RESUMEN
Due to natural abundance, low cost, and compatibility with sustainable green technology, Mg3Sb2-based Zintl compounds are comprehensively explored as potential thermoelectric materials for near-room temperature applications. The effective use of these materials in thermoelectric devices requires both p and n-type Mg3Sb2 having comparable thermoelectric efficiency. However, p-type Mg3Sb2 has inferior thermoelectric efficiency efficiency compared to its n-type counterpart due to low electrical conductivity (â¼103Sm-1). Here, we show that codoping of monovalent atoms (Li-Ag, and Na-Ag) at the Mg site of Mg3Sb2 produces a synergistic effect and boosts the electrical conductivity, which enhances the thermoelectric properties of p-type Mg3Sb2. While, Ag prefers to occupy the Mg2 site, Li and Na are favorable at the Mg1 site of Mg3Sb2 lattice. Compared to Li-Ag codoping, Na-Ag codoping in Mg3Sb2 is found to be more effective for increasing the charge carrier concentration and significantly augmenting the electrical conductivity. The dominance of the three-phonon scattering mechanism in Li and Li-Ag doped Mg3Sb2 and the four-phonon scattering process for the Na and Na-Ag doped Mg3Sb2 are confirmed. Due to the simultaneous increase in electrical conductivity and decrease in thermal conductivity, the zT value â¼0.8 at 675 K achieved for Mg2.975Na0.02Ag0.005Sb2 is the highest value among p-type Mg3Sb2. Our work shows a constructive approach to enhance the zT of p-type Mg3Sb2 via monovalent atoms codoping at the Mg sites.
RESUMEN
The advantage of secondary-phase induced carrier filtering on the thermoelectric properties has paved the way for developing cost-effective, highly efficient thermoelectric materials. Here, we report a very high thermoelectric figure-of-merit of skutterudite nanocomposites achieved by tailoring interface carrier filtering. The single-filled skutterudite nanocomposites are prepared by dispersing rare-earth oxides nanoparticles (Yb2O3, Sm2O3, La2O3) in the skutterudite (Dy0.4Co3.2Ni0.8Sb12) matrix. The nanoparticles/skutterudite interfaces act as efficient carrier filters, thereby significantly enhancing the Seebeck coefficient without compromising the electrical conductivity. As a result, the highest power factor of â¼6.5 W/mK2 is achieved in the skutterudite nanocomposites. The nonuniform strain distribution near the nanoparticles due to the local lattice misfit and concentration fluctuations affect the heat carriers and thereby reduce the lattice thermal conductivity. Moreover, the three-dimensional atom probe analysis reveals the formation of Ni-rich grain boundaries in the skutterudite matrix, which also facilitates the reduction of lattice thermal conductivity. Both the factors, i.e., the reduction in lattice thermal conductivity and the enhancement of the power factor, lead to an enormous increase in ZT up to â¼1.84 at 723 K and an average ZT of about 1.56 in the temperature range from 523 to 723 K, the highest among the single-filled skutterudites reported so far.
RESUMEN
We report the evolution of the thermoelectric and mechanical properties of n-type SnSe obtained by iodine doping at the Se site. The thermoelectric performance of n-type SnSe is detailed in the temperature range starting from 150 K ≤ T ≤ 700 K. The power factor of 0.25% iodine doped SnSe is found to be 0.33 mW m-1 K-2 at 700 K, comparable to that of the other monovalent doped n-type SnSe. The temperature-dependent electrical conductivity of the undoped and iodine doped SnSe samples is corroborated by using the adiabatic small polaron hopping model. A very low value of thermal conductivity, 0.62 W m-1 K-1, is obtained at 300 K and is comparable to that of SnSe single crystals. The low thermal conductivity of n-type polycrystalline SnSe is understood by taking into account the anharmonic phonon vibrations induced by the incorporation of heavy iodine atoms at the Se sites as well as the structural hierarchy of the compound. Besides, iodine doping is found to improve the reduced Young's modulus and hardness values of SnSe, which is highly desirable for thermoelectric device applications.