RESUMO
This paper presents a novel quad-element array with multiple inputs and multiple outputs (MIMO) designed for 5th generation sub-6 GHz applications. The MIMO system achieves a wide impedance bandwidth, high gain, and high isolation among its components, representing significant advancements in sub-6 GHz antenna applications. The single element, an elliptical resonator with a circular slot, is fed by a 50 Ω microstrip feedline, achieves a broad characteristic bandwidth from 3.7 to 5.7 GHz with a resonant frequency of 4.33 GHz and a gain of 1.81 dBi. Characteristic Mode Analysis (CMA) was employed to elucidate the evolution phases of this design. The quad-element MIMO antenna array maintains a compact size and broadband characteristics by arranging mirrored elements on the same ground plane. Implemented on a cost-effective FR-4 substrate measuring 44 × 44 × 1.6 mm3, the recommended MIMO antenna array, enhanced with a partial ground plane and due to the introduction of a vertical strip, a high isolation of - 38.53 dB is achieved between MIMO components along with a realized gain of 3.01 dBi and a radiation efficiency of 71% in the 5G sub-6 GHz band. Noteworthy properties include high isolation, diversity gain (DG), and envelope correlation coefficient (ECC), verifying the appropriateness of the suggested MIMO scheme for 5G transmission and reception in sub-6 GHz applications.
RESUMO
This study explores the viability of using the avoided mode crossing phenomenon in the microwave regime to design microwave differential sensors. While the design concept can be applied to any type of planar electrically small resonators, here, it is implemented on split-ring resonators (SRRs). We use two coupled synchronous SRRs loaded onto a two-port microstrip line system to demonstrate the avoided mode crossing by varying the distance between the split of the resonators to control the coupling strength. As the coupling becomes stronger, the split in the resonance frequencies of the system increases. Alternatively, by controlling the strength of the coupling by materials under test (MUTs), we utilize the system as a microwave differential sensor. First, the avoided mode crossing is theoretically investigated using the classical microwave coupled resonator techniques. Then, the system is designed and simulated using a 3D full-wave numerical simulation. To validate the concept, a two-port microstrip line, which is magnetically coupled to two synchronous SRRs, is utilized as a sensor, where the inter-resonator coupling is chosen to be electric coupling controlled by the dielectric constant of MUTs. For the experimental validation, the sensor was fabricated using printed circuit board technology. Two solid slabs with dielectric constants of 2.33 and 9.2 were employed to demonstrate the potential of the system as a novel differential microwave sensor.
RESUMO
Planar sub-wavelength resonators have been used for sensing applications, but different types of resonators have different advantages and disadvantages. The split ring resonator (SRR) has a smaller sensing region and is suitable for microfluidic applications, but the sensitivity can be limited. Meanwhile, the complementary electric-LC resonator (CELCR) has a larger sensing region and higher sensitivity, but the topology cannot be easily designed to reduce the sensing region. In this work, we propose a new design that combines the advantages of both SRR and CELCR by incorporating metallic bars in a trapezoid-shaped resonator (TSR). The trapezoid shape allows for the sensing region to be reduced, while the metallic bars enhance the electric field in the sensing region, resulting in higher sensitivity. Numerical simulations were used to design and evaluate the sensor. For validation, the sensor was fabricated using PCB technology with aluminum bars and tested on dielectric fluids. The results showed that the proposed sensor provides appreciably enhanced sensitivity in comparison to earlier sensors.
