Epidemiology and incidence of oral squamous cell carcinoma in the Iraqi population over 5 years (2014-2018).

Background: Oral squamous cell carcinoma is one of the most common and life-threatening neoplasms worldwide, and is responsible for approximately 90% of all oral malignancies. Aim: This study was aimed at providing updated information on oral squamous cell carcinoma in all Iraqi governorates for the 5-year period from 2014 to 2018, including the annual incidence and demographic variables. Materials and Methods: The total number of oral squamous cell carcinoma cases in Iraq, along with associated demographic information (age, sex, and site), for the 5-year period from 2014 to 2018 was obtained. The statistical analysis consisted of descriptive analysis, including frequency, percentage, and mean ± standard deviation. A χ 2 test was performed to compare frequencies between male and female patients, among age groups, and among different OSCC sites. The χ 2 test was also used to assess the association of each OSCC site with age and sex. The significance threshold was set at p < 0.05, and the confidence interval was set at 95%. The incidence rate of oral squamous cell carcinoma for each year was calculated by dividing the number of OSCC cases per year by the population of Iraq, then multiplying the result by 100,000. Results: A total of 722 cases were recorded. Statistically, oral squamous cell carcinoma was found to be more prevalent in males and individuals over 40 years of age. The tongue was the most common site of occurrence. Lip squamous cell carcinoma cases were high in males. The incidence rate of oral squamous cell carcinoma was estimated to be 0.4 per 100,000 people. Conclusion: Males and older people are at relatively higher risk of developing oral cancer. The tongue is the most affected site, but any site in the oral cavity may be involved. Further exploration of the causes of oral malignancy in Iraq is necessary to improve prevention strategies.

Transmission of 940 nm diode laser to the radicular area during its application as root canal disinfectant.

To measure the transmitted laser power in the coronal, middle and apical root thirds during vertical and horizontal irradiation of laser. 14 mm length whole roots and longitudinal root sections were irradiated using a 940 nm diode laser with 0.5 W in continuous mode for 5 s. A power detector was placed in front of the root apex for the vertical transmitted power measurement and placed laterally to root surface for the horizontal transmission experiment. The transmitted power from the root apex vertically was 53% of the irradiated power, while for the horizontal transmission experiment for the coronal, middle and apical root thirds were 25.6%, 40.4% and 41.3%, respectively. Irradiation of root canals with 940 nm laser power can be transmitted during vertical irradiation in more than 50% of the samples, whereas less transmission happens with horizontal irradiation at apical and middle root third than coronal.

Combined effects of a topical fluoride treatment and 445 nm laser irradiation of enamel against a demineralization challenge: A light and electron microscopic ex vivo study.

This study investigated the caries-preventive effect of 445 nm laser radiation in combination with fluoride on the prevention of white spot lesions. Previously, several studies have indicated the ability of 488 nm argon ion laser irradiation to reduce early enamel demineralization. A diode laser (445 nm) could be an alternative technology for possible caries-preventive potential. Each sample of a group of seventeen caries-free bovine teeth was treated in four different ways on four different zones of the labial surface: control/no treatment (C), laser irradiation only (L) (0.3 W, 60 s and applied dose of 90 J/cm2), amine fluoride application only (10,000 ppm and pH 3.9) (F), and amine fluoride application followed by laser irradiation (FL). After treatment, the teeth were subjected to a demineralization solution (pH 4.3 for 48 h at 37 °C) to induce subsurface lesions. After sectioning, the teeth were examined by light microscopy. Three teeth were analyzed by scanning electron microscopy (SEM). The depths of the subsurface lesions in the C, L, F, and FL groups were 103.01 (± 13.04), 96.99 (± 14.51), 42.59 (± 17.13), and 24.35 (± 11.38) µm, respectively. The pairwise group comparison showed the following results: p < 0.001 for FL versus C, FL versus L, F versus C, and F versus L, p = 0.019 for FL versus F and p = 0.930 for L versus C. The SEM micrographs support the light-microscopic examination. The results of the current study have shown that using relatively low irradiation settings of 445 nm laser on fluoridated enamel may be effective for prevention of white spot lesions.

Laser-assisted prevention of enamel caries: a 10-year review of the literature.

Since the invention of lasers in dentistry, investigations in caries prevention by the use of laser radiation have been proposed. There are several mechanisms stated for this purpose such as photothermal and/or photochemical interaction processes with the enamel. Alone or in conjugation with topical fluoride application, this treatment modality may improve enamel acid resistance in high-caries-risk populations. Data collection was done by searching the keywords caries, prevention, and laser in PubMed, Embase, Web of Science, Cochrane Library, and Google Scholar. Lasing protocols of the collected literature and their effectiveness as well as examination methods used to verify treatment outcomes have been evaluated. One hundred eighteen publications were found for the last 10 years. The wavelengths investigated for caries prevention are mainly located in the near and the mid-infrared spectral range. In the evaluated period of time, investigations using CO2; Er:YAG; Er,Cr:YSGG; Er:YLF; fundamental, second, and third harmonic generations of Nd:YAG; diodes; and argon ion lasers were found in the databases. Accounting for 39% of the literature, CO2 laser was the most examined system for this purpose. Reviewing the literature in this narrative review showed that all laser systems presented a positive effect in varying degrees. Laser irradiation could be an alternative or synergistic to topical fluoridation for enamel caries prevention with longer lasting effect. Further research should be focused on selecting proper laser settings to avoid damage to enamel and developing effective evidence-based clinical protocols.

Artificial Caries Resistance in Enamel after Topical Fluoride Treatment and 445 nm Laser Irradiation.

