A Rapid Quantitative Analysis of Bicomponent Fibers Based on Cross-Sectional In-Situ Observation.

To accelerate the industrialization of bicomponent fibers, fiber-based flexible devices, and other technical fibers and to protect the property rights of inventors, it is necessary to develop fast, economical, and easy-to-test methods to provide some guidance for formulating relevant testing standards. A quantitative method based on cross-sectional in-situ observation and image processing was developed in this study. First, the cross-sections of the fibers were rapidly prepared by the non-embedding method. Then, transmission and reflection metallographic microscopes were used for in-situ observation and to capture the cross-section images of fibers. This in-situ observation allows for the rapid identification of the type and spatial distribution structure of the bicomponent fiber. Finally, the mass percentage content of each component was calculated rapidly by AI software according to its density, cross-section area, and total test samples of each component. By comparing the ultra-depth of field microscope, differential scanning calorimetry (DSC), and chemical dissolution method, the quantitative analysis was fast, accurate, economical, simple to operate, energy-saving, and environmentally friendly. This method will be widely used in the intelligent qualitative identification and quantitative analysis of bicomponent fibers, fiber-based flexible devices, and blended textiles.

Modified Fabrication of Perovskite-Based Composites and Its Exploration in Printable Humidity Sensors.

Organic perovskites are promising optoelectronic semiconductor materials with photoelectric applications. It is known that the luminescence of perovskites is highly sensitive to hydron molecules due to its low moisture resistance of crystal structure, indicating its potential application on humidity-sensing. Herein, a novel perovskite-based compound (PBC) with minimal defects was developed to promote the photoluminescence performance via optimization of the drying method and precursor constitutions. Perovskite materials with good structural integrity and enhanced fluorescence performance up to four times were obtained from supercritical drying. Moreover, the hydrophilic polymer matrix, polyethylene oxide (PEO), was added to obtain a composite of perovskite/PEO (PPC), introducing enhanced humidity sensitivity and solution processibility. These perovskite/PEO composites also exhibited long-term stability and manifold cycles of sensitivity to humidity owing to perovskite encapsulation by PEO. In addition, this precursor solution of perovskite-based composites could be fancily processed by multiple methods, including printing and handwriting, which demonstrates the potential and broaden the applications in architecture decoration, logos, trademarks, and double encryption of anti-fake combined with humidity.

Tough, Highly Oriented, Super Thermal Insulating Regenerated All-Cellulose Sponge-Aerogel Fibers Integrating a Graded Aligned Nanostructure.

Thermal insulating fibers can effectively regulate the human body temperature and decrease indoor energy consumption. However, designing super thermal insulating fibers integrating a sponge and aerogel structure based on biomass resources is still a challenge. Herein, a flow-assisted dynamic dual-cross-linking strategy is developed to realize the steady fabrication of regenerated all-cellulose graded sponge-aerogel fibers (CGFs) in a microfluidic chip. The chemically cross-linked cellulose solution is used as the core flow, which is passed through two sheath flow channels, containing either a diffusion solvent or a physical cross-linking solvent, resulting in CGFs with a porous sponge outer layer and a dense aerogel inner layer. By regulating and simulating the flow process in the microfluidic chip, CGFs with adjustable sponge thicknesses, excellent toughness (26.20 MJ m-3), and ultralow thermal conductivity (0.023 W m-1 K-1) are fabricated. This work provides a new method for fabricating graded biomass fibers and inspires attractive applications for thermal insulation in textiles.

Thermosensitive Injectable Chitosan/Collagen/ß-Glycerophosphate Composite Hydrogels for Enhancing Wound Healing by Encapsulating Mesenchymal Stem Cell Spheroids.

Chronic wounds caused by diabetic or venous diseases remain a social and healthcare burden. In this work, a new strategy is proposed in which injectable thermosensitive chitosan/collagen/ß-glycerophosphate (ß-GP) hydrogels were combined with three-dimensional mesenchymal stem cell (3D MSC) spheroids to accelerate chronic wound healing by enhanced vascularization and paracrine effects. Chitosan/collagen/ß-GP solution mixed with 3D MSC spheroids was rapidly transformed to a gel at body temperature by physical cross-linking, then overlapped the wounds fully and fitted to any shape of the wound. The results showed that the combination therapy exhibited a markedly therapeutic effect than the hydrogel-loaded two-dimensional (2D) MSCs or 2D MSCs alone. The hydrogel could provide an environment conductive to the attachment and proliferation of encapsulated MSCs, especially accelerating the proliferation and paracrine factor secretion of 3D MSC spheroids. These results supplied a novel alternative approach to treat chronic wounds caused by diabetic or venous diseases.

