by repeated-measures analysis of variance. The findings confirm our hypothesis. The X(50)-values differed significantly (P < 0.01) between ND and OI (4.34 vs. 4.60 mm), and between SS and OI (4.34 vs. 4.60 mm), respectively. In contrast, no significant differences (P > 0.05) were observed between SS and ND. There was no significant difference in both TMW (1269.0 vs. 1284.9 vs. 1193.9 µV*s) and IMP (720.2 vs. 735.3 vs. 723.1 mm) amongst the three conditions (P > 0.05). These findings confirm the assumption that the disturbance of the habitual chewing cycles by balancing-side interferences significantly reduces the masticatory performance in the short term. Occlusal balancing-side interferences are common technical failures of dental restorations. Simulation of this condition caused deterioration of masticatory performance in healthy young adults. Further studies should be carried out, on whether the observed effect is long-term and whether masticatory performance decreases even more in patients with reduced adaptive capacity.

Localised task-dependent motor-unit recruitment in the masseter.

Localised motor-unit (MU) recruitment in the masseter was analysed in this study. We investigated whether differential activation behaviour, which has already been reported for distant masseter regions, can also be detected in small muscle subvolumes at the level of single MUs. Two bipolar fine-wire electrodes and an intra-oral 3D bite-force transmitter were used to record intra-muscular electromyograms (EMG) resulting from controlled bite-forces of 10 healthy human subjects (mean age 24.1 ± 1.2 years). Two-hundred and seventeen decomposed MUs were organised into localised MU task groups with different (P < 0.001) force-direction-specific behaviour. Proportions of MUs involved in one, two, three or four examined tasks were 46%, 31%, 18% and 5%, respectively. This study provides evidence of the ability of the neuromuscular system to modify the mechanical output of small masseter subvolumes by differential control of adjacent MUs belonging to distinct task groups. Localised differential activation behaviour of the masseter may be the crucial factor enabling highly flexible and efficient adjustment of the muscle activity in response to complex local biomechanical needs, for example, continually varying bite-forces during the demanding masticatory process.