RESUMEN
A flexible supercapacitor (SC) is an attractive energy storage device for powering low-power sensors, since it can be built using only nontoxic and sustainable materials. In this study, the advantages of using biodegradable polylactic acid (PLA) substrate for printed SC are investigated by studying the SC's cyclic bending reliability, failure mechanism, and the impact of the bending radius. The results confirm that the SCs with laminated PLA with polymer barrier substrate exhibited the highest bending reliability, stability, and capability in preventing liquid electrolyte evaporation among the investigated substrates. Besides, the reliability decreased with the decreasing bending radius only when the strongly impacted areas lie on the electrode, the flaking and cracking of which was found to be the failure mechanisms of the tested SCs, except for the SCs with PLA/Al substrate, which failed due to the Al cracking. This research suggests that using PLA/barrier substrate, developing more robust activated carbon electrodes, developing cellulose paper with more dense fiber structure and smaller porous areas, and controlling the bending radius are crucial to improving the SC's reliability.
RESUMEN
Understanding the phenomena at interfaces is crucial for producing efficient and stable flexible organic solar cell modules. Minimized energy barriers enable efficient charge transfer, and good adhesion allows mechanical and environmental stability and thus increased lifetime. We utilize here the inverted organic solar module stack and standard photoactive materials (a blend of poly(3-hexylthiophene) and [6,6]-phenyl C61 butyric acid methyl ester) to study the interfaces in a pilot scale large-area roll-to-roll (R2R) process. The results show that the adhesion and work function of the zinc oxide nanoparticle based electron transport layer can be controlled in the R2R process, which allows optimization of performance and lifetime. Plasma treatment of zinc oxide (ZnO) nanoparticles and encapsulation-induced oxygen trapping will increase the absolute value of the ZnO work function, resulting in energy barriers and an S-shaped IV curve. However, light soaking will decrease the zinc oxide work function close to the original value and the S-shape can be recovered, leading to power conversion efficiencies above 3%. We present also an electrical simulation, which supports the results. Finally, we study the effect of plasma treatment in more detail and show that we can effectively remove the organic ligands around the ZnO nanoparticles from the printed layer in a R2R process, resulting in increased adhesion. This postprinting plasma treatment increases the lifetime of the R2R printed modules significantly with modules retaining 80% of their efficiency for â¼3000 h in accelerated conditions. Without plasma treatment, this efficiency level is reached in less than 1000 h.