Conductive and Elastic 3D Helical Fibers for Use in Washable and Wearable Electronics.

Due to the intrinsic properties of fabrics, fabric-based wearable systems have certain advantages over elastomeric material-based stretchable electronics. Here, a method to produce highly stretchable, conductive, washable, and solderable fibers that consist of elastic polyurethane (PU) fibers and conductive Cu fibers, which are used as interconnects for wearable electronics, is reported. The 3D helical shape results from stress relaxation of the prestretched PU fiber and the plasticity of the Cu fiber, which provides a predictable way to manipulate the morphology of the 3D fibers. The present fibers have superior mechanical and electrical properties to many other conductive fibers fabricated through different approaches. The 3D helical fibers can be readily integrated with fabrics and other functional components to build fabric-based wearable systems.

PVAm Nanofibers Fabricated by Rotary Jet Wet Spinning and Applied to Bisphenol A Recognition.

Poly(vinylamine) (PVAm) is an important polymer with the highest content of primary amine groups of any polymer. PVAm has a great potential in selective separation and smart materials. It is difficult to fabricate pure PVAm nanofibers by electrospinning and rotary jet spinning (RJS) without additional polymers. In this work, rotary jet wet spinning (RJWS) was applied to fabricate molecular imprinting nanofibers (MINFs) with polyelectrolyte for the first time. Initially, optimal parameters of spinning are investigated, including coagulation bath, solution viscosity, and rotation speed. The PVAm aqueous solution is sensitive to alcohol. To demonstrate RJWS application, PVAm-based MINFs for bisphenol A (one endocrine disruptor) recognition are prepared by adding dummy template, cross-linking, and template elution. The association constant (8.6 mg/L), equilibrium time (30 min), and binding sites utilization rate (80%) of MINFs are evaluated. Its adsorption amount and selectivity are little lower than those of MIPs prepared by bulk polymerization; however, its adsorption speed is faster than that of MIPs.

Lipid accumulation responses in the liver of Rana nigromaculata induced by perfluorooctanoic acid (PFOA).

Perfluorooctanoic acid (PFOA) is a perfluorinated compound that is widely distributed, is persistent in the environment, and has a low-level chronic exposure effect on human health. The aim of this study was to investigate the peroxisome proliferator activated receptors γ (PPARγ) and the sterol regulatory element-binding protein 2 (SREBP2) signaling pathways in regulating the lipid damage response to PFOA in the livers of amphibians. Male and female frogs (Rana nigromaculata) were exposed to 0, 0.01, 0.1, 0.5 and 1 mg/L PFOA. After treatment, we evaluated the pathological changes in the liver by Oil Red O, staining and examined the total cholesterol (T-CHO) and triglyceride (TG) contents. The mRNA expression levels of PPARγ, Fatty acid synthase (FAS), Acetyl-CoA carboxylase (ACC), Glycerol-3-phosphate acyltransferase (GPAT), SREBP2 and 3-hydroxy-3-methylglutaryl CoA (HMG-CoA) were measured by quantitative real-time polymerase chain reaction (qRT-PCR). The administration of PFOA caused marked lipid accumulation damage in the amphibian livers. The T-CHO contents were elevated significantly after PFOA treatment; these results show a dose-dependent manner in both sexes. The TG content showed a significant increase in male livers, while it was elevated significantly in female livers. The RT-PCR results showed that the mRNA expression levels of PPARγ, ACC, FAS, GPAT, SREBP2 and HMG-CoA were significantly dose-dependently increased in the PFOA-treated groups compared with those of the control group. Our results demonstrated that PFOA-induced lipid accumulation also affected the expression levels of genes FAS, ACC, GPAT and HMG-CoA in the PPARγ and SREBP2 signaling pathways in the liver. These finding will provide a scientific theoretical basis for the protection of Rana nigromaculata against PFOA effects.

Role of the Nrf2-ARE pathway in perfluorooctanoic acid (PFOA)-induced hepatotoxicity in Rana nigromaculata.

