RESUMO
This study explores the impact of adding waste vehicular crumb rubber to the commercially available warm mix additives Sasobit® and Zycotherm® on modified asphalt binders' physical and rheological properties. Various concentrations of crumb rubber (0%, 10%, 15%, and 20%) were introduced to asphalt binder samples with 2% and 4% Sasobit and 1.5% and 3% Zycotherm. The investigation employed conventional tests (penetration and softening point) and advanced mechanical characterization tests, including Superpave rotational viscosity (RV), Dynamic Shear Rheometer (DSR), DSR multi-stress creep recovery (MSCR), DSR linear amplitude sweep (LAS), and Bending Beam Rheometer (BBR). Traditional tests measured the asphalt consistency, while workability was assessed through the RV test. The results showed that the Zycotherm binders experienced a more significant penetration reduction than the Sasobit binders. Additionally, an increased crumb rubber content consistently elevated the softening point and rotational viscosity, enhancing the complex shear modulus (G*) values. Rubberized binders exhibited an improved rutting performance and low-temperature PG grades. Increasing the crumb rubber content enhanced fatigue life, with Z1.5CR20 and S2CR20 demonstrating the longest fatigue lives among the Zycotherm and Sasobit binders, respectively. Overall, Z1.5CR20 is recommended for colder climates, while S2CR20 is suitable for hot-climate applications based on extensive analysis.
RESUMO
Major distresses such as rutting, fatigue, and thermal cracking are facing asphalt pavement structures due to continuous heavy traffic loading and climate change. The modification of asphalt binders (one of the main components of the asphalt paving mix) has the potential to mitigate distresses through using different additives. Polymer modified asphalt (PMA) binders showed a noticeable resistance to pavement distresses as reported in previous studies. The present study aims to evaluate the effect of polymer modification on the rheological properties of asphalt binders through laboratory tests. The polymers included styrene-butadiene-styrene (SBS) and epolene emulsifiable (EE2) types. The 60/70 binder was used as a control for comparison. The Mechanistic-Empirical Pavement Design Guide (MEPDG) was also utilized to simulate the effect of PMA binders on the rheological properties under different climatic conditions and structural capacities. Additionally, the MEPDG was further utilized to compare the effect of asphalt binders on rheological properties using four different binder input levels. Findings of the study showed that laboratory tests experienced varying outcomes regarding the most efficient asphalt binder by means of distresses resistance. However, the MEPDG evaluation showed that the overall ranking of asphalt binders positively impacting the rheological properties was as following: (1) 4.5% EE2 PMA, (2) 4% EE2 PMA, (3) 60/70 binder, (4) 5% SBS PMA, and (5) 4% SBS PMA binders. Furthermore, statistical analysis illustrated that the effect of using different binder input levels on the performance of pavement varied relatively to the evaluated distresses. The analysis showed that using different binder input levels would affect, to a certain extent, the asphalt binder influence on rheological properties only when evaluating rutting and fatigue distresses. Therefore, it is recommended that precise asphalt binder inputs, that is, shear complex modulus (G*) and phase angle (δ) are used when designing pavement structures in regions with hot and mild climate conditions.
