RESUMO
This study aimed to evaluate the influence of denture cleansers on the color, stability, and surface roughness of three-dimensional (3D)-printed denture base resins modified with zirconium dioxide nanoparticles (nano-ZrO2). A total of 440 specimens were fabricated using one heat-polymerized resin, and two 3D-printed resins (NextDent and ASIGA). According to the nano-ZrO2 content, the specimens for each resin were divided into five groups (0%, 0.5%wt, 1%wt, 3%wt, and 5%wt). Each concentration was divided into four subgroups (n = 10) based on the immersion solution (distilled water, sodium hypochlorite, Corega, and Fittydent) and immersion duration (360 and 720 days). The color changes (∆E00) and surface roughness (Ra, µm) of each specimen were measured at different time intervals (base line, 360 days, 720 days) using a spectrophotometer and a non-contact profilometer, respectively. The results were statistically analyzed using ANOVA and a post hoc Tukey's test (α = 0.05). Sodium hypochlorite showed the highest significant color change of all the denture base resins (p < 0.001). The average value of ΔE00 for sodium hypochlorite was significantly higher than the values for the other solutions (Fittydent, Corega, and water) (p < 0.001). Color stability was significantly affected by immersion time for all types of solutions except Corega (p < 0.001). All of the tested immersion solutions (distilled water, sodium hypochlorite, Corega, and Fittydent) showed a significant increase in the surface roughness of all the denture base resins (p < 0.05). Surface roughness was substantially increased by immersion time for all types of solution except Fittydent (p < 0.001). Denture cleansers can result in substantial color change and affect the surface roughness of unmodified and nanoparticle-modified denture base resins. Therefore, the selection of denture cleanser and appropriate types of material is critical for denture longevity.
RESUMO
OBJECTIVE: Socket preservation techniques have been used to maintain the ridge dimension following tooth extraction. The materials used influence the quality and quantity of newly formed bone. Therefore, the aim of this article was to systematically review the literature reporting both histological and radiographic outcomes of socket preservation techniques after tooth extraction in human subjects. MATERIAL AND METHOD: A systematic electronic search was performed in the electronic databases. English language clinical studies that were published between 2017 and 2022 and included both histological and radiographic findings for the test and control groups. Our primary search produced 848 articles, and of these, 215 were duplicate studies. A total of 72 articles were then eligible for full-text reading. RESULTS: The review included eight studies that met its inclusion criteria. Three outcomes were compared in the included studies. The percentage of newly formed bone ranged from 21.34 ± 9.14% to more than 50% of new bone formation. The materials that showed more than 50% of newly formed bone formation were demineralized dentin graft, platelet-rich fibrin, freeze-dried bone allograft, corticocancellous porcine, and autogenous bone. Four Studies did not report the percentage of the residual graft materials, while those who reported showed a variable range of a minimum 1.5% to more than 25%. One study did not report the changes in horizontal width at the follow-up period, while other studies ranged from 0.6 mm to 10 mm. CONCLUSION: Socket preservation represents an efficient technique to preserve the ridge contour with satisfactory newly formed bone in the augmented site and maintaining the vertical and horizontal dimensions of the ridge.
