Spot Overtaking of Dyes of Their Chromatographic Development Associated with Solvent Evaporation.

Infiltration of binary solution of hexane and ethanol into chromatography paper associated with their evaporation was found to generate unexpected initial rapid advancement of wicking front followed by its receding and readvancing in our previous research. In the present study, paper chromatography development of hydrophobic dye, Sudan III, and hydrophilic dye, Acid Blue 9, was carried out using binary solutions of hexane and ethanol in open environment, allowing the developing solvent been evaporated. Sudan III was developed with initial rapid advancing wicking front, while Acid Blue 9 was scarcely developed. On the other hand, Acid Blue 9 was developed with the readvancing second wicking front, while the spot of Sudan III scarcely migrated. Thus, the unexpected illusional phenomenon, overtaking the spot of Sudan III by the spot of Acid Blue 9, was observed. The readvancement of the second wicking front was found to be enhanced as increasing the relative humidity in the environment. Surface temperature of the chromatography paper was measured during the chromatographic development in open environment to show that it became lower than the dew point when the experiments were carried out in relatively high humidity. Solubility of Sudan III in a binary solution of ethanol and water remarkably decreased as increasing the content of water. It was thus suggested that the water vapor condensation to induce water mixing into the mobile phase to decrease the solubility of Sudan III to inhibit its chromatographic development to realize the illusional spot overtaking of dyes of their chromatographic development associated with solvent evaporation.

Bifurcation and Transposition of the Wicking Front of Binary Solutions Infiltrating into Chromatography Paper Associated with Their Evaporation.

Nonequilibrium fluid patterns, such as Marangoni contraction, coffee rings, and tears of wine, are generated in binary solutions spread on a substrate during their evaporation. In this study, we observed another type of nonequilibrium behavior exhibited by binary solutions as they infiltrate porous materials and undergo evaporation. A binary solution comprising hexane and ethanol was brought into contact with the chromatography paper to facilitate infiltration into the paper's pores. Because the experimental setup was in an open environment, infiltration and evaporation occurred simultaneously. The wicking front exhibited an initial rapid advancement, followed by subsequent receding and readvancing. Additionally, the bifurcation of the wicking front after the onset of its readvancement was confirmed by monitoring the temporal evolution of the spatial luminance distribution and temperature distribution on the surface of the chromatography paper. Chromatographic development of a hydrophilic dye was conducted in this experimental setup in an open environment. Additionally, it was confirmed that the receding and readvancing of the wicking front represented the transposition of the bifurcated wicking fronts.

New in vitro SPF Evaluation Method for Hydrophilic Sunscreen Samples.

A new method was developed for the in vitro sun protection factor (SPF) evaluation of sunscreen samples. A new type of substrate, a hydroxyalkyl cellulose-coated plate, was also prepared specifically for hydrophilic samples. This new substrate was required because hydrophilic samples would be unlikely to wet the surface of the standard cosmetic PMMA UV evaluation plate. A super-hydrophilic quartz plate was prepared by corona-discharge treatment before an aqueous solution of hydroxyalkyl cellulose was spread on it. A flat and uniform hydroxyalkyl cellulose film was subsequently formed through the evaporation of water. Special care was taken to inhibit the generation of spatial non-uniformity. Six hydrophilic sunscreen samples with in vivo SPF values of 56, 55, 52, 25, 15, and 4, were then applied to the prepared hydroxyalkyl cellulose-coated plate, as well as a super-hydrophilic quartz plate and a flat hydrophobic PMMA plate. The thicknesses of the applied layers were determined using a wheel-shaped wet film thickness gauge immediately after the application, and UV transmission was measured using an SPF analyzer. The value of in vitro SPF was calculated from the UV absorbance and the thickness of the layer. For two out of the six samples, PMMA plate could not be available, as the samples were unable to wet the PMMA surface. Relatively small differences were observed between the in vitro SPF values when the super-hydrophilic and hydroxyalkyl cellulose-coated plates were used. Samples exhibiting higher in vivo SPF were also associated with higher in vitro SPF values, although a linear relationship was not observed. In contrast to the super-hydrophilic plate whose half-life of the super-hydrophilicity is only approximately five days, the hydrophilicity of the hydroxyalkyl cellulose-coated plate scarcely varied during six months of storage. Finally, a simplified evaluation method was also proposed. The validity of the method was verified through a ring test where three researchers employed this method in different laboratories at three independent organizations.