Fluram-Kemptide-Lys8 Non-radioactive Assay for Protein Kinase A.

The cAMP-dependent protein kinase (PKA) is the best understood member of the superfamily of serine-threonine protein kinases and is involved in controlling a variety of cellular processes. Measurements of PKA activity traditionally relied on the use of [(32)P]-labeled ATP as the phosphate donor and a protein or peptide substrate as the phosphoaceptor. Recently non-isotopic assays for the PKA have been developed and this paper presents an improvement of a fluorometric assay for measuring the activity of PKA. Three peptides were synthesized with the following sequences: LRRASLG (Kemptide), LRRASLGK (Kemptide-Lys8) and LRRASLGGGLRRASLG (Bis-Kemptide), these have in common the substrate sequence recognized by the PKA (RRXS/TΨ), where X is any amino acid and Ψ is a hydrophobic amino acid. Optimal conditions were established for the non-radioactive assay to detect the PKA activity by phosphorylation of these three peptides that are covalently linked to fluorescamine at their N-terminus. The phosphorylated and non-phosphorylated peptides were easily separated by electrophoresis, identified and quantified with optical densitometry and ultraviolet light. The fluorescamine-labeled Kemptide-Lys8 substrate (Fluram-Kemptide-Lys8) was used to calculate the Km and Vmax of the catalytic subunit of PKA from pig heart and showed a detection limit of 260 pmol, a linear range between 700 and 1150 pmol with a linear regression R (2) = 0.956.

Titration of lysine residues on adenine nucleotide translocase by fluorescamine induces permeability transition.

Chemical modification of primary amino groups of mitochondrial membrane proteins by the fluorescent probe fluorescamine induces non-specific membrane permeabilisation. Titration of the lysine ϵ-amino group promoted efflux of accumulated Ca(2+), collapse of transmembrane potential and mitochondrial swelling. Ca(2+) release was inhibited by cyclosporin A. Considering the latter, we assumed that fluorescamine induces permeability transition. Carboxyatractyloside also inhibited the reaction. Using a polyclonal antibody for adenine nucleotide translocase, Western blot analysis showed that the carrier appeared labelled with the fluorescent probe. The results point out the importance of the ϵ-amino group of lysine residues, located in the adenine nucleotide carrier, on the modulation of membrane permeability, since its blockage suffices to promote opening of the non-specific nanopore.

Sample stacking in CZE using dynamic thermal junctions I. Analytes with low dpKa/dT crossing a single thermally induced pH junction in a BGE with high dpH/dT.

The possibility to compress analyte bands at the beginning of CE runs has many advantages. Analytes at low concentration can be analyzed with high signal-to-noise ratios by using the so-called sample stacking methods. Moreover, sample injections with very narrow initial band widths (small initial standard deviations) are sometimes useful, especially if high resolutions among the bands are required in the shortest run time. In the present work, a method of sample stacking is proposed and demonstrated. It is based on BGEs with high thermal sensitive pHs (high dpH/dT) and analytes with low dpK(a)/dT. High thermal sensitivity means that the working pK(a) of the BGE has a high dpK(a)/dT in modulus. For instance, Tris and Ethanolamine have dpH/dT=-0.028/ degrees C and -0.029/ degrees C, respectively, whereas carboxylic acids have low dpK(a)/dT values, i.e. in the -0.002/ degrees C to+0.002/ degrees C range. The action of cooling and heating sections along the capillary during the runs affects also the local viscosity, conductivity, and electric field strength. The effect of these variables on electrophoretic velocity and band compression is theoretically calculated using a simple model. Finally, this stacking method was demonstrated for amino acids derivatized with naphthalene-2,3-dicarboxaldehyde and fluorescamine using a temperature difference of 70 degrees C between two neighbor sections and Tris as separation buffer. In this case, the BGE has a high pH thermal coefficient whereas the carboxylic groups of the analytes have low pK(a) thermal coefficients. The application of these dynamic thermal gradients increased peak height by a factor of two (and decreased the standard deviations of peaks by a factor of two) of aspartic acid and glutamic acid derivatized with naphthalene-2,3-dicarboxaldehyde and serine derivatized with fluorescamine. The effect of thermal compression of bands was not observed when runs were accomplished using phosphate buffer at pH 7 (negative control). Phosphate has a low dpH/dT in this pH range, similar to the dK(a)/dT of analytes. It is shown that mid R:dK(a)/dT-dpH/dTmid R>>0 is one determinant factor to have significant stacking produced by dynamic thermal junctions.

Performance of an ultraviolet light-emitting diode-induced fluorescence detector in capillary electrophoresis.

The performance of a fluorescence detector in capillary electrophoresis (CE) using a light-emitting diode (LED) as excitation source is reported. An ultraviolet LED pulsed at a repetition rate of 500 Hz, combined with a time-discrimination and averaging acquisition system, was used. Limits of detection of 3 and 18 fmoles (at a signal-to-noise ratio equal to 3) were achieved for fluorescamine-derivatized bradykinin and lysine, respectively. This system exhibited a linear response for a concentration range between 54 and 417 microM for derivatized lysine, and between 1.81 and 23.58 microM for derivatized bradykinin. This detection system showed to be very convenient for routine analytical applications.

Separación de aminoácidos mediante cromatografía líquida de alta resolución / Amino acid analysis by high-performance liquid chromatography

Se presenta una compilación de la aplicación de la cromatografía líquida de alta resolución en el análisis de aminoácidos. Se analizan las formas de derivatización, se comparan los distintos derivados según sus alcances y limitaciones, la forma de detección y los distintos modos cromatográficos: cromatografía de intercambio iónico, cromatografía en fase normal, cromatografía en fase reversa y cromatografía en fase quiral. También se presentan los métodos automatizados comerciales más recientes para este tipo de análisis. Se dan ejemplos de aplicación de interés en el campo clínico-bioquímico, con el análisis de muestras de líquido cafalorraquídeo, de orina y de plasma/sangre o manchas de sangre seca. El análisis de los aminoácidos de hidrolizados de proteínas y de péptidos resulta más complejo y las condiciones de hidrólisis juegan un rol muy importante en los resultados, que son tratados en esta compilación. Se incluyen, además, aspectos referidos al análisis de los aminoácidos lábiles en proteínas, la preparación de las muestras, las recomendaciones prácticas al hacer HPLC y la influencia de los buffers

Separación de aminoácidos mediante cromatografía líquida de alta resolución / Amino acid analysis by high-performance liquid chromatography

Se presenta una compilación de la aplicación de la cromatografía líquida de alta resolución en el análisis de aminoácidos. Se analizan las formas de derivatización, se comparan los distintos derivados según sus alcances y limitaciones, la forma de detección y los distintos modos cromatográficos: cromatografía de intercambio iónico, cromatografía en fase normal, cromatografía en fase reversa y cromatografía en fase quiral. También se presentan los métodos automatizados comerciales más recientes para este tipo de análisis. Se dan ejemplos de aplicación de interés en el campo clínico-bioquímico, con el análisis de muestras de líquido cafalorraquídeo, de orina y de plasma/sangre o manchas de sangre seca. El análisis de los aminoácidos de hidrolizados de proteínas y de péptidos resulta más complejo y las condiciones de hidrólisis juegan un rol muy importante en los resultados, que son tratados en esta compilación. Se incluyen, además, aspectos referidos al análisis de los aminoácidos lábiles en proteínas, la preparación de las muestras, las recomendaciones prácticas al hacer HPLC y la influencia de los buffers (AU)