Relationship of contact angle of spray solution on leaf surfaces with weed control.

The weeds are important in agricultural and livestock areas because these plants can cause several damages, especially in the yield. The herbicide pulverization for weed control is the most used, but the efficiency of the control can be dependent the several factors, for example, the correct chose the herbicide and the mixture or not with adjuvant. This study aimed to evaluate the contact angle of herbicide solution droplets associated with adjuvant when deposited on the leaf surface of different weed species and their relationship with chemical control. For the contact angle experiment, the design was completely randomized, with four repetitions, while for the control experiment, a randomized block design was used, both experiments were arranged in a factorial (4 × 2 + 1) design. Factor A corresponded to four spray solutions containing the herbicide no addition of adjuvants and herbicide associated with adjuvants (vegetable oil, mineral oil, and lecithin), factor B to two herbicide dosages, and additional treatment corresponded to water. The contact angle was determined in six weed species: Crotalaria incana, Lantana camara, Ipomoea grandifolia, Asclepias curassavica, Sida obtusifolia, and Ricinus communis, on the adaxial and abaxial surface of each species, and an artificial surface. For the weed control experiment was used two weed species: C. incana and L. camara. The multivariate analysis allowed the understanding of the behavior of the contact angle of the different groups on the natural and artificial surfaces, due to the formation of factors. For all plants, except for the abaxial surface of I. grandifolia and the adaxial surface of A. curassavica, the association of herbicide and adjuvants reduced contact angle on the surfaces. The chemical control resulted in an indirect relation with contact angle, where smaller contact angles of the herbicide solution resulted in a higher percentage of plant intoxication. Therefore, for this situation, it is recommended to use the herbicide aminopyralid + fluroxypir associated with lecithin.

Does the sequence of addition of herbicide and adjuvants to the spray solution influence sicklepod control? / A sequência de adição de herbicida e adjuvantes à calda influencia no controle de fedegoso?

The use of adjuvants associated with herbicides aims at improving the performance of application and the consequent increase in the biological effect of the treatment. However, the sequence of product added to the sprayer tank can influence the phytosanitary spray solution. Thus, this study aimed to evaluate the control of Senna obtusifolia as a function of the sequence of addition of the herbicide aminopyralid + fluroxypyr and adjuvants in the preparation of spray solution. Two herbicide doses (1 and 2 L c.p. ha-1) associated with the adjuvants mineral oil (MO), silicone polyether copolymer (SIL), and a mixture of phosphatidylcholine and propionic acid (LEC), all in the proportion of 0.3% v v-1, with alternate addition to the spray solution to evaluate the effects of the preparation sequence. The spray solution volume considered was 150 L ha-1. Evaluations of spray solution stability were performed from the visual evaluation of homogeneity, electrical conductivity, and pH. The effect of treatment on S. obtusifolia control was measured using a scoring scale and dry matter. Correlation coefficients between the evaluations were also determined. No difference of the preparation sequence of spray solution was observed for stability, pH, and electrical conductivity, but an influence was observed on S. obtusifolia control, without changing dry matter accumulation. The treatment with the adjuvant LEC previously added to the herbicide provided a higher control rate at the highest dose, while the adjuvant SIL had the opposite effect.(AU)

O uso de adjuvantes associados a herbicidas visa melhorar o desempenho da aplicação e o consequente aumento do efeito biológico do tratamento. Porém, a ordem de adição dos produtos ao tanque do pulverizador pode trazer importantes influências à calda fitossanitária. Assim, o objetivo desta pesquisa foi avaliar o controle de Senna obtusifolia em função da sequência de adição do herbicida aminopiralide + fluroxipir e de adjuvantes no preparo das caldas. Foram utilizadas duas dosagens de herbicida (1 e 2 L p.c. ha-1), associadas aos adjuvantes óleo mineral (OM); copolímero de poliéter e silicone (SIL); mistura de fosfatidicolina e ácido propiônico (LEC), todos na proporção de 0,3% v v-1, com adição alternada à calda para avaliar os efeitos da sequência de preparo. O volume de calda considerado foi de 150 L ha-1. Foram realizadas avaliações da estabilidade da calda a partir da avaliação visual de homogeneidade, condutividade elétrica e pH. O efeito do tratamento no controle de S. obtusifolia foi mensurado por meio de uma escala de pontuação e pela massa seca. Também foram determinados os coeficientes de correlação entre as avaliações. Verificou-se que não houve diferença da sequência de preparo da calda para a estabilidade, o pH e a condutividade elétrica. Porém, a sequência de preparo influenciou o controle inicial de S. obtusifolia, sem efeito sobre a massa seca. O tratamento com o adjuvante LEC adicionado ao herbicida proporcionou maior taxa de controle na maior dosagem, enquanto o adjuvante de SIL teve o efeito oposto.(AU)