Measurement of Entrance Skin Dose and the Dose Received by Different Organs in Panoramic Dental Imaging.

BACKGROUND: Thermoluminescence dosimetry(TLD) has been known as one of the most effective methods for dose estimation in diagnostic radiology. Orthopantomogram (OPG) imaging is used by many dentists, oral and maxillofacial surgeons as an effective tool for choosing an appropriate treatment plan. OBJECTIVE: This study aims to measure the entrance skin dose and the dose values received by different head and neck organs in OPG imaging using TLD dosimeters (TLD-100). MATERIAL AND METHODS: In this experimental study, the entrance skin dose and doses of various organs during imaging were measured by TLD dosimeters inside and on the surface of the Rando-Phantom. Doses to various organs, including thyroid, eye, esophagus, parotid and sublingual and submandibular salivary glands were measured. The measurements were repeated twice, and the dose values obtained in the two steps were compared. RESULTS: Based on the results obtained in this study, the minimum dose values were found in Esophagus; 65.81, and 59.31 µGy, respectively. The maximum organ dose value was found for left parotid glands, 3842.42, and 3399.58 for the two measurements, respectively. CONCLUSION: The results show that the dose values can vary based on devices, exposure conditions, and TLD positioning.

Effects of Zn rates and application forms on protein and some micronutrients accumulation in common bean (Phaseolus vulgaris L.).

In order to investigation the effects of Zn rates and application forms on protein and element contents (Fe, Cu, Mn, N and Zn) in bean plant, an experiment was conducted as a factorial based on completely randomized design at greenhouse conditions during 2006. Treatments were included zinc rates in 4 levels (10, 20, 30 and 40 mg Zn kg(-1) soil(-1) in ZnSO4 source) and 3 application forms (soil application, seed pelleting and foliar spraying). Results showed that Zn rates had significant effect on accumulation of Zn, Cu, Mn and N in bean leaves. Nitrogen accumulation in leaves reduced with increasing of zinc in the soil. Among Zn application forms, spray application had the highest accumulation of Fe, Zn and Mn in leaves (423.17, 282.89 and 88.17 mg kg(-1), respectively). The highest Zn content in seed was observed in 20 and 40 mg Zn kg(-1) soil(-1) levels (46.39 and 45.62 mg kg(-1), respectively). Meanwhile, all treatments of Zn (both rate and application) had not significant effects on Cu and Mn accumulation in bean seeds. According to interaction effects between Zn rates and application forms, the highest Fe content in seed was observed when 40 mg kg(-1) soil(-1) of Zn was applied as foliar spraying. The seed protein content nearly was stable while Zn levels was increased from 20 to 40 mg Zn kg(-1) soil(-1). Grain yield had significant correlation to zinc and Cu of leaves but, biomass had significant and negative correlation to Zn content of leaves at p < 0.05% probability levels.

Study for determination of industrial water corrosivity in Kashan Fajre Sepahan Galvanizing Mills during 2005-2006 Iran.

This research was carried out in Kashan Fajre Sepahan Galvanizing mills (KFSGM) for evaluation of water corrosivity during 2005-2006. A total of 18 samples were taken from various points of the water supply system for testing the specific parameters and calculation Langelier Index (LI), Ryznar Index (RI) and Pukorious Index (PI). This research showed that in raw water (sand filter effluent) LI were positive as well as RI and PI were lower than 7 which means that mentioned water is not corrosive. Also LI in treated water by reverse osmosis process was negative and RI and PI were higher than 7, so, this water has corrosive properties. Finally, calculated indexes indicate that according to LI, conditioned water is not corrosive but based on RI and P. this water tend to corrosivity which this findings is compatible with literature review statement. So it is recommended that, for water conditioning addition of preservative chemicals to be continued but at the same time another alternatives such as pH adjustment, air stripping and deoxygenating, control of carbonate concentration and split flow treatment should be studied.