RESUMO
Lisinopril (LIS) is antihypertensive drug, classified as a class III drug with high water solubility and low permeability. To overcome the low permeability, 32 factorial designs aimed to formulate LIS as a sustained-release (LIS-SR) matrix pellet by extrusion/spheronization. Matrix pellets were composed of wet mass containing Avicel® and polymeric matrix polymers (sodium alginate (SA) and chitosan (CS)). Evaluation of the effect of two independent variables, matrix-forming units (SA and CS) on mean line torque, on pellet size, dissolution rate after 6 h, and mucoadhesion strength of the pellets were assessed using Statgraphics software. The tested formulations (F1-F9) showed that mean line torque ranged from 1.583 to 0.461 Nm, with LIS content in the LIS-SR pellets ranged from 87.9 to 103%, sizes varied from 1906 to 1404 µm and high percentages of drug released from pellets formulations (68.48 to 74.18 %), while the mean zeta potential value of mucoadhesive range from -17.5 to -22.9 mV. The selection of optimized formulation must have the following desirability: maximum peak torque, maximum pellets' particle size, and minimum % LIS release after 6hr. LIS optimized sustained release pellet formula composed of 2,159 % SA and 0.357 % CS was chosen as optimized formula. It's showed a 1.055 Nm mean line torque was responsible for the increased pellet size to 1830.8 µm with decreased release rate 56.2 % after 6 hr, and -20.33 mV average mucin zeta potential. Ex-vivo mucoadhesion studies revealed that that the optimize formulation, exhibited excellent mucoadhesive properties, after 1 h, about 73% of the pellets were still attached to the mucus membrane. Additionally, ex-vivo permeation determination of LIS from the optimized LIS-SR formulation was found to be significantly higher (1.7-folds) as compared to free LIS. In conclusion: LIS-SR matrix pellets, prepared with an extrusion/spheronization have desirable excellent characteristics in-vitro and ex-vivo sustained-release pellet formulation of LIS-SR was able to sustain the release of LIS for up to 8 h.
RESUMO
PURPOSE: Lidocaine (LID) is a local anesthetic that is administered either by injection and/or a topical/transdermal route. However, there is a current need to develop efficacious methods for the oral delivery of LID with optimized bioavailability. METHODS: We developed oral LID biodegradable microspheres that were loaded with alginate-chitosan with different mass ratios, and characterized these microspheres in vitro. We also developed, and utilized, a simple and sensitive HPLC-tandem mass spectrometry (LC-MS-MS) method for assaying LID microspheres. RESULTS: The mean particle size (MPS) of the LID microspheres ranged from 340.7 to 528.3 nm. As the concentration of alginate was reduced, there was a significant reduction in MPS. However, there was no significant change in drug entrapment efficiency (DEE), or drug yield, when the alginate concentration was either increased or decreased. DSC measurements demonstrated the successful loading of LID to the new formulations. After a slow initial release, less than 10% of the LID was released in vitro within 4 h at pH 1.2. In order to evaluate nephrotoxicity, we carried out MTT assays of LID in two types of cell line (LLC-PK1 and MDCK). LID significantly suppressed the cell toxicity of both cell lines at the concentrations tested (100, 200, and 400ng/µL). CONCLUSION: Experiments involving the oral delivery of LID formulations showed a significant reduction in particle size and an improvement in dissolution rate. The formulations of LID developed exhibit significantly less toxicity than LID alone.
