RESUMEN
BACKGROUND: The leaves of Elaeagnus angustifolia, belonging to the Elaeagnaceae Juss. family, are known for their medicinal properties for relieving cough and asthma, as well as treating dysentery and diarrhea. OBJECTIVE: To establish a rapid qualitative method for the detection of secondary metabolites in leaves of Elaeagnus angustifolia, including the identification and analysis of various secondary metabolites in leaves of Elaeagnus angustifolia. METHOD: Samples were separated using a Waters ACQUITY H-Class ultra-performance liquid chromatography (UPLC) system (FTN autosampler, quaternary LC pump) and ACQUITY UPLC® BEH C18 column (1.7 µm, 2.1 mm× 100 mm). The flow rate was set to 0.4 mL/min, the injection volume was 1.0 µL, and the column temperature was set to 45 °C. The mobile phase was methanol (A) with) -0.1% formic acid in water (B). Samples were analyzed by quadrupole time-of-flight mass spectrometry (Q-TOF-MS). RESULTS: A total of 182 different secondary metabolites were detected from 10 varieties of leaves of Elaeagnus angustifolia, including 77 flavonoids, 20 steroids, 7 alkaloids, 15 amino acids, 18 organic acids, and 45 other compound types. CONCLUSIONS: A method for the rapid analysis of leaves of Elaeagnus angustifolia by UPLC-Q-TOF-MS was established, and the secondary metabolites in leaves of Elaeagnus angustifolia were identified. The enrichment of secondary metabolites in leaves of different varieties of Elaeagnus angustifolia was clarified. HIGHLIGHTS: The UPLC-Q-TOF-MS method is very fast and possesses a high degree of selectivity, precision, and sensitivity. These findings provide a reliable foundation for the development of medicinal resources derived from Elaeagnus angustifolia leaves.
RESUMEN
We investigated a prototype virtual-pinhole positron emission tomography (PET) system for small-animal imaging applications. The PET detector modules were made up of 1.3 mm lutetium-yttrium oxyorthosilicate (LYSO) arrays, and the insert detectors consisted of 0.6 mm pixelated cadmium zinc telluride (CdZnTe). To validate the imaging experiment, we did a Monte Carlo simulation for the virtual-pinhole PET (VP-PET) system in the Geant4 Application for Emission Tomography (GATE). For a point source of 22Na with a 0.5 mm diameter, the filtered back-projection algorithm-reconstructed PET image showed a resolution of 0.7 mm full-width-at-half-maximum. The system sensitivity was 0.46 cps/kBq at the center of the field view of the PET system with a source activity of 0.925 MBq and an energy window of 350 to 650 keV. A rod source phantom and a Derenzo phantom with 18F were also simulated to investigate the PET imaging ability. GATE simulation indicated that sources with 0.5 mm diameter could be clearly detected using 0.6 mm pixelated CdZnTe detectors as insert devices in a VP-PET system.
RESUMEN
This study aims to further identify the biological effects of neutron-irradiated plants and provides insights into the mutation breeding of such plants. In this study, the neutron irradiation device designed by our institute was used to analyze the relationship between the seed components in different legume crops and their neutron absorption dose rate, fission gamma absorption dose rate, and induced gamma absorption dose rate. The results show that the effect sizes of the components on the neutron absorbed dose rate are as follows: ash > fat > moisture > carbohydrate > protein. The effect sizes of the components on the absorbed dose rate of fission gamma are as follows: ash > moisture > fat > carbohydrate > protein. There is a positive correlation between fission gamma absorbed dose rate and the weight of ash, water and fat, while a negative correlation with carbohydrate and protein. However, the linear relationship between each component and the absorbed dose rate of induced gamma is not significant, this needs to be identified by further researches. Based on the results of the present study, we conclude that the neutron absorbed dose can be calculated without taking into account the fat composition of bean crop seeds (except for soybean seeds) in the process of mutation breeding induced by radiation. In special cases where the accuracy requirement of the dose rate is not high, it is possible to use protein instead of legume crop seeds for neutron absorption dose calculations.
Asunto(s)
Californio/análisis , Neutrones , Phaseolus/química , Phaseolus/efectos de la radiación , Semillas/química , Semillas/efectos de la radiación , Dosis de RadiaciónRESUMEN
We are currently investigating the feasibility of using highly pixelated Cadmium Zinc Telluride (CdZnTe) detectors for sub-500 µm resolution PET imaging applications. A 20 mm × 20 mm × 5 mm CdZnTe substrate was fabricated with 350 µm pitch pixels (250 µm anode pixels with 100 µm gap) and coplanar cathode. Charge sharing among the pixels of a 350 µm pitch detector was studied using collimated 122 keV and 511 keV gamma ray sources. For a 350 µm pitch CdZnTe detector, scatter plots of the charge signal of two neighboring pixels clearly show more charge sharing when the collimated beam hits the gap between adjacent pixels. Using collimated Co-57 and Ge-68 sources, we measured the count profiles and estimated the intrinsic spatial resolution of 350 µm pitch detector biased at -1000 V. Depth of interaction was analyzed based on two methods, i.e., cathode/anode ratio and electron drift time, in both 122 keV and 511 keV measurements. For single-pixel photopeak events, a linear correlation between cathode/anode ratio and electron drift time was shown, which would be useful for estimating the DOI information and preserving image resolution in CdZnTe PET imaging applications.
RESUMEN
We are investigating the feasibility of a high resolution positron emission tomography (PET) insert device based on the CdZnTe detector with 350 µm anode pixel pitch to be integrated into a conventional animal PET scanner to improve its image resolution. In this paper, we have used a simplified version of the multi pixel CdZnTe planar detector, 5 mm thick with 9 anode pixels only. This simplified 9 anode pixel structure makes it possible to carry out experiments without a complete application-specific integrated circuits readout system that is still under development. Special attention was paid to the double pixel (or charge sharing) detections. The following characteristics were obtained in experiment: energy resolution full-width-at-half-maximum (FWHM) is 7% for single pixel and 9% for double pixel photoelectric detections of 511 keV gammas; timing resolution (FWHM) from the anode signals is 30 ns for single pixel and 35 ns for double pixel detections (for photoelectric interactions only the corresponding values are 20 and 25 ns); position resolution is 350 µm in x,y-plane and â¼0.4 mm in depth-of-interaction. The experimental measurements were accompanied by Monte Carlo (MC) simulations to find a limitation imposed by spatial charge distribution. Results from MC simulations suggest the limitation of the intrinsic spatial resolution of the CdZnTe detector for 511 keV photoelectric interactions is 170 µm. The interpixel interpolation cannot recover the resolution beyond the limit mentioned above for photoelectric interactions. However, it is possible to achieve higher spatial resolution using interpolation for Compton scattered events. Energy and timing resolution of the proposed 350 µm anode pixel pitch detector is no better than 0.6% FWHM at 511 keV, and 2 ns FWHM, respectively. These MC results should be used as a guide to understand the performance limits of the pixelated CdZnTe detector due to the underlying detection processes, with the understanding of the inherent limitations of MC methods.