OBJECTIVE: This in vitro study is aimed at investigating the caries preventive effectiveness of 445 nm diode laser in combination with topical fluoridation. MATERIALS AND METHODS: A total of 30 caries-free bovine teeth were used in this study. Eighteen teeth were covered with nail varnish except four windows on the labial surface. The windows were assigned to no treatment/control (C), laser (L) (0.3 W, 60 s, and 90 J/cm2), fluoride (F), and fluoride followed by laser (FL) treatment groups. Artificial caries lesions were created, and the teeth were sectioned and investigated under polarized light microscopy for quantitative measurement of the resulted lesion depth. Ten teeth were used for surface temperature measurement and two teeth for scanning electron microscopy (SEM). Extra twelve human molars were used for the intrapulpal temperature measurement. The absorbance of fluoride at 445 nm was measured. RESULTS: The means of lesion depth for the C, L, F, and FL groups were 123.48 (±21.93), 112.33 (±20.42), 99.58 (±30.68), and 89.03 (±30.38) µm, respectively. The pairwise differences of the L, F, and FL groups compared with the C group were significant (p < 0.05). The differences between groups were tested: FL versus L p=0.02, F versus L p=0.16, and FL versus F p=0.91, and the difference of the F versus FL was not significant (p=0.91). Temperature increment at the enamel surface and pulp roof were ∆T = 16.67 (±4.11) and 2.12 (±0.66)°C, respectively. The topical fluoride absorbance at 445 nm is five orders higher than that at 810 nm. SEM shows that after laser irradiation the enamel surface was intact and without thermal damage. CONCLUSIONS: The 445 nm laser irradiation may be useful for caries prevention, and its effectiveness is lower than those previously achieved using the argon ion laser.

Clinical Investigation of 940 nm Diode Laser Power Bleaching: An In Vivo Study.

Introduction: The increased demand by patient to whiten their teeth in short time had made in-office bleaching procedure the common one. The accompanying tooth sensitivity remains an important factor affecting patients physically and psychologically. The aim of this in vivo study was to observe the effectiveness of 940 nm diode laser in combination with bleaching gel by analyzing tooth sensitivity and colour change. Methods: Fourteen patients treated by laser-assisted bleaching using diode laser at 940 nm and bleaching gel containing 38% hydrogen peroxide. Tooth sensitivity recorded during and after treatment at 6 hours and 1 day using visual analogue scale (VAS). Tooth shade had recorded before and after bleaching using Vita classical brightness scale. Results: Patients whom did not experienced pain during and after the treatment were 78.60% and 92.90%, respectively. Tooth brightness change after treatment was statistically different (P = 0.001). Conclusion: Diode laser of 940 nm is an effective adjunctive tool for reducing tooth sensitivity originated from high concentration H2 O2 bleaching gel.

The Bactericidal Effect of 2780 and 940 nm Laser Irradiation on Enterococcus faecalis in Bovine Root Dentin Slices of Different Thicknesses.

OBJECTIVE: The aim of this in vitro study was to investigate the antibacterial effect of the dual wavelength (2780 nm Er,Cr:YSGG and 940 nm diode) laser in elimination of Enterococcus faecalis in comparison with a 2780 nm Er,Cr:YSGG laser alone. BACKGROUND DATA: Various laser wavelengths have been introduced as an adjunct in root canal treatment because of laser's bactericidal effect. MATERIALS AND METHODS: Seventy- five slices of dentin with thicknesses of 300, 500, and 1000 µm (n = 25 each) obtained from caries-free bovine teeth were inoculated with 1 µL of E. faecalis suspension [1.67 × 10(7) colony-forming units (CFU)] and divided randomly into three groups: (A) samples indirectly irradiated with power settings of 1.06 W, 50 Hz, and 50 µs for Er,Cr:YSGG laser; (B) samples indirectly irradiated with Er,Cr:YSGG laser with the same power settings as group A and simultaneously with a 940 nm diode laser of 0.51 W in pulsed mode; and five samples from each thickness that were chosen as an unirradiated control group (Co). After irradiation, the CFU of E. faecalis were counted and the bacterial reduction was analyzed using Kruskal-Wallis nonparametric and post-hoc Dunnett tests. RESULTS: There were statistical differences between groups A and B compared with the control group over all the three dentin slice thicknesses (p < 0.001). However, there was no statistical difference between groups A and B in killing of E. faecalis on 500 µm dentin slices. There were significantly more viable bacteria in group A than in group B in 300 and 1000 µm dentin slices (p < 0.01). CONCLUSIONS: The results of this in vitro study showed that the dual wavelength laser system obtained a significantly higher bactericidal effect on E. faecalis than Er,Cr:YSGG laser, reaching a depth of 1000 µm of dentin.

The effects of CO2 laser with or without nanohydroxyapatite paste in the occlusion of dentinal tubules.

The aim of this study was to evaluate a new treatment modality for the occlusion of dentinal tubules (DTs) via the combination of 10.6 µm carbon dioxide (CO2) laser and nanoparticle hydroxyapatite paste (n-HAp). Forty-six sound human molars were used in the current experiment. Ten of the molars were used to assess the temperature elevation during lasing. Thirty were evaluated for dentinal permeability test, subdivided into 3 groups: the control group (C), laser only (L-), and laser plus n-HAp (L+). Six samples, two per group, were used for surface and cross section morphology, evaluated through scanning electron microscope (SEM). The temperature measurement results showed that the maximum temperature increase was 3.2 °C. Morphologically groups (L-) and (L+) presented narrower DTs, and almost a complete occlusion of the dentinal tubules for group (L+) was found. The Kruskal-Wallis nonparametric test for permeability test data showed statistical differences between the groups (P < 0.05). For intergroup comparison all groups were statistically different from each other, with group (L+) showing significant less dye penetration than the control group. We concluded that CO2 laser in moderate power density combined with n-HAp seems to be a good treatment modality for reducing the permeability of dentin.