Perfluorooctanoic acid (PFOA) is widely distributed in various environmental media and is toxic to organisms. This study demonstrated that PFOA induces hepatotoxicity in the frog and evaluated the role of CYP3A and the Nrf2-ARE signaling pathway in regulating responses to PFOA-induced hepatotoxicity. Rana nigromaculata were exposed to 0, 0.01, 0.1, 0.5, or 1 mg/L PFOA solutions in a static-renewal system for 14 days. Liver tissue samples were collected 24 h after the last treatment. Hepatic histology was observed by HE staining and transmission electron microscopy. The oxidative stress levels in the liver were measured. The expression levels of CYP3A, Nrf2, NQO1, and HO-1 mRNA were measured by quantitative reverse transcription-polymerase chain reaction. PFOA-treated frog liver tissue exhibited diffuse cell borders, cytoplasmic vacuolization, broken nuclei, nuclear chromatin margination, and swollen mitochondria. In addition, the livers of PFOA-treated frogs showed a significantly elevated content of reactive oxygen species, malondialdehyde, glutathione and glutathione S-transferase activity compared to the livers of control frogs. However, the glutathione peroxidase activities concomitantly decreased in PFOA-treated frogs compared to those in the control group. Furthermore, compared with control frogs, the expression levels of CYP3A, Nrf2, and NQO1 mRNA significantly increased in PFOA-treated frogs. HO-1 mRNA expression remarkably increased only in groups treated with 0.5 or 1 mg/L PFOA. Our results indicate that PFOA induces hepatotoxicity in a dose-dependent manner. Furthermore, the results of the comparison analysis between different gender groups illustrated that PFOA is more toxic to female frogs than male frogs. Our results demonstrated that PFOA causes liver damage and that CYP3A enhances PFOA-induced female frogs hepatotoxicity are more virulent than male through biotransformation, and the activation of the Nrf2-ARE pathway is induced to protect against hepatotoxicity in Rana nigromaculata, all of which provide the scientific basis for the protection of amphibians against environmental contaminants.

Effects of MCLR exposure on sex hormone synthesis and reproduction-related genes expression of testis in male Rana nigromaculata.

Microcystin-leucine-arginine (MCLR) is the most popular and toxic variant among microcystins, which can cause severe reproductive toxicity to animals. However, the mechanisms of reproductive toxicity induced by MCLR in amphibians are still not entirely clear. In the current study, toxicity mechanisms of MCLR on the reproductive system of male Rana nigromaculata followed by low concentration (0, 0.1, 1, and 10 µg/L) and short-term (0, 7, and 14 days) MCLR exposure were shown. It was observed that MCLR could be bioaccumulated in the testes of male frogs, and the theoretical bioaccumulation factor values were 0.24 and 0.19 exposed to 1 µg/L and 10 µg/L MCLR for 14 days, respectively. MCLR exposure significantly decreased testosterone (T) concentrations and increased estradiol (E2) concentrations exposed to 1 and 10 µg/L MCLR for 14 days. The mRNA levels of HSD17B3 were downregulated, and HSD17B1 and CYP19A1 mRNA expression levels were upregulated, respectively. Only 10 µg/L MCLR group showed significant induction of follicle-stimulating hormone (FSH) levels and cyclic adenosine monophosphate (cAMP) content. Moreover, AR and ESR1 mRNA expression levels were significantly upregulated exposed to 1 and 10 µg/L MCLR for 14 days, respectively. Our results suggested that low-concentration MCLR induced transcription changes of CYP19A1, HSD17B3, and HSD17B1 led to endocrine disorders, and caused interference of spermatogenesis by the decrease of T and abnormal gene expressions of AR and ESR1 in the testes of R. nigromaculata.

Regulatory effect of quercetin on hazardous microcystin-LR-induced apoptosis of Carassius auratus lymphocytes in vitro.

Microcystins (MCs) are secondary metabolites produced by cyanobacteria. Oxidative stress is considered the major cytotoxic mechanism of microcystin-LR (MCLR). Quercetin (QE) is a flavonoid that can eliminate reactive oxygen species (ROS) and elicit anti-inflammatory and anti-apoptotic effects. This study determined the regulatory effect of QE on the cytotoxicity and oxidative stress of Carassius auratus lymphocytes induced by 1 µg/L MCLR in vitro after 24 h. MCLR-mediated cytotoxicity and ROS formation in fish lymphocytes were suppressed by QE in a concentration-dependent manner. In addition, QE enhanced the endogenous antioxidant defense system and the Bax/Bcl-2 ratio to protect fish lymphocytes against oxidative stress and apoptosis induced by MCLR. Glutathione levels and catalase activities increased by approximately 3.9- and 2-fold, respectively, in the QE treatment group (1000 µg/L) compared with the MCLR treatment group. The percentage of apoptosis in the only MCLR treatment group was 59% whereas that in the control group was 23%. The percentage of apoptosis in the high-dose QE treatment group (1000 µg/L) was 29%, lower by nearly half compared with the only MCLR treatment group. QE (1000 µg/L) effectively inhibited the expression of caspase-3 protein by nearly 43% compared with the only MCLR treatment group. The results obtained clearly indicate that QE can effectively prevent MCLR-induced immunotoxicity by eliminating oxidative stress and blocking the mitochondrial apoptotic pathway in fish lymphocytes.