Stackable guide in implantology: A technical note.

INTRODUCTION: With the rise of digital workflow, the production of implant guides is becoming increasingly easy and reproducible. The objective is to obtain an optimal correlation between the prosthetic and implant axis to ensuring the "X jaw - one day" concept in the short term and a sustainable technique in a long term TECHNIQUE: This approach requires a strict and rigorous preoperative evaluation. The data recording steps allow a complete visualization of the case and are used to custom the guide. The bone support is surmounted by several stages (positioning guide, drilling guide and the future temporary prosthesis). CONCLUSION: Despite the time-consuming nature, this technique provides a reliable and reproducible protocol for immediate loading without compromising the prosthetic axis.

Autotransplantation with tooth replica: Technical note.

INTRODUCTION: Dental autotransplantation is a surgical procedure that involves the implantation of a tooth with incomplete root development to replace an injured or missing tooth. An initial surgery was performed to attempt orthodontic traction without success after 6 months. TECHNIQUE: Preoperative assessment included mandibular cone beam computed tomography to visualise two canines. The double autotransplantation technique was performed under general anaesthesia using three-dimensional resin-printed dental replicas. The extra-alveolar time for each tooth was reportedly <1 min, and pulp sensibility was observed 3 months later. CONCLUSION: In the digital era, dental autotransplantation has become an essential part of orthodontic-surgical treatment in children and adolescents with dental agenesis or non-preservable teeth. The use of three-dimensional dental replicas printed from radiological data offers a reliable, reproducible, and valid therapeutic solution with an advantageous benefit/risk balance.

Front-block technical note: dental and bone borne distractors.

Orthognathic surgical technique of segmental osteogenesis distraction of the anterior mandible alveolar process (front-block) was introduced by Triaca and al. in 2001 [2] including lower incisors. The technical note describes distraction process used both, dental-borne distractor and bone-borne distractor. A genioplasty plate was used as a bone-borne distractor. The main point here is that distraction depends on two distraction vectors, a dental one and an alveolar one. It provides good stability and controlled segmental osteogenesis translation and allows sufficient alveolar segmental transport without loading the teeth too heavily.